Search

Purpose: To test whether the force–velocity (F–V) relationship obtained during a specific single-stroke kayak test (SSKT) and during nonspecific traditional resistance-training exercises (bench press and prone bench pull) could discriminate between 200-m specialists and longer-distance (500- and 1000-m) specialists in canoe sprint. Methods: A total of 21 experienced male kayakers (seven 200-m specialists and 14 longer-distance specialists) participated in this study. After a familiarization session, kayakers came to the laboratory on 2 occasions separated by 48 to 96 hours. In a randomized order, kayakers performed the SSKT in one session and the bench press and bench pull tests in another session. Force and velocity outputs were recorded against 5 loads in each exercise to determine the F–V relationship and related parameters (maximum force, maximum velocity, F–V slope, and maximum power). Results: The individual F–V relationships were highly linear for the SSKT (r =.990 [.908,.998]), bench press (r =.993 [.974,.999]), and prone bench pull (r =.998 [.992, 1.000]). The F–V relationship parameters (maximum force, maximum velocity, and maximum power) were significantly higher for 200-m specialists compared with longer-distance specialists (all Ps ≤.047) with large effect sizes (≥0.94) revealing important practical differences. However, no significant differences were observed between 200-m specialists and longer-distance specialists in the F–V slope (P ≥.477). Conclusions: The F–V relationship assessed during both specific (SSKT) and nonspecific upper-body tasks (bench press and bench pull) may distinguish between kayakers specialized in different distances. [ABSTRACT FROM AUTHOR]

This study aimed to compare the magnitude of the force-velocity (F-V) relationship parameters (maximum force [F0], maximum velocity [V0], F-V slope, and maximum power [Pmax]) between the squat jumps (SJ) performed from different knee angles. The F-V relationships of 12 men were assessed in 3 sessions during the SJ performed from a knee angle of 80° (SJ80), 90° (SJ90) and 100° (SJ100). The SJ100 provided likely to very likely higher values of F0 and Pmax compared to SJ80 (86% and 98%, respectively) and SJ90 (73% and 94%, respectively), while unclear and trivial differences were observed for the remaining comparisons. The magnitude of the correlations between the 3 SJ types was very large to nearly perfect for Pmax (r range = 0.864 to 0.940), moderate to very large for F0 (r range = 0.438 to 0.778), and small to large for V0 (r range = 0.361 to 0.642) and the F-V slope (r range = 0.178 to 0.645). These results suggest that the F-V relationship assessed during the SJ exercise is affected by the initial knee angle with the increase of the knee angle from 80° to 100° being associated with higher values of F0 and Pmax, while V0 remains unchanged. [ABSTRACT FROM AUTHOR]

This study aimed to explore the effect of the knee angle and loading condition on the magnitude and reliability of squat jump (SJ) performance variables. Thirteen male sport sciences students performed in a random order 4 SJ types (knee angle of 80º [SJ80], 90º [SJ90], 100º [SJ100], and self-preferred [SJpref]) against 3 external loads. The push-off distance (HpO), jump height (Hmax), maximum force (Fmax) and maximum power (Pmax) were obtained from force platform recordings. The HpO during the SJpref (43.4 ± 6.4 cm) was always between SJ90 (44.3 ± 4.8 cm) and SJ100 (40.5 ± 4.2 cm). The magnitudes of Hmax, Fmax and Pmax were comparable or higher during the SJpref. The increase of the knee angle was associated with larger values of Fmax and Pmax, but no significant differences were observed for Hmax. An acceptable reliability was observed for HpO (coefficient of variation [CV]≤5.09% and intraclass correlation coefficient [ICC]≥0.78), Hmax (CV≤6.06% and ICC≥0.84), Fmax (CV≤3.25% and ICC≥0.96) and Pmax (CV≤2.93% and ICC≥0.96). Reliability did not systematically differ between the 4 SJ types. In conclusion, the higher magnitudes and comparable reliability of the performance variables obtained during the SJpref support its use for testing lower-body ballistic performance against different loads. [ABSTRACT FROM AUTHOR]

The assessment of the force-velocity (F-V) profile in athletes may have important applications for training prescription, injury management, and fatigue monitoring. This study aimed to assess whether a novel single kayak stroke test (SKST) is able to provide the F-V relationship variables (maximum force, maximum velocity and maximum power) of competitive kayakers with acceptable reliability and external validity. Six female (age: 20.3 ± 3.7 years) and eight male (age: 20.8 ± 2.4 years) elite kayakers performed the SKST, bench press, bench pull, and short Wingate kayak test. The individual F-V relationships were highly linear [median r (range): left stroke = 0.986 (0.897 - 0.998); right stroke = 0.987 (0.971 - 0.999)]. The reliability of the F-V relationship parameters obtained during the SKST was high (within-session: CV ≤ 4.48% and ICC ≥ 0.93; between-session: CV ≤ 8.06% and ICC ≥ 0.65). The validity of the F-V relationship parameters obtained during the SKST was generally very high for maximum power (r range = 0.825 - 0.975), high for maximum force during both the bench press and the bench pull (r range = 0.751 - 0.831), and high or moderate for maximal velocity during the bench pull (r = 0.770 - 0.829) and the bench press (r = 0.355 - 0.471), respectively. The SKST can be considered a feasible procedure for testing the maximal upper-body muscle mechanical capacities of kayakers. [ABSTRACT FROM AUTHOR]

This study aimed to compare the reliability and magnitude of the force-velocity (F-V) relationship parameters between the squat jumps performed from the 90° (SJ90) and self-preferred knee angle (SJpref). A secondary aim was to explore the effect of the analysis procedure (force platform [FP] and Samozino's [SAM] method) and the number of loads tested (three- and two-point methods) on the F-V relationships. Twelve men were tested in two sessions during the SJ90 and SJpref. Two identical blocks of jumps were performed in each session against three external loads. The F-V relationship parameters (maximum force, maximum velocity, F-V slope and maximum power) were determined at each block through the FP and SAM procedures using the data collected under three (three-point method) or only the two most distant loads (two-point method). The average coefficient of variation (CV) of the four F-V parameters revealed a higher reliability for the SJ90 compared to the SJpref (5.86% vs. 7.55%; CVratio = 1.29) with more pronounced differences using the FP (CVratio = 1.43) than the SAM procedure (CVratio = 1.14), and higher reliability for the SAM compared to the FP (6.14% vs. 7.27%; CVratio = 1.18). The SJpref and SAM procedures provided comparable or higher magnitude of the F-V relationship parameters than the SJ90 and FP, respectively. The three- and two-point methods revealed a comparable reliability and trivial differences in the magnitude of the F-V relationship parameters. The routine testing procedure of the F-V relationship could be simplified using the SJpref, the SAM procedure and the two-point method. [ABSTRACT FROM AUTHOR]

The Sport Competitive Anxiety Test (SCAT) has been applied most widely to estimate anxiety in sport. Although the SCAT has been modified to make the instrument more appropriate for the assessment of the multidimensional competitive trait anxiety construct, the extended version (SCATe) has not been validated to date. The aim of this study was to investigate factorial validity of the SCATe, as well as the consistency of the three subscale measures within the global score. SCATe was evaluated with 1024 young competitors aged 12 to 21 years, involved in 21 sports. The Cronbach's coefficients, exploratory and confirmatory factorial analysis and the Spearman Correlation were applied. The three-factor model accounts for 34.23% of the total variance of competitive anxiety. All three dimensions revealed significant inherent eigenvalues (6.79, 1.98, and 1.49). The somatic component was 23%, while selfconfidence and cognitive components were 7% and 5%, respectively. The results indicated acceptable internal consistency and factorial validity for successful evaluation of a global score for competitive trait anxiety and the three individual subscale scores: somatic, cognitive and self-confidence. The data suggest that SCATe could be applied as alternative test to SCAT, however, further improvement of the SCATe metric characteristics is recommended. [ABSTRACT FROM AUTHOR]

Single outcomes of standard isokinetic dynamometry tests do not discern between various muscle mechanical capacities. In this study, we aimed to (1) evaluate the shape and strength of the force-velocity relationship of knee extensors, as observed in isokinetic tests conducted at a wide range of angular velocities, and (2) explore the concurrent validity of a simple 2-velocity method. Thirteen physically active females were tested for both the peak and averaged knee extensor concentric force exerted at the angular velocities of 30 °-240 °/s recorded in the 90 °-170 ° range of knee extension. The results revealed strong (0.960 < R < 0.998) linear force-velocity relationships that depict the maximum muscle force (i.e. the forceintercept), velocity (velocity-intercept), and power (their product). Moreover, the line drawn through only the 60 ° and 180 °/s data (the '2-velocity method') revealed a high level of agreement with the force-velocity relationship obtained (0.76 < R < 0.97; all power < 0.001); while the force-intercept highly correlated (0.68 < R < 0.84; all power ≤ 0.01) with the directly measured isometric force. The 2-velocity method could therefore be developed into a standard method for isokinetic testing of mechanical capacities of knee extensors and, if supported by further research, other muscles. This brief and fatigue- free testing procedure could discern between muscle force, velocity, and power-producing capacities. [ABSTRACT FROM AUTHOR]

The aim of this study was to assess the effect of a unilateral anterior cruciate ligament reconstruction (ACLR) on maximum voluntary contraction (MVC) and explosive strength of both the involved limb and the uninvolved limb. Nineteen male athletes completed a standard isometric testing protocol 4 months post-ACLR, while 16 healthy participants served as a control group (CG). The explosive strength of the knee extensors and flexors was assessed as RFD obtained from the slope of the force–time curves over various time intervals. Both muscle groups of the involved limb had significantly lower MVC compared to the uninvolved. The involved limb also had significantly lower RFD in the late phase of contraction (140–250 ms) for both knee extensors and flexors (P < 0.05). There was no difference in MVC between the uninvolved limb and the CG. However, RFD of the uninvolved limb was lower compared to CG for both knee extensors (0–180 ms;P < 0.01) and flexors (0–150 ms;P < 0.05). ACLR leads to lower MVC and explosive strength of the involved limb. As a consequence of potential crossover (presumably neural-mediated) effects, explosive strength deficits could be bilateral, particularly in the early phase of the contraction (<100 ms). [ABSTRACT FROM AUTHOR]