Search

Uniform air distribution is the basic condition for the stable operation of circulating fluidized beds and closely related to the hole layout of nozzles and the air outlet conditions. In this paper, CAD modeling software is used to establish different opening types for nozzles and the corresponding gasifier models, and Fluent simulation software for numerical simulations (k-ε model) is introduced to the hydrodynamic behavior of the upper opening, the side opening and the combined opening types of nozzles, as well as the corresponding single-nozzle fluidized bed gasifiers. The flow field distribution under the above opening modes is obtained, including the velocity distribution, static pressure distribution, and total pressure distribution, and the influence of the boundary conditions, including the inlet gas velocity and outlet pressure, on the flow field distribution inside the nozzle and in the single-nozzle fluidized bed gasifier is also investigated. The simulation results show that the suitable optimal operating conditions for the coal gasifier can be achieved with an inlet velocity of 30 m/s and an outlet pressure of 25 kPaG. Under the above conditions, the local fluidization dead zone at the elbow and top of the nozzle is narrower, the uniformity of the wind velocity can be improved, the pressure drop of the inner core tube of the nozzle is gentle, and the pressure distribution tends to be stable. Theoretically, the anti-slag performance of the nozzle is improved, which will enhance the stability and reliability of the operation of the gasification unit. [ABSTRACT FROM AUTHOR]

Background: Advances in regeneration methods have brought us improved vascular scaffolds with small diameters (φ < 6 mm) for enhancing biological suitability that solve their propensity for causing intimal hyperplasia post‐transplantation. Methods: The correlation between the rehydration ratio of the hydrogel and its material concentration is obtained by adjusting the material ratio of the hydrogel solution. The vascular model with helical structure has been established and analyzed to verify the effect of helical microvascular structure on thrombosis formation by the fluid simulation methods. Then, the helical structure vascular has been fabricated by self‐developed 3D bioprinter, the vascular scaffolds are freeze‐dried and rehydrated in polyethylene glycol (PEG) solution. Results: The experimental results showed that the hybrid hydrogel had a qualified rehydration ratio when the content of gelatin, sodium alginate, and glycerol was 5, 6, and 3 wt%. The established flow channel model can effectively reduce thrombus deposition and improve long‐term patency ratio. After PEG solution modification, the contact angle of the inner wall of the vascular scaffold was less than 30°, showing better hydrophilic characteristics. Conclusion: In study, a small‐diameter inner wall vascular scaffold with better long‐term patency was successfully designed and prepared by wrinkling and PEG modification of the inner wall of the vascular scaffold. This study not only creates small‐diameter vascular scaffolds with helical structure that improves the surface hydrophilicity to reduce the risk of thrombosis but also rekindles confidence in the regeneration of small caliber vascular structures. [ABSTRACT FROM AUTHOR]