Search

This study explores the intersection of waste management and sustainable fuel production, focusing on the pyrolysis of plastic waste, specifically polystyrene. We examine the physicochemical parameters of the resulting waste plastic pyrolytic oils (WPPOs), blended with kerosene to form a potential alternative fuel for gas turbines. Our findings reveal that all WPPO blends lead to increased emissions, with NOX rising by an average of 61% and CO by 25%. Increasing the proportion of WPPO also resulted in a higher exhaust gas temperature, with an average rise of 12.2%. However, the thrust-specific fuel consumption (TSFC) decreased by an average of 13.8%, impacting the overall efficiency of waste-derived fuels. This study underscores the need for integrated waste-to-energy systems, bridging the gap between waste management and resource utilization. [ABSTRACT FROM AUTHOR]

Addressing the burgeoning issue of polymer waste management and disposal, chemical recycling, specifically the production of highquality oil, presents an enticing solution. This research paper delves into the process of plastic waste pyrolysis, focusing on polypropylene, and thoroughly examines the physico-chemical properties of the resulting pyrolytic oil. The oils, obtained from waste plastic pyrolysis (referred to as WPPO), are then blended with kerosene and utilized as fuel for a gas turbine engine. The primary objective of this investigation is to ascertain how the blend composition influences the performance and emission parameters of the micro gas turbine. In our findings, it was observed that all tested waste plastic pyrolysis blends displayed a trend towards escalating regulated emissions such as nitrogen oxides (NOx) with an average increase of 26% for polypropylene pyrolysis oil (PPO). The emission index (EI) for carbon monoxide (CO) was found to be relatively consistent across all fuel blends tested in this study. Interestingly, when considering the thrust specific fuel consumption (TSFC) within the EI calculation, blends of aviation kerosene and plastic oil showed lower values in comparison to the pure Jet A-1 fuel. Furthermore, an augmentation in the proportion of WPPO in the blends consequently led to an elevation in the exhaust gas temperature (an average increase of 8.7% for PPO). Interestingly, the fuel efficiency of the Jet engine, expressed as TSFC, demonstrated a decrease, with an average reduction of 13.8% observed for PPO. [ABSTRACT FROM AUTHOR]

The process of pyrolysis is investigated in this paper. The pyrolysis results of two samples: waste tyres and rubber at different heating rates (10, 20, 50 K/min), were compared. In other experiments the degradation of two pyrolysis products, char and oil was examined. The kinetic study using the thermogravimetry equipment (TG) was done, which allowed determination of the kinetic mechanism of the process. The elemental analysis of the samples was performed. [ABSTRACT FROM AUTHOR]