Search

Solid-contact Pb2+-selective-electrodes and solid contact reference electrodes suitable for use as disposable sensing devices for environmental monitoring of lead have been prepared on screen-printed substrates. Accurate control over the fabrication procedures leads to excellent reproducibility of their calibration characteristics such as slope, offset and limit of detection. In particular, the limit of detection in the nanomolar range opens the possibility of their use for trace analysis of Pb2+ in environmental water samples. Significantly, the potentiometric measurements correlate well with data determined using inductively coupled plasma mass spectrometry (ICP-MS) in a number of real samples taken from local rivers. Ways in which these sensors might be employed in autonomous platforms for monitoring water quality in-situ are discussed. The possibility of including arrays of virtually identical sensors is highlighted as a possible route to achieve long-term deployments.

In this paper, we describe a new type of polymer membrane-based reference electrode (RE) based on ionic liquids (ILs), in both liquid-contact (LCRE) and solid-contact reference electrode (SCRE) forms. The ILs used were bis(trifluoromethane sulfonyl)amid with 1-alkyl-3methyimidazolium as well as phosphonium and ammonium cations. In addition to their charge stabilisation role, it was found that the ILs also functioned as effective plasticizers in the PVC matrix. The LCREs and SCREs were prepared using the same design as their corresponding indicator electrodes. LCREs were prepared by casting in glass rings while SCREs were prepared on platforms made using screen-printing technology, with poly(3-octylthiophene-2,5 diyl) (POT) as the intermediate polymer. After potentiometric characterization of the response mechanism, the practical performance of the REs was studied using potentiometric titrations (Pb2+ and pH), and characterised using cyclic voltammetry and impedance spectroscopy. All results were compared via parallel experiments in which the novel RE was substituted by a conventional double junction Ag/AgCl reference electrode. The mechanism of response is most likely based on a limited degree of partitioning of IL ions into the sample thereby defining aquo-membrane interfacial potential. Despite their simple nature and construction, the REs showed excellent signal stability, and performed well in the analytical experiments. The identical mode of fabrication to that of the equivalent indicator (or Ion-Selective) electrode (ISE) will facilitate mass-production of both indicator and reference electrode using the same fabrication line, the only difference being the final capping membrane composition.

There have been considerable developments in the field of potentiometric sensors in recent years mainly with respect to lowering detection limits and making sensors smaller, solid-state, robust and less expensive.[1, 2] In potentiometric measurements two electrodes are needed, an indicator or ion-selective electrode (ISE) and a reference electrode. However, recent progress in the design and characteristics of the indicator electrodes cannot be exploited without similar progress in the design of the reference electrodes. In this paper we present development of chips with fully integrated solid-contact reference (SC-RE) and ion-selective (SC-ISEs) electrodes. In these electrodes, a conducting polymer (CP) (poly(3,4-ethylenedioxythiophene)) is used as the solid contact ion-to-electron transducer[3]. The conducting polymer is deposited using galvanostatic electropolymerization.[4, 5] The ability to produce reliable miniaturized reference electrodes, has given us the opportunity to develop several prototype versions of miniature, solid-contact sensor systems (i.e. with fully integrated ion-selective and reference electrodes) that can be further integrated into microfluidic platforms. We have prepared microchips using different designs to test for the best accommodation of the sensors and to optimise the sensor-chip platform characteristics. Our initial goal is to prepare Pb-ISEs suitable for use as a chemo-sensing component in a widely distributed wireless sensor network (WSN) for monitoring the quality of a fresh water system, together with advanced diagnostics to evaluate the on-going functionality of the sensors using simple electronic signals.[5, 6]