Search

Green assessment of analytical procedures has become an environmental obligation in equivalence to their International Council of Harmonization analytical validation obligation. Worldwide awareness of our planet and ecological hazards have raised the shades of green and sustainable chemistry in pure or formulated API assays. The Green Analytical Procedure Index (GAPI) is instant five pentagrams for evaluating the greenness of each step in the developed analytical procedure, in discriminative colors: green, yellow, and red. In the present study, GAPI is applied to assess three novel direct analytical methods: spectrophotometric, fluorimetric, and high-performance thin-layer chromatography (HPTLC) for remdesivir (RDV) quantitation, both in bulk and pharmaceutical vials. Furthermore, a comparative green level calculated GAPI study has been assembled for the proposed methods versus the previously reported methods, for RDV assay, of similar techniques. Spectrophotometric direct Amax method at 240 nm, fluorimetric emission at 404 nm upon excitation at 275 nm as well as the HPTLC densitometric measurement using ethanol and distilled water (7:3, v/v) as mobile phase, all three methodologies are developed, optimized, and fully validated for RDV quantitation. They have been applied to assay RDV pharmaceutical vials and results are compared together with a one-way ANOVA test. Satisfactory recoveries and nano-level sensitivities in addition to the least standard deviations encourage the use of developed methods for routine analysis in quality control laboratories. Their promising greenness profile satisfies the beliefs of ecological sustainability of Green Agenda 2030.

Potent muscle relaxant (thiocolchicoside, TCC) and nonsteroidal anti-inflammatory drug (etoricoxib, ETXB) fixed-dose combination is formulated at relatively high 1:15 and 1:7.5 ratios for TCC and ETXB, respectively. Since the minor component (TCC) has lower absorptivity, assay of TCC/ETXB tablets presents an analytical challenge. The current study presents two novel methods: first is a micellar electrokinetic capillary chromatography (MEKC). Background electrolyte is borate buffer (40 mM, pH 9.2) containing 30 mM sodium dodecyl sulfate and methanol (ratio 80:20%, v/v), measured at 210 nm. Second is a direct double A max spectrophotometric method; minor component, TCC, is measured directly at its distant λ max (373 nm), at zero absorption of ETXB. Then, a ten-fold dilution step is carried out to eliminate TCC spectral interference and ETXB is determined at its λ max (282 nm). Both drugs’ concentrations disclose obedient linearities at 2–100 μg·mL−1 in MEKC, versus 3–25 and 40–350 μg·mL−1 for TCC and ETXB, respectively, in spectrophotometry. All ICH validation elements have been fulfilled for the developed methods. MEKC and spectrophotometric assays achieve accuracy, precision, selectivity, and robustness to be recommended for industrial quality control routine analysis of TCC/ETXB pills formulated at cited ratios or even higher.

The widespread coronavirus 2019 (COVID-19) pandemic, attributed to the severe acute respiratory syndrome coronavirus-2, has resulted in global lockdowns and excess mortality. Remdesivir (RM) is the first and only antiviral drug that the US Food and Drug Administration (FDA) has approved so far for COVID-19. The treatment protocol involves multidrug combinations, basically depending on RM, in addition to antimicrobials, antipyretics, corticosteroids, and anticoagulants. This study develops and validates sensitive and selective RM screening in spiked human plasma in the presence of commonly co-administered drugs. Hydroxychloroquine, azithromycin, paracetamol, dexamethasone, and anticoagulants (rivaroxaban and edoxaban) have been detected simultaneously with RM in the same biological matrix. Separation has been efficiently achieved by simple reversed phase HPLC with dual detectors. Diode array detector and fluorimetric detection have been used to compare their sensitivity and selectivity. Both assays have been validated according to bioanalytical FDA validation parameters. Chromatographic separation and quantitation of RM along with concomitant drugs instantly bioscreen COVID-19 multiple therapy medication in 10 min run time. Furthermore, the proposed in vitro study takes the lead for prospective testing of possible drug–drug interactions that alter the pharmacokinetic profiles of drugs.

The recent interest in bioactive compounds from natural sources has led to the evolution of the skin care industry. Efforts to develop biologically active ingredients from natural sources have resulted in the emergence of enhanced skin care products. Spirulina (SPR), a nutritionally enriched cyanobacteria-type microalga, is rich in nutrients and phytochemicals. SPR possesses antioxidant, immunomodulatory, and anti-inflammatory activities. Spirulina-loaded bilosomes (SPR-BS), a novel antiaging drug delivery system, were designed for the first time by incorporation in a lecithin–bile salt-integrated system for bypassing skin delivery obstacles. The optimized BS had good entrapment efficiency, small particle size, optimal zeta potential, and sustained drug release pattern. Blank and SPR-loaded BS formulations were safe, with a primary irritancy index of <2 based on the Draize test. In vivo tests were conducted, and photoprotective antiaging effects were evaluated visually and biochemically by analyzing antioxidant, anti-inflammatory, and anti-wrinkling markers following ultraviolet (UV) B irradiation. Results of biochemical marker analysis and histopathological examination confirmed the superior antiaging effect of SPR-BS compared with SPR. Thus, SPR-loaded BS is a promising nanoplatform for SPR delivery, can be used for treating UV-induced skin damage, and offers maximum therapeutic outcomes. [ABSTRACT FROM AUTHOR]

Semaglutide (SEMG) is one of the most widely used and trending medications to treat type II diabetes and obesity. This work aimed to develop a liquid chromatography with spectroflourimetric detection (HPLC-flourimetry) analysis of SEMG in both its tablet dosage form and plasma. The power of fluorescence detection coupled with HPLC proved its capability as a bioanalytical tool to assay SEMG in plasma samples owing to its simplicity and sensitivity which reached below the Cmax of SEMG. Separation was done using a C18 column with mobile phase of acetonitrile and water acidified with orthophosphoric acid (pH 3.5) (1.41 × 10–5 M) in isocratic mode in ratio 57:43 and 1 mL/min flow rate after extraction using protein precipitation. Detection was carried out at λ excitation of 238 nm and λ emission of 416 and 307 nm for SEMG and the internal standard, respectively. Evaluation of greenness of the proposed method was done using AGREE (Analytical GREEnness Metric Approach), ComplexGAPI (Complementary Green Analytical Procedure Index) & the new algorithm RGB 12 model (Red–Green–Blue). They showed that these methods can be a greener alternative with acceptable sensitivity for analysis of SEMG. The developed seven min-assay was validated per ICH as well as FDA bio analytical methods’ guidelines to prove its applicability for routine sample analysis and future pharmacokinetic studies. [ABSTRACT FROM AUTHOR]

Diabetics are liable to fatal atherosclerotic cardiovascular diseases. It is clinically attributed to their imbalanced plasma lipoproteins. Fixed‐dose combination "polypill" of simvastatin (10 mg) and sitagliptin phosphate (100 mg) is mainly indicated for the treatment of diabetic dyslipidemia. Novel green micellar electrokinetic capillary chromatographic method has been developed for simultaneous determination of simvastatin and sitagliptin phosphate in binary synthetic mixtures and their pharmaceutical formulation. Separation was achieved using a deactivated fused silica capillary (50 cm effective length × 50 μm id) through a background running electrolyte of 100 mM borate buffer (pH 9.1) and 100 mM sodium dodecyl sulfate. Diode array detection was set at 238 and 210 nm for simvastatin and sitagliptin phosphate, respectively. All experimental parameters were closely varied and optimized. Both drugs declared good linearities over the range of 10–100 μg/mL. Proposed study was validated according to International Council for Harmonization guidelines. It was applied to the assay of laboratory‐made binary mixtures and marketed tablets. Electrophoretic assay was compared with a reported spectrophotometric one. Satisfactory t‐test and F‐ratio indicated insignificant differences between both methods. Moreover, it is the first capillary electrophoretic simultaneous assay for simvastatin and sitagliptin phosphate, and fits a linear correlation with the green analytical attributes. [ABSTRACT FROM AUTHOR]

Two simple methods have been developed and validated for the simultaneous determination of rosiglitazone maleate (ROS) and metformin hydrochloride (MET) in synthetic mixtures and coated tablets in a ratio of 1:250 (ROS:MET). The first method was a spectrophotometric one. The minor component, ROS was determined by measuring the values of absorbance at λmax 312 nm and the D1 amplitudes at 331 nm where MET shows no absorption contribution. However, absorbance interferences from tablet excipients were successfully corrected by D1 at 331 nm zero-crossing technique. Study of spectral interference from tablet excipients was included in the text. Standard curves for Amax and D1 methods were in the concentration range 20.0-80.0 μg mL−1. The major component, MET was determined both in binary mixtures and tablets by measuring its Amax at 236 nm. Extensive dilution eliminated any absorption contribution from the coexisting ROS or tablet matrix. Standard curves showed linearity in the concentration range 4.0-12.8 μg mL−1. The second method was based on high performance thin layer chromatography (HPTLC) separation of the two drugs followed by densitometric measurements of their spots at 230 nm. The separation was carried out on Merck HPTLC aluminium sheets of silica gel 60 F254 using methanol:water:NH4Cl 1% w/v (5:4:1 v/v/v) as the mobile phase. Linear calibration graphs of peak area values were obtained versus concentrations in the range of 0.4-2.0 μg band−1 and 20.0-100.0 μg band−1 for ROS and MET, respectively. According to International Conference on Harmonisation (ICH) guidelines, different validation parameters were verified for the two methods and presented. [ABSTRACT FROM AUTHOR]

Two simple and sensitive kinetic spectrophotometric methods for the determination of sucralose are described. The first method is based upon a kinetic investigation of the oxidation reaction of the drug with alkaline potassium permanganate at room temperature for a fixed time of 30 min. The absorbance of the green coloured manganate ions produced was measured at 610 nm. The second method is based on the reaction of sucralose with cerium (IV) ammonium sulfate in the presence of perchloric acid with the subsequent measurement of the excess unreacted cerium (IV) ammonium sulfate at 320 nm at a fixed time of 30 min in a thermostated water bath at 60 ± 1 °C. This principle is adopted to develop a kinetic method for sucralose determination. The absorbance concentration plots in both methods were rectilinear over the range 4-16 and 10-30 µg ml, for the first and second methods, respectively. The different experimental parameters affecting the development and stability of the colours were carefully studied and optimized. The determination of sucralose by rate constant method, fixed concentration method, and fixed-time method was also feasible with calibration equations obtained but the latter method was found to be more applicable. The two methods have been applied successfully to commercial tablets. Copyright © 2010 John Wiley & Sons, Ltd. Two simple and sensitive kinetic spectrophotometric methods for the determination of Sucralose are described. The first method is based upon a kinetic investigation of the oxidation reaction of the drug with alkaline potassium permanganate. The absorbance of the green colored manganate ions produced was measured at 610 nm. The second method is based on the reaction of Sucralose with cerium (IV) in the presence of perchloric acid and measurement of the excess unreacted cerium (IV) at 320 nm. [ABSTRACT FROM AUTHOR]

Background: Intestinal coccidiosis is a debilitating disease in poultry and livestock, leading to economic impact worldwide. Coccidiosis is prevented and treated in broilers by the inclusion of anticoccidials in feed. Toltrazuril is administered in potable water to treat coccidiosis., Objective: Three robust analytical methods for quantitation of toltrazuril in pure and pharmaceutical formulations are developed. Furthermore, ecological metrics; either penalization- or color-code-based techniques are applied for the appraisal of assays., Methods: Firstly, Second-Derivative (Δλ; 5 nm) spectrophotometric method; Toltrazuril is measured from peak to peak at 244-260 nm within a linearity range of 5-25 μg/mL. The second one is a high-performance thin-layer chromatography (HPTLC) analysis performed on an aluminum sheet of silica gel using ethyl acetate, methanol, ammonium chloride buffer, and water (8:1:0.5:0.5) (%V/V) as the elution phase. Toltrazuril, at a retardation factor of 0.66 ± 0.01, is linearly determined in the range of 1-9 μg/spot at 243 nm. The third one is Reversed Phase-HPLC-diode array detection, using Agilent column C18 (5 μm, 4.6 x 150 mm) in isocratic elution mode with a mobile phase of acetonitrile and water in a ratio of 80:20 (v/v), respectively, at 1 mL/min flow rate. Toltrazuril elutes at a retention time of 2.58 ± 0.1 min and is linearly determined at 243 nm in the range of 0.25-25 μg/mL., Results: Calculated 2D-values and peak areas are highly correlated to their corresponding drug concentrations at coefficients; r > 0.999. All methods were ICH validated and applied to dosage form with satisfactory % recoveries (97-103%). Statistical comparisons reported one using t-test and F-test disclose insignificant variation. Examining greenness and whiteness norms, proposed methods were evaluated and ranked alongside four different reported methods., Conclusion: The proposed methods are green, accurate, and can be applied in routine quality control for the determination of toltrazuril in pharmaceutical formulations., (© The Author(s) 2024. Published by Oxford University Press on behalf of AOAC INTERNATIONAL. All rights reserved. For permissions, please email: journals.permissions@oup.com.)