Search

In this study, we successfully designed and tested a new micropump that utilizes an active check valve and bottom-protruding structure to achieve sample transportation. We performed theoretical analyses and numerical simulations to determine the optimal location of the active check valve. We also experimentally analyzed variations in the generated flow rate with respect to the pneumatic frequencies, actuated air pressures, and locations of the active check valve. The experimental results indicate the optimum air pressure, driving frequency, and location of the active check valve to be 68.9 kPa, 26.0 Hz, and 2.0 mm, respectively. We obtained a maximum pumping rate of 488 μL/min and a maximum pumping efficiency of 35.4%. The proposed micropump could perform a crucial function in the transportation of microfluids and could be incorporated into micro total analysis systems. [ABSTRACT FROM AUTHOR]

In this study, a valveless pump was successfully designed and fabricated for the purpose of medium transportation. Different from traditional pumps, the newly designed pump utilizes an actuated or a deflected membrane, and it serves as the function of a check valve at the same time. For achieving the valveless property, an inlet or outlet port positioned in an upper- or lower-layer thin membrane was designed to be connected to an entrance or exit channel. Theoretical analysis and numerical simulation were conducted simultaneously to investigate the large deformation characteristics of the membranes and to determine the proper location of the inlet or outlet port on the proposed pump. Then, the valveless pump was fabricated on the basis of the proposed design. In the experiment, the maximum flow rate of the proposed pump exceeded 12.47 mL/min at a driving frequency of 5.0 Hz and driving pressure of 68.95 kPa. [ABSTRACT FROM AUTHOR]

The electrowetting on dielectric (EWOD) technique has considerable potential for microfluidic and biomedical applications. The Lippmann-Young model based on the force balance concept has long been used to predict the contact angles of droplets under electrowetting. However, recent experimental evidence has indicated that this model fails to provide accurate predictions of the lower contact angles associated with saturation conditions at higher electric potentials. Hence, the study simulates the internal flow in an actuated droplet and treats it as stagnation-point flow. This kinetic energy is then taken into consideration while calculating the contact angles using an energy balance model. The energy of an actuated droplet is contributed by the combination of the side surface tension energy, the base tension energy, the dielectric energy, and the kinetic energy when deriving the energy balance model. Consequently, the new energy balance model modifies the Lippmann-Young equation, thereby providing enhanced reasonable predictions of the droplet contact angle across the higher electric potential where the contact angles are close to the saturated condition.