Search

The acoustic properties of seafloor sediments on continental slopes play a crucial role in underwater acoustic propagation, communication, and detection. To investigate the acoustic characteristics and spatial distribution patterns of sediments on the continental slope, a geoacoustic experiment was conducted in the northwestern South China Sea. The experiment covered two sections: one crossing the shelf and slope in the downslope direction, and the other near the shelf break in the along-slope direction. In situ techniques, sediment sampling, and laboratory measurements were used to acquire data on sediment acoustic properties (such as sound speed and attenuation) and physical properties (including particle composition, density, porosity, and mean grain size). The experimental findings revealed several key points: (1) Acoustic properties of shallow water coarse-grained sediments and deep-sea sediments were higher when measured in the laboratory compared to in situ measurements. (2) Relationships between measured attenuation and physical properties, as well as between sound speed and mean grain size, showed deviations from previous empirical equations. (3) Sediment acoustic and physical properties exhibited significant variations in the downslope direction, while showing gradual variations in the along-slope direction. These variations can be attributed to sedimentary environmental factors such as material sources, hydrodynamic conditions, and water depth. [ABSTRACT FROM AUTHOR]

This study focuses on the inversion of sub-bottom profile (SBP) data in the northern South China Sea using an empirical relationship derived from sediment acoustic data. The sub-bottom profile is primarily utilized for various marine applications, such as geological mapping and resource exploration. In this research, we present a study conducted in the northern slope canyon of the South China Sea. Firstly, we obtained the seabed reflection coefficient from sub-bottom profiles obtained by the autonomous underwater vehicle (AUV) detection system. Secondly, we utilized the acoustic empirical relationship in the northern South China Sea to establish relationship equations between the seabed reflection coefficient and the porosity, density, and average particle size of the sediment at a main frequency of 4 kHz (the AUV shallow profile main frequency). Then, using these equations, we were able to invert the physical parameters such as porosity, density, and average particle size of the seabed surface sediments. Finally, the inverted results are compared and analyzed by using the sediment samples test data. The overall deviation rate of the inverted physical parameters is within the range of ±10% when compared. The inverted results closely match the measured values, accurately reflecting the dynamic changes in the physical properties of seabed surface sediments. Notably, the average grain size is a direct indicator of the sediment particles size with smaller particles found in deeper water. The variation characteristics of sediment physical parameters align well with the variation of sediment types in the canyon, which is consistent with changes in the water depth, topography, and hydrodynamic conditions of the area. This further demonstrates the reliability of the inversion results. [ABSTRACT FROM AUTHOR]

Based on the data of the acoustic and physical properties of seafloor sediments obtained on the continental shelf area of the East China Sea (ECS), prediction equations of the sediment sound speed based on single and dual parameters were established, and the correlation of the sound speed with physical parameters was discussed. The results show that the sediment sound speed (c) is strongly correlated with water content (w), density (ρ), void ratio (e), mean grain size (Mz) and median grain size (Md), and the coefficient of determination R2 of the empirical regression equation is generally greater than 0.80, while the empirical regression equation coefficient of determination R2 of the compression coefficient (a) and compression modulus (E) are slightly lower, with 0.79 and 0.73, respectively. The coefficients of determination of the dual parameter regression equations between sediment sound speed with physical property parameters are generally higher than those of the single parameter equations, which are all higher than 0.90 indicating better prediction performance. The sensitivity of the physical parameters to the sound speed was analyzed, and the result shows that the sequence of sensitivity from high to low influence on sediment sound speed is void ratio, density, compressibility coefficient, median grain size and mean grain size. The prediction equations established in this study are a good extension and supplement to marine geoacoustic models and is of great significance for obtaining the acoustic properties of the seafloor sediments on the shelf of the East China Sea. [ABSTRACT FROM AUTHOR]

The inversion method based on the reflection loss-grazing angle curve is an effective tool to obtain local underwater acoustic parameters. Because geoacoustic parameters vary in sensitivity to grazing angle, it is difficult to get accurate results in geoacoustic parameter inversion based on small-grazing-angle data in shallow water. In addition, the normal-mode model commonly used in geoacoustic parameter inversion fails to meet the needs of accurate local sound field simulation as the influence of the secant integral is ignored. To solve these problems, an acoustic data acquisition scheme was rationally designed based on a sparker source, a fixed vertical array, and ship drifting with the swell, which could balance the trade-off among signal transmission efficiency and signal stability, and the actual local acoustic data at low-to-mid frequencies were acquired at wide grazing angles in the South Yellow Sea area. Furthermore, the bottom reflection coefficients (bottom reflection losses) corresponding to different grazing angles were calculated based on the wavenumber integration method. The local seafloor sediment parameters were then estimated using the genetic algorithm and the bottom reflection loss curve with wide grazing angles, obtaining more accurate local acoustic information. The seafloor acoustic velocity inverted is c p = 1659   m / s and the sound attenuation is α p = 0.656   dB / λ in the South Yellow Sea. Relevant experimental results indicate that the method described in this study is feasible for local inversion of geoacoustic parameters for seafloor sediments. Compared with conventional large-scale inversion methods, in areas where there are significant changes in the seabed sediment level, this method can obtain more accurate local acoustic features within small-scale areas. [ABSTRACT FROM AUTHOR]

Based on the data of the sound speed and the physical–mechanical properties of 300 seafloor sediment samples collected in the middle area of the Southern Yellow Sea, a backpropagation (BP) neural network algorithm is used herein to study the neural network topology and the corresponding neuron characteristic factors. A neural network model for predicting the sound speed of the seafloor sediment based on density, water content, porosity, void ratio, liquid limit, plastic limit, and clay content in the middle area of the Southern Yellow Sea is established. The results show that the sound speed prediction accuracy is the highest when the network model contains seven input layer neurons, ten hidden layer neurons, and one output node. According to the prediction results, the MAE(Mean Absolute Error) and the MAPE(Mean Absolute Percentage Error) are 13.19 m s−1 and 0.85%, respectively. The prediction results illustrate that the established BP neural network prediction method for the seafloor sediment sound speed is better than the traditional single, two and multi-parameter prediction equations. [ABSTRACT FROM AUTHOR]

To measure and characterize the roughness spectrum of sea-bottom, which is an important input parameter of the bottom acoustic backscattering model, an underwater laser three-dimensional (3D) scanning system for measuring seafloor microtopography has been developed successfully. The proposed underwater laser 3D scanning system can provide 3D seafloor microtopography with the resolution of millimeter levels in both horizontal and vertical directions and obtain the roughness spectrum of sea-bottom further. Two sets of data, which were suitable to model low- and mid-frequency acoustic backscattering at 6–24 kHz, were collected in two sites of sandy bottom during the acoustic scattering experiment in the southern Yellow Sea. The one-dimensional (1D) and two-dimensional (2D) roughness spectrum of the seafloor have been calculated at the two sites named S1 and S2, respectively. The result shows that calculated 2D spectral indices and spectral intensities, respectively, were 3.45 and 2.17 × 10−4 m4 at S1 and 3.33 and 4.66 × 10−4 m4 at S2. 2 D roughness spectrum parameters were used to model the acoustic scattering at S1, and the result indicates that the measurement results of the seafloor roughness spectrum is suitable for modeling bottom acoustic scattering. [ABSTRACT FROM AUTHOR]

The shear wave characteristics of shallow seafloor sediment are vital to marine acoustic study and ocean engineering exploration. We analyzed the shear wave speed and the physical properties of the southern Yellow Sea sediment based on the Grain-Shearing (GS) model. The results show that: (1) The shear wave speed of the high-porosity sediment is lower than that of the low-porosity sediment; (2) The shear wave speed of the fine-grained sediment is lower than that of the coarse-grained sediment; (3) The burial depth of the sediment has a significant influence on the shear wave speed of the seafloor sediment. The GS model agrees well with the measurement data from the southern Yellow Sea. However, the quantitative analysis of the impact of input parameters on the GS model requires further research. [ABSTRACT FROM AUTHOR]