Search

In southeast New Hampshire, where reformulated gasoline was used from the 1990s to 2007, methyl tert-butyl ether (MtBE) concentrations ≥0.2 μg/L were found in water from 26.7% of 195 domestic wells sampled in 2005. Ten years later in 2015, and eight years after MtBE was banned, 10.3% continue to have MtBE. Most wells (140 of 195) had no MtBE detections (concentrations0.2 μg/L) in 2005 and 2015. Of the remaining wells, MtBE concentrations increased in 4 wells, decreased in 47 wells, and did not change in 4 wells. On average, MtBE concentrations decreased 65% among 47 wells whereas MtBE concentrations increased 17% among 4 wells between 2005 and 2015. The percent change in detection frequency from 2005 to 2015 (the decontamination rate) was lowest (45.5%) in high-population-density areas and in wells completed in the Berwick Formation geologic units. The decontamination rate was the highest (78.6%) where population densities were low and wells were completed in bedrock composed of granite, metamorphic, and mafic rocks. Wells in the Berwick Formation are characteristically deeper and have lower yields than wells in other rock types and have shallower overburden cover, which may allow for more rapid transport of MtBE from land-surface releases. Low-yielding, deep bedrock wells may require large contributing areas to achieve adequate well yield, and thus have a greater chance of intercepting MtBE, in addition to diluting contaminants at a slower rate and thus requiring more time to decontaminate.

This report presents public water-supply data and geohydrologic data along a 50-mile segment of the Connecticut River valley from Windsor to Vernon, Vermont. An inventory of wells indicates that domestic ground-water supplies come primarily from bedrock, whereas public water supplies are derived from discontinuous, glacial sand and gravel deposits. Self-supplied industries generally use surface-water supplies. Data from eight seismic-refraction surveys, and from a seismic-reflection survey along this 50-mile reach of the Connecticut River, were compared with stratigraphic information from 217 drillers' logs. These data indicate that stratified-drift deposits range from 0 to 270 feet and average about 65 feet. Stratigraphic information from drillers' logs and seismic-reflection records show that predominantly fine-grained stratified drift fills the valley and that coarser sand and gravel deposits exist discontinuously within this area.