Search

Coupling the photo-oxidation of biomass derived substrates with water splitting in a photoelectrochemical (PEC) cell is a broadly discussed approach intended to enhance efficiency of hydrogen generation at the cathode. Here, we report a PEC device employing a nanostructured semitransparent WO 3 photoanode that, irradiated with simulated solar light achieves large photocurrents of 6.5 mA cm -2 through oxidation of glucose, a common carbohydrate available in nature that can be obtained by processing waste biomass. The attained photocurrents are in a large part due to the occurrence of the photocurrent doubling, where oxidation of glucose by the photogenerated positive hole is followed by injection by the formed intermediate of an electron into the conduction band of WO 3. Selection of an appropriate supporting electrolyte enabled effective reforming of glucose into valuable products: gluconic and glucaric acids, erythrose and arabinose with up to 64% total Faradaic yield attained at ca 15% glucose conversion., (© 2022. The Author(s).)

N-type semiconducting WO 3 is widely investigated as a photoanode operating in water and seawater splitting devices. Because of the propensity of WO 3 to favor photo-oxidation of acidic electrolyte anions and, in parallel, the formation on the electrode surface of the peroxo species, the choice of the appropriate electrolyte to allow stable operation of the photoanode is of critical importance. Our results from structural and photoelectrochemical tests performed using mesoporous WO 3 photoanodes exposed to 80 h long photoelectrolysis in a 1 M aq. methanesulfonic acid supporting electrolyte demonstrate the photostability of both the WO 3 photomaterial and the CH 3 SO 3 H electrolyte. The reasons for the stability of aqueous solutions of CH 3 SO 3 H are discussed on the basis of earlier literature reports., Competing Interests: The authors declare no competing financial interest., (© 2022 The Authors. Published by American Chemical Society.)

Solar-to-hydrogen photoelectrochemical cells (PECs) have been proposed as a means of converting sunlight into H2 fuel. However, in traditional PECs, the oxygen evolution reaction and the hydrogen evolution reaction are coupled, and so the rate of both of these is limited by the photocurrents that can be generated from the solar flux. This in turn leads to slow rates of gas evolution that favor crossover of H2 into the O2 stream and vice versa, even through ostensibly impermeable membranes such as Nafion. Herein, we show that the use of the electron-coupled-proton buffer (ECPB) H3PMo12O40 allows solar-driven O2 evolution from water to proceed at rates of over 1 mA cm(-2) on WO3 photoanodes without the need for any additional electrochemical bias. No H2 is produced in the PEC, and instead H3PMo12O40 is reduced to H5PMo12O40. If the reduced ECPB is subjected to a separate electrochemical reoxidation, then H2 is produced with full overall Faradaic efficiency.

Tungsten trioxide (WO3) is one of a few stable semiconductor materials liable to produce solar fuel by photoelectrochemical water splitting. To enhance its visible light conversion efficiency, we incorporated plasmonic gold nanoparticles (Au NPs) derivatized with polyoxometalate (H3PMo12O40) species into WO3. The combined plasmonic and catalytic effect of Au NPs anchored to the WO3 surface resulted in a large increase of water photooxidation currents. Shielding the Au NPs with polyoxometalates appears to be an effective means to avoid formation of recombination centers at the photoanode surface., (© 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.)

Nanostructuring of semiconductor films offers the potential means for producing photoelectrodes with improved minority charge carrier collection. Crucial to the effective operation of the photoelectrode is also the choice of a suitable electrolyte. The behaviour of the nanostructured WO(3) photoanodes in methane sulfonic acid solutions, which allow one to obtain large, perfectly stable visible-light driven water splitting photocurrents, is discussed. The important effect of the electrolyte concentration upon the current distribution and the related photocurrent losses within the nanoporous photoelectrodes is pointed out.

The fabrication of thin-film Fe(2)O(3) photoanodes from the spray pyrolysis of Fe(III)-containing solutions is reported along with their structural characterization and application to the photoelectrolysis of water. These films combine good performance, measured in terms of photocurrent density, with excellent mechanical stability. A full investigation into the effects that modifications of the spray-pyrolysis method, such as the addition of dopants or structure-directing agents and changes in precursor species or carrier solvent, have on the performance of the photoanodes has been realized. The largest photocurrents were obtained from photoanodes prepared from ferric chloride precursor solutions, simultaneously doped with Ti(4+) (5%) and Al(3+) (1%). Doping with Zn(2+) also shows promise, cathodically shifting the onset potential by approximately 0.22 V.

The present investigation reports the first experimental measurements of the reorganization energy of unfolded metalloprotein in urea solution. Horse heart cytochrome c (cyt c) has been found to undergo reversible one-electron transfer reactions at pH 2 in the presence of 9 M urea. In contrast, the protein is electrochemically inactive at pH 2 under low-ionic strength conditions in the absence of urea. Urea is shown to induce ligation changes at the heme iron and lead to practically complete loss of the alpha-helical content of the protein. Despite being unfolded, the electron-transfer (ET) kinetics of cyt c on a 2-mercaptoethanol-modified Ag(111) electrode remain unusually fast and diffusion controlled. Acid titration of ferric cyt c in 9 M urea down to pH 2 is accompanied by protonation of one of the axial ligands, water binding to the heme iron (pK(a) = 5.2), and a sudden protein collapse (pH < 4). The formal redox potential of the urea-unfolded six-coordinate His18-Fe(III)-H(2)O/five-coordinate His18-Fe(II) couple at pH 2 is estimated to be -0.083 V vs NHE, about 130 mV more positive than seen for bis-His-ligated urea-denatured cyt c at pH 7. The unusually fast ET kinetics are assigned to low reorganization energy of acid/urea-unfolded cyt c at pH 2 (0.41 +/- 0.01 eV), which is actually lower than that of the native cyt c at pH 7 (0.6 +/- 0.02 eV), but closer to that of native bis-His-ligated cyt b(5) (0.44 +/- 0.02 eV). The roles of electronic coupling and heme-flattening on the rate of heterogeneous ET reactions are discussed.

The heme iron coordination of unfolded ferric and ferrous cytochrome c in the presence of 7-9 M urea at different pH values has been probed by several spectroscopic techniques including magnetic and natural circular dichroism (CD), electrochemistry, UV-visible (UV-vis) absorption and resonance Raman (RR). In 7-9 M urea at neutral pH, ferric cytochrome c is found to be predominantly a low spin bis-His-ligated heme center. In acidic 9 M urea solutions the UV-vis and near-infrared (NIR) magnetic circular dichroism (MCD) measurements have for the first time revealed the formation of a high spin His/H(2)O complex. The pK(a) for the neutral to acidic conversion is 5.2. In 9 M urea, ferrous cytochrome c is shown to retain its native ligation structure at pH 7. Formation of a five-coordinate high spin complex in equilibrium with the native form of ferrous cytochrome c takes place below the pK(a) 4.8. The formal redox potential of the His/H(2)O complex of cytochrome c in 9 M urea at pH 3 was estimated to be -0.13 V, ca. 100 mV more positive than E degrees ' estimated for the bis-His complex of cytochrome c in urea solution at pH 7.

Mesoporous semiconducting films consisting of preferentially orientated monoclinic-phase nanocrystals of tungsten trioxide have been prepared using a novel version of the sol-gel method. Transformations undergone by a colloidal solution of tungstic acid, stabilized by an organic additive such as poly(ethylene glycol) (PEG) 300, as a function of the annealing temperature have been followed by means of a confocal Raman microscope. The shape and size of WO3 nanoparticles, the porosity, and the properties of the films depend critically on preparation parameters, such as the tungstic acid/PEG ratio, the PEG chain length, and the annealing conditions. Well-crystallized WO3 films combine excellent photoresponse to the blue region of the solar spectrum, up to 500 nm, with good transparency at wavelengths larger than 550 nm. Particular applications of these nanocrystalline WO3 films include photoelectrochemical and electrochromic devices.

The present review describes work done over the past twenty years on the controlled release of drugs using iontophoresis or electrophoresis techniques. Following a description of therapeutic applications, in vivo and in vitro studies have been discussed with emphasis on the potentials of such techniques to control drug release. Different mathematical models have been reviewed and an attempt has been made to combine them to explain the various configurations of systems currently used.