Search

Latent thermal energy storage (TES) devices could enable advances in many thermal management applications, including peak load shifting for reducing energy demand and cost of HVAC or providing supplemental heat rejection in transient thermal management systems. However, real-time feedback control of such devices is currently limited by the absence of suitable state of charge estimation techniques, given the nonlinearities associated with phase change dynamics. In this paper we design and experimentally validate a state-dependent Riccati equation (SDRE) filter for state of charge estimation in a phase change material (PCM)-based TES device integrated into a single-phase thermal-fluid loop. The advantage of the SDRE filter is that it does not require linearization of the nonlinear finite-volume model; instead, it uses a linear parameter-varying system model which can be quickly derived using graph-based methods. We leverage graph-based methods to prove that the system model is uniformly detectable, guaranteeing that the state estimates are bounded. Using measurements from five thermocouples embedded in the PCM of the TES and two thermocouples measuring the fluid temperature at the inlet and outlet of the device, the state estimator uses a reduced-order finite-volume model to determine the temperature distribution inside the PCM and in turn, the state of charge of the device. We demonstrate the state estimator in simulation and on experimental data collected from a thermal management system testbed to show that the state estimation error converges near zero and remains bounded., Comment: Manuscript submitted to the ASME Journal on Dynamic Systems, Measurement and Control (JDSMC)

Many dynamical systems, including thermal, fluid, and multi-agent systems, can be represented as weighted graphs. In this paper we consider whether the unstable states of such systems can be observed from limited discrete-time measurement, that is, whether the discrete formulation of system is detectable. We establish that if the associated graph is fully connected, then a linear time invariant system is detectable by measuring any state. Further, we show that a parameter-varying or time-varying system remains uniformly detectable for a reasonable approximation of its state transition matrix, if the underlying graph structure is maintained.

In this paper, we develop a predictive geometry control framework for jet-based additive manufacturing (AM) based on a physics-guided recurrent neural network (RNN) model. Because of its physically interpretable architecture, the model's parameters are obtained by training the network through back propagation using input-output data from a small number of layers. Moreover, we demonstrate that the model can be dually expressed such that the layer droplet input pattern for (each layer of) the part to be fabricated now becomes the network parameter to be learned by back-propagation. This approach is applied for feedforward predictive control in which the network parameters are learned offline from previous data and the control input pattern for all layers to be printed is synthesized. Sufficient conditions for the predictive controller's stability are then shown. Furthermore, we design an algorithm for efficiently implementing feedback predictive control in which the network parameters and input patterns (for the receding horizon) are learned online with no added lead time for computation. The feedforward control scheme is shown experimentally to improve the RMS reference tracking error by more than 30% over the state of the art. We also experimentally demonstrate that process uncertainties are compensated by the online learning and feedback control.