Search

A three-dimensional magnetic probe system has been designed and implemented at the Space Plasma Environment Research Facility (SPERF). This system has been developed to measure the magnetic field with high spatial and temporal resolution, enabling studies of fundamental processes in space physics, such as magnetic reconnection at the Earth's magnetopause, on the basis of SPERF. The system utilizes inductive components as sensors, arranged in an array and soldered onto a printed circuit board (PCB), achieving a spatial resolution of 2.5 mm. The system's electrical parameters have been measured, and its amplitude–frequency response characteristics have been simulated. The system has demonstrated good performance with response capabilities below 50 kHz. The experimental setup and results are discussed, highlighting the system's effectiveness in accurately measuring weak magnetic signals and its suitability for magnetic reconnection experiments. [ABSTRACT FROM AUTHOR]

The magnetic reconnection process relevant to that at the magnetotail is one of the research contents of the Space Plasma Environment Research Facility, which is under construction at the Harbin Institute of Technology in China. Two magnetic mirror sub-coils placed symmetrically in the vertical direction and connected in series cooperate with a dipole coil to generate a magnetic field environment similar to the Earth's magnetotail. A capacitor-based pulsed power supply (PPS) system with a modular design is developed to excite two magnetic mirror sub-coils to generate a magnetic field with a magnetic flux density of not less than 200 G at the center of the two sub-coils. The PPS should deliver a pulsed current with a peak of more than 8 kA, and the duration of the current not be less than 95% of the peak over 5 ms to two magnetic mirror sub-coils when the charging voltage is not less than 20 kV. In addition, the duration from the peak to 10% of the peak is not more than 130 ms. The detailed design of the PPS is discussed in this paper, and a test method is designed to reduce the risk of damage to the wires and the connection between the wires and the coaxial cables of the PPS when the PPS discharges at a higher charging voltage. Finally, the discharge test of the PPS is carried out to verify the design of the PPS. [ABSTRACT FROM AUTHOR]

A steady-state, high-flux N2/Ar helicon wave plasma (HWP) with a small diameter (10 mm) was used to nitride the interior of a slender austenitic stainless steel (ASS) 316L tube at a temperature of 450 °C. N2 and Ar were fed to a 500 mm long slender tube with 10 mm inner diameter and were ionized inside the tube using a helicon wave in the magnetic field of 2000 G. The microstructure and depth of the nitrided layers, in addition to the morphology and hardness of the nitrided surfaces, were intensively characterized by employing scanning electron microscopy (SEM), optical microscopy (OM), X-ray diffraction (XRD), energy dispersive X-ray spectroscopy (EDS), as well as microhardness tests. The results confirmed that the nitrided layer consisted primarily of the expanded austenite phase γN, and neither CrN nor iron nitride precipitates. An increasing trend in microhardness was observed in inductively coupled plasma (ICP) and HWP modes; however, the increase in HWP nitriding (up to HV 1820 with a thickness of 14 μm) was approximately 1.5 times greater than that achieved through ICP plasma nitriding. This was owing to the higher N+ ion density in the HWP mode. Considering the successful control of N2 plasma discharge in a slender tube with a small diameter, this study opens up a new avenue for achieving high-yield nitride layers inside slender tubes. [ABSTRACT FROM AUTHOR]