Search

Objective To discuss and summarize the preventive measures and treatment methods for aspiration/ingestion during dental procedures. Methods One case of aspiration during an implant operation was reported, and the literature on aspiration/ingestion during oral procedures was reviewed. Results An implant screwdriver accidentally slipped into the mouth of the patient during implant surgery. The patient experienced no obvious discomfort except a few coughs. The surgeon and assistant paused the procedure immediately to search for the screwdriver, but it was not found. The patient declared that there was no special abnormality, such as breathing disorder or chest distress, so we considered that the foreign body was ingestion. After the implant surgery was completed, no foreign body was found in the stomach via gastroscopy. Chest X-ray and CT showed a dense metal shadow in the lower lobe of the left lung. Under local anesthesia, bronchoscopy and biopsy forceps were used by respiratory physicians to clip out the foreign body. After removal of the foreign body, the patient had no obvious discomfort but a slight cough. Cephalexin and metronidazole were given for three days to prevent infection. Three days later, the patient had no complaints of respiratory discomfort. After reviewing the literature, we found that the operation should be paused immediately after aspiration/ingestion occurs during dental procedures and that the dental chair should be laid down to prevent the foreign body from descending deeper, which may increase the difficulty of removal and cause gastrointestinal and respiratory tract injury. The position of the foreign body should be determined by imaging examination, and the corresponding means to remove the foreign body should be performed. Conclusion Patients may have no obvious symptoms after aspiration/ingestion during dental procedures, and the foreign body can be removed after imaging examination.

In response to the precision machining of frictionless aluminum alloy cylinder with anodized oxide films, a composite spiral abrasive flow polishing method was proposed. A simulation model was established to analyze the collision between particles and the wall in polishing processes, and he influences of particle velocity in different directions on polishing were investigated. The processing mechanism of the composite spiral abrasive flow polishing was revealed. The simulation results show hat the composite spiral motion changes the trajectory of the abrasive particles, and the addition of rotational velocity enhances the effective stress of the abrasive. The effective plastic deformation of the wall increases with the spiral groove speed. Particle image velocimetry observation experimental results demonstrate that the composite spiral motion increases the rotational velocity of the abrasives and enhances the vorticity of the flow field. The experimental results show that the composite spiral abrasive flow polishing not only causes less damages to the aluminum alloy anodized film, and effectively improves the surface quality of the workpieces. [ABSTRACT FROM AUTHOR]

Swine enteric coronaviruses (SECs) cause significant economic losses to the pig industry in China. Although many commercialized vaccines against transmissible gastroenteritis virus (TGEV) and porcine epidemic diarrhea virus (PEDV) are available, viruses are still widespread. The recent emergence of porcine deltacoronavirus (PDCoV) and swine acute diarrhea syndrome coronavirus (SADS-CoV), for which no vaccines are available, increases the disease burden. In this review, we first introduced the genomic organization and epidemiology of SECs in China. Then, we discussed the current vaccine development and application in China, aiming to provide suggestions for better prevention and control of SECs in China and other countries. [ABSTRACT FROM AUTHOR]