Search

Introduction: Hemadsorption with new sorbent cartridges is an emerging extracorporeal blood purification technique. Flow distribution inside the sorbent is one of the main issues concerning the device's performance and optimal sorbent utilization. In this experiment, we aimed to investigate the efficacy of vibration during adsorption by measuring the removal of vancomycin. Methods: In this experimental study, 1,000 mL of saline with 10 g of vancomycin was circulated in a closed circuit (set flow of 250 mL/min) simulating a hemadsorption blood run using HA380 minimodule cartridge containing 75 g of wet resin. This vibration model was implemented with a damping head device installed in front of the adsorption cartridge during the experiment. The kinetics of the vancomycin were assessed by removal ratio over 120 min. Results: We found no difference between the two models. Adsorption with and without vibration did not differ significantly for partial reduction ratios, overall amount of adsorbed molecule, or adsorption kinetics. Conclusion: The current design and structure of the minimodule cartridge demonstrated no difference in small-middle solute removal. Further improvement with the addition of mechanical vibration to the device was not observed. [ABSTRACT FROM AUTHOR]

Background: The level of bacteremia in patients with sepsis and septic shock is a predictor of complications and mortality, regardless of the type of bacteria. Devices for bacteria, endotoxin and cytokines removal by adsorption have been recently developed. Thus, extracorporeal blood purification therapies have been proposed as adjunctive therapy in sepsis in combination with drugs. Some potentially useful drugs, however, are precluded due to their organ or metabolic toxicity. The present study represents a preliminary report on the in vitro effect of a sorbent device (minimodule with HA380 beads, Jafron medical, Zhuhai, China) in which the particles have been functionalized with vancomycin on the surface. The impact of the surface‐modified beads on circulating bacteria (Staphylococcus aureus) has been tested in a simulated in vitro circulation. Methods: In vitro experiments were carried out with 800 mL of blood enriched with S. aureus species. Blood was circulated in the vancomycin‐functionalized and non‐functionalized mini‐module cartridges in hemoadsorption setup (300 mL each) and the bactericidal effect was assessed. Also, 200 mL of blood was used as a control. Results: A significant increase in the time to positivity of blood cultures was observed after 60 min and also after 120 min of therapy with the mini‐module functionalized with vancomycin as opposed to the non‐functionalized cartridge. Conclusions: These results suggest a possible way of treating sepsis by using drug‐ or antibiotic‐functionalized cartridges without worrying about pharmacological toxicity. The prolongation of the time to bacterial culture positivity to S. aureus after a passage through a column packed with beads functionalized with vancomycin represents a proof of concept. [ABSTRACT FROM AUTHOR]

In order to develop a standardized nomenclature for the mechanisms and materials utilized during extracorporeal blood purification, a consensus expert conference was convened in November 2022. Standardized nomenclature serves as a common language for reporting research findings, new device development, and education. It is also critically important to support patient safety, allow comparisons between techniques, materials, and devices, and be essential for defining and naming innovative technologies and classifying devices for regulatory approval. The multidisciplinary conference developed detailed descriptions of the performance characteristics of devices (membranes, filters, and sorbents), solute and fluid transport mechanisms, flow parameters, and methods of treatment evaluation. In addition, nomenclature for adsorptive blood purification techniques was proposed. This report summarizes these activities and highlights the need for standardization of nomenclature in the future to harmonize research, education, and innovation in extracorporeal blood purification therapies. [ABSTRACT FROM AUTHOR]

Introduction: Per- and polyfluoroalkyl substances (PFAS) are known water pollutants leading to potential public health consequences. High blood levels of PFAS have been associated with several pathological conditions including testicular and kidney cancer. Classic extracorporeal therapies have demonstrated limited efficiency, and new approaches should be explored. In this study, we studied the possible role of hemoadsorption to achieve a fast, safe, and effective removal of PFAS from blood in patients with high blood levels. Methods: We developed an in vitro model of hemoadsorption to test the potential of PFAS removal by extracorporeal treatment. We recirculated a highly polluted batch of water (4 L) through a sorbent cartridge (Jafron Medical, Zhuhai, China) for 120 min at a flow of 150 mL/min. We collected samples at different time points and analyzed 39 different PFAS compounds. Results: For the PFAS compounds with concentrations significantly above normal, we observed a removal ratio close to 90% already within the first 60 min of circulation leading to almost complete elimination of all pollutants at 120 min. Conclusions: The in vitro model of hemoadsorption suggests the possible application in vivo of this technique to reduce/normalize the concentrations of PFAS in patients exposed to water or environmental pollution. [ABSTRACT FROM AUTHOR]

Background The CARdiorenal PEDIatric EMergency (CARPEDIEM) machine was originally designed to perform only continuous venovenous hemofiltration (CVVH) in neonatal and pediatric patients. In some cases, adequate convective clearance may not be reached because of a limited blood flow. In such conditions, the application of diffusive clearance [continuous venovenous hemodialysis (CVVHD)] would help optimize blood purification. In this study, the CARPEDIEM™ machine was modified to enable the circulation of dialysis through the filter allowing testing of the performance of CARPEDIEM™ machine in CVVHD. Methods Three different polyethersulfone hemodialyzers (surface area = 0.1 m.sup.2, 0.2 m.sup.2, and 0.35 m.sup.2, respectively) were tested in vitro with a scheduled combination of plasma flow rates (Qp = 10-20-30 ml/min) and dialysis fluid flow rate (Qd = 5-10-15 ml/min). Three sessions were performed in co-current and one in counter-current configuration (as control) for each filter size. Clearance was measured from the blood and dialysate sides and results with mass balance error greater than 5 % were discarded. Results Urea and creatinine clearances for each plasma/dialysate combination are reported: clearance increase progressively for every filter proportionally to plasma flow rates. Similarly, clearances increase progressively with dialysate flow rates at a given plasma flow. The clearance curve tends to present a steep increase for small increases in plasma flow in the range below 10 ml/min, while the curve tends to plateau for values averaging 30 ml/min. As expected, the plateau is reached earlier with the smaller filter showing the effect of membrane surface-area limitation. At every plasma flow, the effect of dialysate flow increase is evident and well defined, showing that saturation of effluent was not achieved completely in any of the experimental conditions explored. No differences (p > 0.05 for all values) were obtained in experiments using whole blood instead of plasma or using co-current versus counter-current dialysate flow configuration. Conclusions Although plasma flow and filter surface give an important contribution to the level of clearance urea and creatinine, it appears evident that dialysate flow plays an essential role in the blood purification process, justifying the use of CVVHD versus CVVH in case of high dialysis dose requirement and/or limited blood flow rate., Author(s): Anna Lorenzin[sup.1] , Francesco Garzotto[sup.1] , Alberta Alghisi[sup.2] , Mauro Neri[sup.1] , Dario Galeano[sup.1] , Stefania Aresu[sup.3] , Antonello Pani[sup.3] , Enrico Vidal[sup.4] , Zaccaroa Ricci[sup.5] , Luisa Murer[sup.4] [...]

Background: Extracorporeal removal of bilirubin in patients with severe liver dysfunction is a key blood purification strategy. We conducted an ex vivo study to assess the quantitative capacity to remove bilirubin from plasma of a novel adsorptive cartridge. Methods: We studied a downscaled module of the BS330 Plasma Bilirubin Adsorption Column Cartridge (Jafron Biomedical, Zhuhai City, China) to minimize the plasma requirement in an ex vivo circulation using a solution of hyperbilirubinemic plasma. We measured the bilirubin concentration gap (ΔC) between inlet (Cpin) and outlet (Cpout) of the unit and we calculated the removal ratio (RR) as mass adsorbed at different time points. Moreover, we compared the ex vivo model with the bilirubin adsorption kinetics in a patient with acute on chronic liver failure treated with the BS330 cartridge. Results: Bilirubin concentration change across the cartridge at 30 min was 16.5%, and cartridge saturation was reached at 750 min. We used a minimodule downscaled to 1:3 and containing approximately 131 g of BS330 sorbent beads: the device retained 759 mg of bilirubin with a RR of 78.1% and a RR of 42.6% at 120 min. Thus, the adsorption capacity was 5.76 mg of bilirubin per gram of sorbent. Bilirubin adsorption kinetics in our clinical case with a full-scale unit shows a coherent trend with a total bilirubin mass adsorbed after 180 min of 470 mg. Discussion: Our findings provide the first assessment of bilirubin adsorption in an ex vivo model of plasma perfusion and can be used to design interventional studies in humans, providing guidance for an adequate prescription of treatment frequency and duration. [ABSTRACT FROM AUTHOR]

Introduction: Sepsis is a frequent complication in critically ill patients. Patients may require control of the source of infection, removal of pathogens and damaged cells, and organ support. Often, these targets can be achieved through the utilization of extracorporeal therapies including hemoperfusion for the adsorption of cytokines and other circulating mediators. On extracorporeal organ support, patients are generally treated with antibiotic therapy, and vancomycin is one of the most commonly used antibiotics. Because of the aspecific nature of adsorption, antibiotics can be removed from the circulation, leading to altered plasma levels and requiring prescription adjustment. The aim was to define the amount of vancomycin adsorbed by a sorbent cartridge (HA380, Jafron, China) during hemoperfusion and to establish possible strategies to maintain an effective plasma level in critically ill patients undergoing extracorporeal therapies. Methods: In vitro experiments with incremental concentrations of vancomycin in the test solution (500 and 1,000 mL) were carried out in a recirculation circuit until sorbent saturation was observed. A maximum of 10 g of vancomycin were injected and mini-modules containing 25 g of dry resin were utilized. Results: In different experiments with various concentration of vancomycin, a maximum amount of 244 mg/g of sorbent was adsorbed reaching saturation between 60 and 80 min from the beginning of the experiments. The kinetics of adsorption appears to be governed by a Langmuir-like isotherm with maximal removal speed in the early minutes and a plateau after 60 min. Discussion/Conclusion: HA380 adsorbs significant amounts of vancomycin. Adjusting the achieved results with the experimental mini-module to a full-scale cartridge, a total of 25 g of antibiotic can be removed. This might have affected outcome results in clinical trials. This suggests prescribing administration to critically ill patients requiring hemoperfusion, immediately after or in the inter-session time window. In case of administration during hemoperfusion, adequate adjustment and plasma level monitoring is strongly recommended. [ABSTRACT FROM AUTHOR]

Introduction: At the time of renal replacement therapy, approximately 20% of critically ill patients have septic shock. In this study, medium cutoff (MCO) continuous venovenous hemodialysis (CVVHD) was compared to high-flux membrane continuous venovenous hemodiafiltration (CVVHDF) in terms of hemodynamic improvement, efficiency, middle molecule removal, and inflammatory system activation. Methods: This is a monocenter crossover randomized study. Between December 31, 2017, and December 31, 2019, 20 patients with septic shock and stage 3 acute kidney injury (AKI) admitted to 2 Italian ICUs were enrolled. All patients underwent CVVHD with Ultraflux® EMiC®2 and CVVHDF with AV1000S® without washout. Each treatment lasted 24 h. Results: Compared to AV1000S®-CVVHDF, EMIC®2-CVVHD normalized cardiac index (β = −0.64; p = 0.02) and heart rate (β = 5.72; p = 0.01). Interleukin-8 and myeloperoxidase removal were greater with AV1000S®-CVVHDF than with EMiC®2-CVVHD (β = 0.35; p < 0.001; β = 0.43; p = 0.03, respectively). Leukocytosis improved over 24 h in EMiC®2-CVVHD-treated patients (β = 4.13; p = 0.03), whereas procalcitonin levels decreased regardless of the modality (β = 0.89; p = 0.01) over a 48-h treatment period. Reduction rates, instantaneous plasmatic clearance of urea, creatinine, and β2-microglobulin were similar across modalities. β2-Microglobulin removal efficacy was greater in the EMiC®2 group (β = 0–2.88; p = 0.002), while albumin levels did not differ. Albumin was undetectable in the effluent in both treatments. Discussion: In patients with septic shock and severe AKI, the efficacy of uremic toxin removal was comparable between MCO-CVVHD and CVVHDF. Further, MCO-CVVHD was associated with improved hemodynamics. Fraction of filtration and transmembrane pressure reduction and the maintenance of equal efficacy might be the key features of CVVHD with MCO membranes in critically ill patients. [ABSTRACT FROM AUTHOR]

Introduction: Medium cutoff (MCO) membranes represent an interesting innovation in the field of hemodialysis. Given the correlation between large (PM >25 kDa) middle molecules (LMM) and clinical outcomes, the possibility to broaden the spectrum of solutes removed in hemodialysis with MCO membranes introduces a new perspective for end-stage kidney disease patients. Due to low diffusion coefficients of LMM, the use of convection is required to maximize extracorporeal clearance. High convective rates are achieved with high-flux membranes in hemodiafiltration, a technique not available in the US. In case of the MCO membrane, remarkable clearances of LMM are achieved combining the permeability of the membrane with a significant amount of internal convection. The mechanism of filtration-backfiltration inside the dialyzer enables effective removal of LMM in a technique called expanded hemodialysis (HDx). Given such theoretical explanation, it is important to demonstrate the blood and ultrafiltration rheology inside the MCO dialyzer. Method: This study for the first time describes flow dynamic parameters and internal cross-filtration, thanks to specific radiology and nuclear imaging techniques. Results: Flow dynamic analysis of the blood and dialysate compartment confirms excellent distribution of velocities and an excellent matching of blood and dialysate. Average blood flow velocity allows for wall shear rates adequate to avoid protein stagnation at the blood membrane interface and increase in blood viscosity. Cross-filtration analysis demonstrates a remarkable filtration/backfiltration flux reaching values >30 mL/min at a blood flow of 300 mL/min and zero net filtration. Conclusion: The MCO dialyzer Theranova 400 appears to have a design optimized to perform expanded hemodialysis (HDx). [ABSTRACT FROM AUTHOR]