Search

In this study, we propose a framework for chirp-based communications by exploiting discrete Fourier transform-spread orthogonal frequency division multiplexing (DFT-s-OFDM). We show that a well-designed frequency-domain spectral shaping (FDSS) filter for DFT-s-OFDM can convert its single-carrier nature to a linear combination of chirps circularly translated in the time domain. Also, by exploiting the properties of the Fourier series and Bessel function of the first kind, we analytically obtain the FDSS filter for an arbitrary chirp. We theoretically show that the chirps with low ripples in the frequency domain result in a lower bit-error ratio (BER) via less noise enhancement. We also address the noise enhancement by exploiting the repetitions in the frequency. The proposed framework offers a new way to efficiently synthesize chirps that can be used in Internet-of-Things (IoT), dual-function radar and communication (DFRC) or wireless sensing applications with existing DFT-s-OFDM transceivers., Comment: 5 pages, 5 figures, pre-print, accepted for publication in IEEE Communications Letters

Due to the rapidly increasing number of flights and high usage of VHF channels, the VHF spectrum is becoming much more crowded, and use of analog waveforms will likely not maintain the required performance. Therefore, digital communications have been considered due to larger spectral efficiency. Notably, VHF data link modes 2 and 3 (VDL2 and 3) using D8PSK modulation has been proposed. VDL2 and 3 received attention due to its simplicity and more constant amplitude waveform, yielding lower PAPR. Recently, advanced VHF digital link (A-VDL) was proposed for VHF. This scheme enables use of essentially the same platform as VDL except for the physical layer processing, including modulation. The proposed A-VDL, following DVB-S2 standard, uses APSK modulation with higher modulation order than VDL, hence providing higher spectral efficiency than VDL. Compared to the widely used QAM, APSK is more resistant to amplifier amplitude and phase distortions. Thus, APSK has become of interest for satellite communications, as well as VHF communications in A-VDL. In this paper, we investigate other advanced technologies such as channel encoding technique low-density parity-check (LDPC), more efficient standardized voice encoders, as well as better pulse shaping filters than the classical square-root raised-cosine filter used in VDL and A-VDL. Via simulations and analysis, we compare the proposed scheme's link margin, PAPR, and spectral efficiency compared to VDL and A-VDL, which both use Reed Solomon (RS) encoding. In addition, as another way of generating the same VDL waveforms (or possibly other single-carrier aeronautical band waveforms), we investigate the single-carrier type waveform used in cellular LTE and 5G uplink communication links, the discrete Fourier transform-spread OFDM (DFT-s-OFDM), and discuss how we can take advantage of using the same LTE and 5G hardware resources., Comment: This article has been accepted for publication in IEEE DASC Conference 2020

In this paper, we investigate an algorithm to attain additive white Gaussian noise (AWGN) performance in spectrally non-white channels, using multicarrier communications, i.e., orthogonal frequency division multiplexing (OFDM) and filterbank multicarrier (FBMC). The non-white channel can be from non-white noise, or more commonly, interference. Our algorithm uses a simple optimization method to find usable subcarriers and assigns different power levels to the subcarriers to attain the equivalent AWGN channel bit error ratio (BER). Subcarriers that experience very high interference are assigned as null subcarriers. After describing our analysis, we show results for two non-white interference signal examples: the Gaussian pulse shaped distance measuring equipment (DME) pulses, and a classical rectangular-pulse interference signal. The DME example is pertinent for currently proposed aviation communication systems, where new multicarrier techniques, e.g., the L-band digital aviation communication systems (LDACS) have been designed as an inlay approach between the high-power DME channels in the L-band. Our results show how using this adaptive technique can improve performance and spectral efficiency, whereas fixed bandwidth schemes such as LDACS could suffer significant performance degradation. These results show the utility of this idea for future adaptive and cognitive radio applications for aviation or other non-white channels., Comment: This paper has been submitted to IEEE Transactions on Wireless Communications (TWC), and currently under review

Urban air mobility (UAM) is a concept for creating an airborne transportation system that operates in urban settings with an on-board pilot and/or remote pilot in command (RPIC), or with a fully autonomous architecture. Although the passenger traffic will be mostly in and near urban environments, UAM is also being considered for air cargo, perhaps between cities. Such capability is pushing the current communication, navigation and surveillance (CNS) / air traffic management (ATM) systems that were not designed to support these types of aviation scenarios. The UAM aircraft will be operating in a congested environment, where CNS and ATM systems need to provide integrity, robustness, security, and very high availability for safety of UAM operations while evolving. As UAM is under research by academia and government agencies, the industry is driving technology towards aircraft prototypes. Critical UAM requirements are derived from command and control (C2) (particularly for RPIC scenario), data connectivity for passengers and flight systems, unmanned aircraft systems (UAS) to UAS communication to avoid collision, and data exchange for positioning and surveillance. In this paper, we study connectivity challenges and present requirements towards a robust UAM architecture through its concept of operations. In addition, we review the existing/potential CNS technologies towards UAM, i.e., 3rd generation partnership project (3GPP) fifth generation (5G) new radio (NR), navigation detect & avoid (DAA), and satellite systems and present conclusions on a future road-map for UAM CNS architecture., Comment: Keywords: 5G, CNS, DAA, NASA, requirement analysis, radio technical commission for aeronautics (RTCA), satellite systems, UAM. Citation: M. C. Erturk, N. Hosseini, H. Jamal, A. Sahin, D. Matolak and J. Haque, "Requirements and Technologies Towards UAM: Communication, Navigation, andSurveillance," 2020 Integrated Communications, Navigation, Surveillance Conference (ICNS), Herndon, VA, 2020

Drones, unmanned aerial vehicles (UAVs), or unmanned aerial systems (UAS) are expected to be an important component of 5G/beyond 5G (B5G) communications. This includes their use within cellular architectures (5G UAVs), in which they can facilitate both wireless broadcast and point-to-point transmissions, usually using small UAS (sUAS). Allowing UAS to operate within airspace along with commercial, cargo, and other piloted aircraft will likely require dedicated and protected aviation spectrum at least in the near term, while regulatory authorities adapt to their use. The command and control (C2), or control and non-payload communications (CNPC) link provides safety critical information for the control of the UAV both in terrestrial-based line of sight (LOS) conditions and in satellite communication links for so-called beyond LOS (BLOS) conditions. In this paper, we provide an overview of these CNPC links as they may be used in 5G and satellite systems by describing basic concepts and challenges. We review new entrant technologies that might be used for UAV C2 as well as for payload communication, such as millimeter wave (mmWave) systems, and also review navigation and surveillance challenges. A brief discussion of UAV-to-UAV communication and hardware issues are also provided., Comment: 10 pages, 5 figures, IEEE aerospace conference

In this paper we describe the overall idea and results of a recently proposed radio access technique based on filter bank multicarrier (FBMC) communication system using two orthogonal polarizations: dual-polarization FBMC (DP-FBMC). Using this system we can alleviate the intrinsic interference problem in FBMC systems. This enables use of all the multicarrier techniques used in cyclic-prefix orthogonal frequency-division multiplexing (CP-OFDM) systems for channel equalization, multiple-input/multiple-output (MIMO) processing, etc., without using the extra processing required for conventional FBMC. DP-FBMC also provides other interesting advantages over CP-OFDM and FBMC such as more robustness in multipath fading channels, and more robustness to receiver carrier frequency offset (CFO) and timing offset (TO). For DP-FBMC we propose three different structures based on different multiplexing techniques in time, frequency, and polarization. We will show that one of these structures has exactly the same system complexity and equipment as conventional FBMC. In our simulation results DP-FBMC has better bit error ratio (BER) performance in dispersive channels. Based on these results, DP-FBMC has potential as a promising candidate for future wireless communication systems., Comment: 1.This paper is accepted to be published in IEEE Vehicular Technology Conference (VTC) FALL 2018. 2.In this new submitted version authors have revised the paper based on the VTC FALL reviewers comments. Therefore some typos have fixed and some results have changed

In a recent work we proposed a new radio access technique based on filter bank multi-carrier (FBMC) modulation using two orthogonal polarizations: dual-polarization FBMC (DP-FBMC). We showed that with good cross-polarization discrimination (XPD), DP-FBMC solves the intrinsic imaginary interference shortcoming of FBMC without extra processing. DP-FBMC also has other interesting advantages over cyclic prefix orthogonal frequency-division multiplexing (CP-OFDM) and FBMC such as more robustness in dispersive channels, and it is also more robust to receiver carrier frequency offset (CFO) and timing offset (TO). In this paper we analyze the peak to average power ratio (PAPR) of DP-FBMC and compare PAPR simulation results with that of conventional FBMC, for different prototype filters and overlapping factors. According to the analysis and results, with a proper choice of prototype filter, DP-FBMC has comparable PAPR to FBMC., Comment: This paper has been published in IEEE MILCOM Conference 2018. Some results has been changed from first version

Filter bank multi-carrier (FBMC) offers superior spectral properties compared to cyclic-prefix orthogonal frequency-division multiplexing (CP-OFDM), at the cost of an inherent shortcoming in dispersive channels called intrinsic imaginary interference. In this paper we propose a new FBMC based communication system using two orthogonal polarizations for wireless communication systems: dual-polarization FBMC (DP-FBMC). Using this system we can significantly suppress the FBMC intrinsic interference. Therefore in DP-FBMC all the multicarrier techniques used in CP-OFDM systems such as channel equalization, etc., should be applicable without using the complex processing methods required for conventional FBMC. DP-FBMC also has other interesting advantages over CP-OFDM and FBMC: it is more robust in highly dispersive channels, and also to receiver carrier frequency offset (CFO) and timing offset (TO). In our DP-FBMC system we propose three different structures based on different multiplexing techniques. We show that compared to conventional FBMC, one of these DP-FBMC structures has equivalent complexity and equipment requirements. We compare DP-FBMC with other systems through simulations. According to our results DP-FBMC has potential as a promising candidate for future wireless communication networks., Comment: This paper has been submitted to the IEEE Transactions on Vehicular Technology (TVT) for possible publication, as well as a U.S. patent application. Right now this paper is under revision, and this new submitted version is the revised paper addressing all the reviewers' comments