Search

This paper proposes an energy management framework for cellular heterogeneous networks (HetNets) supported by dynamic solar powered drones. A HetNet composed of a macrocell base station (BS), micro cell BSs, and drone small cell BSs are deployed to serve the networks' subscribers. The drones can land at pre-planned locations defined by the mobile operator and at the macrocell BS site where they can charge their batteries. The objective of the framework is to jointly determine the optimal trips of the drones and the MBSs that can be safely turned off in order to minimize the total energy consumption of the network. This is done while considering the cells' capacities and the minimum receiving power guaranteeing successful communications. To do so, an integer linear programming problem is formulated and optimally solved for three cases based on the knowledge level about future renewable energy statistics of the drones. A low complex relaxed solution is also developed. Its performances are shown to be close to those of the optimal solutions. However, the gap increases as the network becomes more congested. Numerical results investigate the performance of the proposed drone-based approach and show notable improvements in terms of energy saving and network capacity.

Energy harvesting (EH) combined with cooperative communications constitutes a promising solution for future wireless technologies. They enable additional efficiency and increased lifetime to wireless networks. This paper investigates a multiple-relay selection scheme for an EH-based two-way relaying (TWR) system. All relays are considered as EH nodes that harvest energy from renewable energy and radio frequency (RF) sources. Some of them are selected to forward data to the destinations. The power splitting (PS) protocol, by which the EH node splits the input RF signal into two components for EH and information transmission, is adopted at the relay nodes. The objective is to jointly optimize i) the set of selected relays, ii) their PS ratios, and iii) their transmit power levels in order to maximize data rate-based utilities over multiple coherent time slots. A joint-optimization solution based on geometric programming (GP) and binary particle swarm optimization is proposed to solve non-convex problems for two utility functions reflecting the level of fairness in the TWR transmission. Numerical results illustrate the system's behavior versus various parameters and show that the performance of the proposed scheme is very close to that of the optimal branch-and-bound method and that GP outperforms the dual problem-based method.

This paper proposes and investigates a green virtualization framework for infrastructure sharing among multiple cellular operators whose networks are powered by a combination of conventional and renewable sources of energy. Under the proposed framework, the virtual network formed by unifying radio access infrastructures of all operators is optimized for minimum energy consumption by deactivating base stations (BSs) with low traffic loads. The users initially associated to those BSs are off-loaded to neighboring active ones. A fairness criterion for collaboration based on roaming prices is introduced to cover the additional energy costs incurred by host operators. The framework also ensures that any collaborating operator is not negatively affected by its participation in the proposed virtualization. A multi-objective linear programming problem is formulated to achieve energy and cost efficiency of the networks' operation by identifying the set of inter-operator roaming prices. For the case when collaboration among all operators is infeasible due to profitability, capacity, or power constraints, an iterative algorithm is proposed to determine the groups of operators that can viably collaborate. Results show significant energy savings using the proposed virtualization as compared to the standalone case. Moreover, collaborative operators exploiting locally generated renewable energy are rewarded more than traditional ones., Comment: Accepted for publication in IEEE Transactions on Cognitive Communications and Networking

Zone-level occupancy counting is a critical technology for smart buildings and can be used for several applications such as building energy management, surveillance, and public safety. Existing occupancy counting techniques typically require installation of large number of occupancy monitoring sensors inside a building as well as an established network. In this study, in order to achieve occupancy counting, we consider the use of WiFi probe requests that are continuously transmitted from WiFi enabled smart devices. To this end, WiFi Pineapple equipment are used for passively capturing ambient probe requests from WiFi devices such as smart phones and tablets, where no connectivity to a WiFi network is required. This information is then used to localize users within coarsely defined occupancy zones, and subsequently to obtain occupancy count within each zone at different time scales. An interacting multi-model Kalman filter technique is developed to improve occupancy counting accuracy. Our numerical results using WiFi data collected at a university building show that utilization of WiFi probe requests can be considered a viable solution tool for zone-level occupancy counting in smart buildings., Comment: 11 pages, 14 figures

Passive Radio-Frequency IDentification (RFID) systems carry critical importance for Internet of Things (IoT) applications due to their energy harvesting capabilities. RFID based position estimation, in particular, is expected to facilitate a wide array of location based services for IoT applications with low-power requirements. In this paper, considering monostatic and bistatic configurations and 3D antenna radiation pattern, we investigate the accuracy of received signal strength based wireless localization using passive ultra high frequency (UHF) RFID systems. The Cramer-Rao Lower Bound (CRLB) for the localization accuracy is derived, and is compared with the accuracy of maximum likelihood estimators for various RFID antenna configurations. Numerical results show that due to RFID tag/antenna sensitivity, and the directional antenna pattern, the localization accuracy can degrade at blind locations that remain outside of the RFID reader antennas' main beam patterns. In such cases optimizing elevation angle of antennas are shown to improve localization coverage, while using bistatic configuration improves localization accuracy significantly., Comment: 11 pages, 8 figures

Cellular operators are increasingly turning towards renewable energy (RE) as an alternative to using traditional electricity in order to reduce operational expenditure and carbon footprint. Due to the randomness in both RE generation and mobile traffic at each base station (BS), a surplus or shortfall of energy may occur at any given time. To increase energy self-reliance and minimize the network's energy cost, the operator needs to efficiently exploit the RE generated across all BSs. In this paper, a hybrid energy sharing framework for cellular network is proposed, where a combination of physical power lines and energy trading with other BSs using smart grid is used. Algorithms for physical power lines deployment between BSs, based on average and complete statistics of the net RE available, are developed. Afterwards, an energy management framework is formulated to optimally determine the quantities of electricity and RE to be procured and exchanged among BSs, respectively, while considering battery capacities and real-time energy pricing. Three cases are investigated where RE generation is unknown, perfectly known, and partially known ahead of time. Results investigate the time varying energy management of BSs and demonstrate considerable reduction in average energy cost thanks to the hybrid energy sharing scheme., Comment: 16 pages 8 figures in IEEE Transactions on Communications 2017

In this paper, the production decisions across multiple energy suppliers in smart grid, powering cellular networks are investigated. The suppliers are characterized by different offered prices and pollutant emissions levels. The challenge is to decide the amount of energy provided by each supplier to each of the operators such that their profitability is maximized while respecting the maximum tolerated level of CO2 emissions. The cellular operators are characterized by their offered quality of service (QoS) to the subscribers and the number of users that determines their energy requirements. Stochastic geometry is used to determine the average power needed to achieve the target probability of coverage for each operator. The total average power requirements of all networks are fed to an optimization framework to find the optimal amount of energy to be provided from each supplier to the operators. The generalized $\alpha$-fair utility function is used to avoid production bias among the suppliers based on profitability of generation. Results illustrate the production behavior of the energy suppliers versus QoS level, cost of energy, capacity of generation, and level of fairness., Comment: 6 pages, 4 figures

In this paper, the problem of energy efficiency in cellular heterogeneous networks (HetNets) is investigated using radio resource and power management combined with the base station (BS) ON/OFF switching. The objective is to minimize the total power consumption of the network while satisfying the quality of service (QoS) requirements of each connected user. We consider the case of co-existing macrocell BS, small cell BSs, and private femtocell access points (FAPs). Three different network scenarios are investigated, depending on the status of the FAPs, i.e., HetNets without FAPs, HetNets with closed FAPs, and HetNets with semi-closed FAPs. A unified framework is proposed to simultaneously allocate spectrum resources to users in an energy efficient manner and switch off redundant small cell BSs. The high complexity dual decomposition technique is employed to achieve optimal solutions for the problem. A low complexity iterative algorithm is also proposed and its performances are compared to those of the optimal technique. The particularly interesting case of semi-closed FAPs, in which the FAPs accept to serve external users, achieves the highest energy efficiency due to increased degrees of freedom. In this paper, a cooperation scheme between FAPs and mobile operator is also investigated. The incentives for FAPs, e.g., renewable energy sharing and roaming prices, enabling cooperation are discussed to be considered as a useful guideline for inter-operator agreements., Comment: 15 pages, 9 Figures, IEEE Transactions on Vehicular Technology 2017