Search

The failure mechanism of torsional concrete beams with fiber-reinforced polymer (FRP) bars is essential for developing the design method. However, limited experimental research has been conducted on the torsion behavior of concrete beams with FRP bars. Therefore, the pure torsion test of four large-scale FRP-RC beams (2800 mm × 400 mm × 200 mm) was conducted to investigate the influence of the stirrup ratio (0, 0.49%, and 0.98%) and longitudinal reinforcement ratio (3.01%, 4.25%) on torsion behavior. The test results indicated that three typical failure patterns, including concrete cracking failure, stirrup rupturing failure, and concrete crushing failure, were observed in specimens without stirrups (stirrup ratio 0), partially over-reinforced specimens (stirrup ratio 0.49%), and over-reinforced specimens (stirrup ratio 0.98%), respectively. The tangent angle of spiral cracks at the midpoint of the long side of the cross-section was approximately 45° initially for all specimens. The torque–twist angle curves exhibited a linear and bilinear behavior for specimens without stirrups and specimens with stirrups, respectively. As the stirrup ratio increased from 0 to 0.98%, torsion capacity increased from 24.9 kN∙m to 27.8 kN∙m, increased by 12%, ultimate twist angle increased from 0.0018 rad/m to 0.0403 rad/m. As the longitudinal reinforcement ratio increased from 3.01% to 4.25%, the torsion capacity increased from 27.8 kN∙m to 28.3 kN∙m, and the ultimate twist angle decreased from 0.0403 rad/m to 0.0244 rad/m. Based on test results, the stirrup strain limit of 5200 με and spiral crack angle of 45° was suggested for torsion capacity calculation. In addition, based on the database of torsion tests, the performance of torsion capacity provisions was assessed. [ABSTRACT FROM AUTHOR]

Perforated GFRP rib (PFR) connectors have been used in FRP-concrete hybrid beams due to durability and ease of construction. PFR connectors are parallel FRP plates with predrilled holes positioned in the flange of FRP beams. The optimal plate spacing needs to be determined because it affects the shear performance of PFR connectors. 18 push-out tests were conducted to investigate the effect of plate spacing (Sl), penetrating GFRP bar diameter (d), and concrete strength (fc) on the failure mode, capacity, and shear load-slip (P-S) curves of double-row PFR connectors. Results showed that PFR connectors suffered plate shear failure with the concrete dowel undamaged. Typical P-S curves consisted of micro-slipping and significant-slipping phases. The shear capacity and stiffness of PFR connectors were improved by 33.3% and 45.1%, respectively, by increasing the plate spacing from 1.2 h (where h denotes the plate height) to 3.2 h. The effect of plate spacing on shear capacity and stiffness could be neglected if the ratio (Sl/h) was more than 3.2. Specimens with a larger diameter of penetrating bar and higher concrete strength demonstrated higher capacity and stiffness. An empirical equation based on the maximum stress failure criterion was proposed to estimate the capacity of PFR connectors, considering the plate spacing effect, and verified by available data. Additionally, a description of the P-S curve was developed and calibrated by the experimental results. [ABSTRACT FROM AUTHOR]