Search

Road dust carries various contaminants and causes urban non-point source pollution in waterbodies through runoff. Road dust samples were collected in each month in two years and then sieved into five particle size fractions. The concentrations of ten heavy metals (As, Cd, Cr, Cu, Hg, Mn, Ni, Pb, Zn, Fe) in each fraction were measured. The particle size fraction load index, coefficient of divergence, and Nemerow integrated risk index were used to analyze the temporal variation of pollution load and ecological risk in different particle size fractions. The advanced three-way model and wavelet analysis were used in quantitative identification and time-series analysis of sources. Results showed that both the pollution load and ecological risk of most heavy metals showed a decreasing trend from the finest fraction (P1) to the coarsest fraction (P5). The frequency of heavy metals in P1 posing extreme risk was about two times that of P5. Main types of heavy metal sources were similar among different fractions, whereas the impact intensity of these sources varied among different fractions. Traffic exhaust tended to accumulate in finer particles, and its contribution to Cu in P5 was only 35–55% of that in other fractions. Construction contributed more to coarser particles, and its contribution to Pb was increased from 45.34% in P1 to 65.35% in P5. Wavelet analysis indicated that traffic exhaust showed periodicities of 5–8 and 10–13 months. Fuel combustion displayed the strongest periodicity of 12–15 months, peaking in winter. [ABSTRACT FROM AUTHOR]

Tire wear particles (TWPs) in stormwater runoff have been widely detected and were generally classified into microplastics (MPs). TWPs and conventional MPs can be intercepted and accumulated in stormwater filtration systems, but their impacts on filtration, adsorption and microbial degradation processes of conventional pollutants (organic matters, nitrate and ammonium) have not been clarified. TWPs are different from MPs in surface feature, chemical components, adsorption ability and leaching of additives, which might lead to their different impacts on conventional pollutants removal. In this study, five different levels of aged polyethylene MPs (PEMPs) and aged TWPs contamination in stormwater filtration systems were simulated using thirty-three filtration columns. Results showed that ultraviolet aging treatment was less influential for the aging of TWPs than that of PEMPs, the specific surface area of aged PEMPs (1.603 m2/g) was over two times of unaged TWPs (0.728 m2/g) in the same size. Aged PEMPs and aged TWPs had different impacts on conventional pollutants removal performance and microbial communities, and the difference might be enlarged with exposure duration. The intensified aged PEMPs contamination generally promoted conventional pollutants removal, whereas aged TWPs showed an opposite trend. Mild contamination (0.01% and 0.1%, wt%) of aged PEMP/TWPs was beneficial to the richness and diversity of microbial communities, whereas higher contamination of aged PEMPs/TWPs was harmful. Aged PEMPs and TWPs had different impact on microbial community structure. Overall, the study found that TWPs were more detrimental than PEMPs in filtration systems. The research underscores the need for more comprehensive investigation into the occurrence, effects and management strategies of TWPs, as well as the importance of distinguishing between TWPs and MPs in future studies. [Display omitted] • Temporally, COD and NO 3 −–N removal rate showed an "increase-decrease-increase" trend. • Aged PEMPs pollution increased removal performance, TWPs showed adverse impacts. • Opposite to TWPs, the intensified PEMPs pollution was beneficial to Actinobacteria. • TWPs were more harmful than PEMPs for stormwater filtration systems. [ABSTRACT FROM AUTHOR]