Search

Two-dimensional materials are characterised by a number of unique physical properties which can potentially make them useful to a wide diversity of applications. In particular, the large thermal conductivity of graphene and hexagonal boron nitride has already been acknowledged and these materials have been suggested as novel core materials for thermal management in electronics. However, it was not clear if mass produced flakes of hexagonal boron nitride would allow one to achieve an industrially-relevant value of thermal conductivity. Here we demonstrate that laminates of hexagonal boron nitride exhibit thermal conductivity of up to 20 W/mK, which is significantly larger than that currently used in thermal management. We also show that the thermal conductivity of laminates increases with the increasing volumetric mass density, which creates a way of fine-tuning its thermal properties., Comment: 6 pages, 4 figures

The deformation of monolayer graphene, produced by chemical vapor deposition (CVD), on a polyester film substrate has been investigated through the use of Raman spectroscopy. It has been found that the microstructure of the CVD graphene consists of a hexagonal array of islands of flat monolayer graphene separated by wrinkled material. During deformation, it was found that the rate of shift of the Raman 2D band wavenumber per unit strain was less than 25% of that of flat flakes of mechanically-exfoliated graphene, whereas the rate of band broadening per unit strain was about 75% of that of the exfoliated material. This unusual deformation behavior has been modeled in terms of mechanically-isolated graphene islands separated by the graphene wrinkles, with the strain distribution in each graphene island determined using shear lag analysis. The effect of the size and position of the Raman laser beam spot has also been incorporated in the model. The predictions fit well with the behavior observed experimentally for the Raman band shifts and broadening of the wrinkled CVD graphene. The effect of wrinkles upon the efficiency of graphene to reinforce nanocomposites is also discussed., Comment: ACS Nano (2015)

We demonstrated that chemical vapor deposition of graphene on Cu films strongly enhances their thermal diffusivity and thermal conductivity. Deposition of graphene increases the thermal conductivity of 9 micrometer (25 micrometer) thick Cu films by up to 24% (16%) near room temperature. Interestingly, the observed improvement of thermal properties of graphene coated Cu films is primarily due to changes in Cu morphology during graphene deposition and associated with it temperature treatment rather than graphene's action as an additional heat conducting channel. Enhancement of thermal properties of metal films via graphene coating may lead to applications in electronic circuits and metallurgy., Comment: 16 pages, 3 figures