Search

Cosmic dust models are key ingredients in advancing our understanding of astronomical environments as diverse as interstellar clouds in galaxies, circumstellar envelopes around evolved and young stars, and protoplanetary disks. Such models consist of several dust populations, each with different compositions and size distributions. They may also consider different grain shapes, although most models assume spherical grains. All include a component of silicate dust. The absorption and emission properties of these dust components are calculated from the optical constants of each dust material which have various experimental, phenomenological, and theoretical origins depending on the model. We aim to provide the community with new sets of optical constants for amorphous silicate dust analogues at low temperatures. The analogues consist of four Mg-rich silicate samples of stoichiometry ranging from enstatite to olivine, and of eight samples of Mg and Fe rich silicates with a pyroxene stoichiometry and differing magnesium and iron content. We calculated the optical constants from transmission measurements using the Kramers-Kronig relations, assuming that the grains are small compared to the wavelength and prolate in shape with axis ratios of 1.5 and 2 for the Mg and Fe rich samples, respectively. New optical constants for silicate dust analogues were calculated over the wavelength range from 5 to 800-1000 microns, depending on the sample, and at temperatures of 10, 30, 100, 200, and 300 K.We determined the uncertainties on the derived optical constants based on the assumptions used to calculate them. To facilitate the use of these data in cosmic dust models, we provide optical constants extrapolated outside the measured spectral range into the UV-NIR and mm-cm wavelength ranges, as well as formulae that can be used to interpolate them at any temperature in the range 10 - 300 K.

To model the cold dust emission observed in the diffuse interstellar medium, in dense molecular clouds or in cold clumps that could eventually form new stars, it is mandatory to know the physical and spectroscopic properties of this dust and to understand its emission. This work is a continuation of previous studies aiming at providing astronomers with spectroscopic data of realistic cosmic dust analogues for the interpretation of observations. Ferromagnesium amorphous silicate dust analogues were produced with a mean composition close to $\mathrm{Mg_{1-x}Fe_{x}SiO_3}$ with x = 0.1, 0.2, 0.3, 0.4. Part of each sample was annealed at 500$^{\circ}$C for two hours in a reducing atmosphere to modify the oxidation state of iron. We have measured the mass absorption coefficient (MAC) of these ferromagnesium amorphous silicate dust analogues in the spectral domain 30 - 1000 $\mu$m for grain temperature in the range 10 - 300 K and at room temperature in the 5 - 40 $\mu$m range. The MAC of ferromagnesium samples behaves in the same way as the MAC of pure Mg-rich amorphous silicate samples. In the 30 - 300 K range, the MAC increases with increasing grain temperature whereas in the range 10 - 30 K, we do not see any change of the MAC. The MAC cannot be described by a single power law in ${\lambda}^{-\beta}$. The MAC of all the samples is much higher than the MAC calculated by dust models. The complex behavior of the MAC of amorphous silicates with wavelength and temperature is observed whatever the exact silicate composition (Mg vs. Fe amount). It is a universal characteristic of amorphous materials, and therefore of amorphous cosmic silicates, that should be taken into account in astronomical modeling. The enhanced MAC of the measured samples compared to the MAC calculated for cosmic dust model implies that dust masses are overestimated by the models.

A wealth of data from the Herschel and Planck satellites and now from ALMA, revealing cold dust thermal emission, is available for astronomical environments ranging from interstellar clouds, cold clumps, circumstellar envelops, and protoplanetary disks. The interpretation of these observations relies on the understanding and modeling of cold dust emission and on the knowledge of the dust optical properties. The aim of this work is to provide astronomers with a set of spectroscopic data of realistic interstellar dust analogues that can be used to interpret the observations. Glassy silicates of mean composition (1-x)MgO - xSiO2 with x = 0.35, 0.40 and 0.50 were synthesized. The mass absorption coefficient (MAC) of the samples was measured in the spectral domain 30 - 1000 $\mu$m for grain temperature in the range 300 K - 10 K and at room temperature in the 5 - 40 $\mu$m domain. We find that the MAC of all samples varies with the grains temperature. In the FIR/submm, and above 30K, the MAC value at a given wavelength increases with the temperature as thermally activated absorption processes appear. The studied materials exhibit different and complex behaviors at long wavelengths (lambda $\geq$ 200 to 700 $\mu$m depending on the samples) and the MAC cannot be approximated by a single power law in ${\lambda}^{-\beta}$. These behaviors are attributed to the amorphous nature of dust and to the amount and nature of the defects within this amorphous structure. Above 20 $\mu$m, the measured MAC are much higher than the MAC calculated from interstellar silicate dust models indicating that the analogues measured in this study are more emissive than the silicates in cosmic dust models. This has important astrophysical implications because masses are overestimated by the models. Moreover, constraints on elemental abundance of heavy elements in cosmic dust models are relaxed

Cold dust grains emission in the FIR/submm is usually expressed as a modified black body law in which the dust mass absorption coefficient (MAC), is described with a temperature- and wavelength-independent emissivity spectral index, beta. However, numerous data from space and balloon-born missions and recently from Herschel and Planck show that dust emission is not well understood, as revealed by the observed anti-correlation of beta with the grain temperature. In order to give astronomers the necessary data to interpret FIR/submm observations, we synthesised analogues of interstellar amorphous and crystalline silicate grains, rich in Mg and Ca, and having stiochiometry of olivine and pyroxene and measured their MAC, in the 100-1000/1500 \mum range for grain temperatures varying from 300 to 10 K. We find that the grain MAC decreases when the grain temperature decreases and that the local spectral index, beta, defined as the slope of the MAC curve, is anti-correlated with the grain temperature. These variations, which are not observed in the crystallised samples, are related to the amorphous nature of the samples. In addition, the spectral shape of the MAC is complex: at short wavelengths (lambda < 500/700 \mum), beta is in the range 1.6 - 2.1 for all grain temperature and grain composition whereas at longer wavelengths (lambda > 500/700 \mum), beta < 2 for samples with a pyroxene stoichiometry and beta > 2 for samples with an olivine stoichiometry. Hence, the simplifying asymptotic expression based on a single temperature- and wavelength-independent spectral index used by astronomers is not appropriate to describe the dust MAC and thus the dust emission, and may induce significant errors on the derived parameters such as the dust mass and the dust physical and chemical properties. Instead, dust emission models should use the dust MAC as a function of wavelength and temperature.

We present laboratory studies of the micro-structural evolution of an amorphous ferro-magnesian silicate, of olivine composition, following thermal annealing under vacuum. Annealing under vacuum was performed at temperatures ranging from 870 to 1020 K. After annealing spheroidal metallic nano-particles (2-50 nm) are found within the silicate films. We interpret this microstructure in terms of a reduction of the initial amorphous silicate FeO component, because of the carbon-rich partial pressure in the furnace due to pumping mechanism. Annealing in a controlled oxygen-rich atmosphere confirms this interpretation. The observed microstructures closely resemble those of the GEMS (Glass with Embedded Metal and Sulphides) found in chondritic IDPs (Interplanetary Dust Particles). Since IDPs contain abundant carbonaceous matter, a solid-state reduction reaction may have occurred during heating in the hot inner regions of the proto-solar disc. Related to this, the presence of forsterite grains grown from the amorphous precursor material clearly demonstrates that condensation from gaseous species is not required to explain the occurrence of forsterite around young protostars and in comets. Forsterite grains in these environments can be formed directly in the solid phase by thermal annealing of amorphous ferro-magnesian silicates under reducing conditions., Comment: 4 pages, 2 figures. Accepted for publication A&A Letter to the Editor

Impact ionisation detectors on a suite of spacecraft have shown the direction, velocity, flux and mass distribution of smaller ISP entering the Solar System. During the aphelion segments of the Stardust flight, a dedicated collector surface was oriented to intercept ISP of beta = 1, and returned to Earth in January 2006. In this paper we describe the probable appeareance and size of IS particle craters from initial results of experimental impacts and numerical simulation, explain how foils are being prepared and mounted for crater searching by automated acquisition of high magnification electron images (whilst avoiding contamination of the foils) and comment on appropriate analytical techniques for Preliminary Examination (PE).

The findings of the Stardust spacecraft mission returned to earth in January 2006 are discussed. The spacecraft returned two unprecedented and independent extraterrestrial samples: the first sample of a comet and the first samples of contemporary interstellar dust. An important lesson from the cometary Preliminary Examination (PE) was that the Stardust cometary samples in aerogel presented a technical challenge. Captured particles often separate into multiple fragments, intimately mix with aerogel and are typically buried hundreds of microns to millimeters deep in the aerogel collectors. The interstellar dust samples are likely much more challenging since they are expected to be orders of magnitudes smaller in mass, and their fluence is two orders of magnitude smaller than that of the cometary particles. The goal of the Stardust Interstellar Preliminary Examination (ISPE) is to answer several broad questions, including: which features in the interstellar collector aerogel were generated by hypervelocity impact and how much morphological and trajectory information may be gained?; how well resolved are the trajectories of probable interstellar particles from those of interplanetary origin?; and, by comparison to impacts by known particle dimensions in laboratory experiments, what was the mass distribution of the impacting particles? To answer these questions, and others, non-destructive, sequential, non-invasive analyses of interstellar dust candidates extracted from the Stardust interstellar tray will be performed. The total duration of the ISPE will be three years and will differ from the Stardust cometary PE in that data acquisition for the initial characterization stage will be prolonged and will continue simultaneously and parallel with data publications and release of the first samples for further investigation.

Comets are generally believed to have formed in a cold region, trapping in the cometary ices the original low-temperature condensate grains of our Solar System. These grains would have been preserved in cold-storage, at a temperature below the freezing point of CO2, for the last 4.5+ billion years. Carbonates are common in hydrous meteorites and hydrous interplanetary dust particles (IDPs), where they are believed to have formed by parent-body aqueous processing. Since simple models of cometary evolution involve no aqueous processing, carbonates were generally presumed not to occur in comets. However, Toppani et al. [1] have performed experiments that indicate carbonate can be formed by non-equilibrium condensation in circumstellar environments where water is present as a vapor, not as a liquid. This suggests carbonate might have condensed in cold regions of the Solar Nebula, and might be present in comets.

Aluminium foils were used on Stardust to stabilize the aerogel specimens in the modular collector tray. Part of these foils were fully exposed to the flux of cometary grains emanating from Wild 2. Because the exposed part of these foils had to be harvested before extraction of the aerogel, numerous foil strips some 1.7 mm wide and 13 or 33 mm long were generated during Stardusts's Preliminary Examination (PE). These strips are readily accommodated in their entirety in the sample chambers of modern SEMs, thus providing the opportunity to characterize in situ the size distribution and residue composition - employing EDS methods - of statistically more significant numbers of cometary dust particles compared to aerogel, the latter mandating extensive sample preparation. We describe here the analysis of nearly 300 impact craters and their implications for Wild 2 dust.

It is expected that Comet Wild-2 dust should resemble anhydrous carbon-rich, chondritic porous (CP) interplanetary dust particles (IDPs) collected in the stratosphere because some CP IDPs are suspected to be from comets. The rarity of carbonaceous grains and presolar silicates, as well as the presence of high-temperature inner solar nebula minerals in the Wild-2 sample (e.g. osbornite and melilite), appear incompatible with most CP IDPs. However, it is premature to draw firm conclusions about the mineralogy of comet Wild-2 because only approx. 1% of the sample has been examined. The most abundant silicates in CP IDPs are GEMS (glass with embedded metal and sulfides). Nonsolar O isotopic compositions confirm that at least some GEMS in IDPs are presolar amorphous silicates. The presence or absence of GEMS in the Wild-2 sample is important because it addresses, (a) the relationship between CP IDPs and comets, and (b) the hypothesis that other GEMS in IDPs formed in the solar nebula. Here we show that most of the GEMSlike materials so far identified in Stardust aerogel were likely impact generated during collection. At the nanometer scale, they are compositionally and crystallographically distinct from GEMS in IDPs.