Search

When compared to the much more common voltage-source inverter (VSI), the current-source inverter (CSI) is rarely used for variable speed drive applications, due to its disadvantages: the need of a constant DC-link current, typically realized with a front-end converter, and the need for reverse-voltage blocking (RVB) devices, typically implemented with in-series diodes. This limits the overall efficiency of the architecture. This paper investigates latest progress of the CSI research, with the aim of demonstrating why CSI could come back in the near future. Different architectures based on modern wide-bandgap (WBG) switches are analyzed, with an emphasis on why CSI can be advantageous compared to VSI. [ABSTRACT FROM AUTHOR]

This paper describes a simple dc-dc step-up converter topology for switch-mode dc power supplies. The proposed configuration is well suited for high-power applications with battery supply. In the automotive framework, the push-pull architecture is the most widespread. However, as power increases, the use of a full-bridge architecture is mandatory. This paper presents a full-bridge architecture where the traditional single-phase transformer is replaced by a three-phase transformer. A prototype was realized and tested for the power supply of automotive devices. In this environment, one of the most important requirements is the ability to provide a burst of power during short-duration events, together with high-efficiency and high-quality output voltage. The latter constraints can be achieved by only using closed-loop switch-mode dc-dc converters at high switching frequency, thus reducing converter efficiency and creating electromagnetic-compatibility (EMC) problems. In this paper, the aforementioned issues were tackled relying on an open-loop topology. Open-loop converters are feasible if the output resistance of the converter is as low as possible, and a possible solution is the minimization of power losses. The solution is the use of a three-phase transformer with a delta-wye connection within a full-bridge converter topology. The configuration will be referred to as 3boost power supply. The three-phase transformer replaces the common single-phase transformer, and it is driven by a three-phase full-bridge inverter operating in six-step modulation. At secondary, a three-phase full wave diode rectifier is used to obtain the output dc voltage level. Therefore, a unitary transformer utilization factor is achieved. A simple theoretical comparison between the three types of converters--push-pull, conventional full bridge, and 3boost is shown. A low-power version of the converter was realized. Experiments confirm that this topology allows to achieve a high efficiency, a lower ripple factor, and a good EMC behavior. Index Terms--DC-DC power conversion, pulsewidth-modulated power converters.