Search

The present article reports the heat transfer characteristics of a vertical stainless steel foil of 0.15 mm thickness (SS304) by circular impinging jets of various fluids such as pure water, nano-fluids (Al2O3-water, ф = 0.15%, 0.6%), and aqueous high-alcohol surfactant (HAS, i.e., 2-ethyl-hexanol, 100-400 ppm) studied using an infrared thermal imaging camera (A655sc, FLIR System). The enhancement in the heat transfer rates for Al2O3-water nano-fluids with ф = 0.15%, ф = 0.60%, and aqueous surfactant solution (150ppm) is found to be 140%, 207%, and 117% higher compared to pure water results, respectively. The surface characteristics of the foil after jet impingement by various fluids are also studied using scanning electron microscopy (SEM), energy dispersive spectrometer (EDS), and surface wettability. [ABSTRACT FROM AUTHOR]

In the present study, an experimental investigation has been carried out to analyze the heat transfer characteristics of CuO-water nanofluids jet on a hot surface. A rectangular stainless steel foil (AISI-304, 0.15 mm thick) used as the test surface is electrically heated to obtain the required initial temperature (500 °C). The distribution of surface heat flux on the target surface is evaluated from the recorded thermal images during transient cooling. The effect of nanoparticle concentration and Reynolds number of the nanofluids on the heat transfer characteristics is studied. Tests are performed for varied range of Reynolds number (5000 ≤ Re ≤ 12,000), two different CuO-water nanofluids concentration (Φ = 0.15%, 0.6%) and two different nozzle to plate distance (l/d = 6, 12). The enhancement in Nusselt number for CuO-water nanofluids was found to be 14% and 90%, for nanofluids concentration of Φ = 0.15% and Φ = 0.60%, respectively, compared to pure water. The test surface characteristics after nanofluids jet impingement are studied using scanning electron microscope (SEM). Based on the investigation, a correlation among various parameters, namely, Reynolds number (Re), Prandtl number (Pr), nozzle to plate distance (l/d), and Nusselt number (Nu), is presented. [ABSTRACT FROM AUTHOR]