Search

The study establishes an adequate monomer combination for achieving the best balance of properties required in obtaining polyimide alignment layers for display devices. The molecular design of some aliphatic/aromatic polyimides was performed by using dianhydride monomers with distinct configurations in terms of rigidity, size, and symmetry. The polyimides based on semi-flexible and nonsymmetric dianhydride moieties present lower refractive index and dielectric constant (<3) than those obtained from symmetric and rigid dianhydride units. This determines faster traveling of visible and microwave radiations as required for liquid crystal alignment purposes. The interactions of samples with the N-(4-Methoxybenzylidene)-4-butylaniline, cyanobiphenyl, and 4-pentyl-4-cyanobiphenyl nematics were assessed. The analyzed polyimides have higher surface tensions than the ones of the liquid crystals, determining a parallel arrangement of the nematic molecules. As the dispersive interactions at the polymer surface are lower, the work of spreading is higher as a result of improved adhesion of liquid crystal with the polyimide alignment layer. The sample containing rigid, symmetric, noncoplanar dianhydride units (PI.4) and the one based on semi-flexible, nonsymmetric dianhydride moieties are the most transparent for visible and microwave radiations, allowing low cohesion interaction at interface with nematics. These aspects recommend the two studied polyimides as candidates for alignment layers. [ABSTRACT FROM AUTHOR]

Atomic force microscopy (AFM) was used to analyze rectangular 3‐dimensional patterned microstructures with different functionalities induced on copolyimide containing alicyclic sequences film surfaces by means of oxygen plasma treatment. The plasma power was ranged to be big enough to accelerate the plasma species towards the copolyimide surface, and the exposure time was not very small to generate a roughness that still can be monitored by AFM. To create the rectangular pattern, transmission electron microscopy grid masks were placed on the samples before treatment. Plasma‐induced micropatterning with alternating hydrophilic and hydrophobic surface chemistries was evaluated by measuring the adhesion forces between the gold‐covered AFM tip and the copolyimide surfaces. To fabricate 3‐dimensional metallic microstructures arranged in well‐defined areas, thin metal layers were sputtered on these pretreated copolyimide films. The AFM morphological aspects of the obtained metallic structures were correlated with the surface modifications induced by plasma treatment conditions. Functional indexes and functional volume parameters were also calculate to characterize the functional behavior of the surface, such as wear, lubrication, and contact. The AFM data were compared with those obtained using the small‐angle X‐ray scattering measurements. [ABSTRACT FROM AUTHOR]