Search

High-efficiency rock breaking technology is an important problem to be solved urgently in deep mining. The existing auxiliary rock breaking technology for coal mine excavation has problems such as polluting coal, high requirements for tool materials, and difficulty in subsequent washing. In this paper, an active excitation cutting system for rotary cylinder of cantilever roadheader based on alternating valve is proposed. According to the classical calculation formula of cutting load of roadheader, considering the stiffness-damping characteristics of cutting part and cutting cylinder, the simulation algorithm of cutting load is compiled based on MATLAB simulation analysis software. The excitation cutting experiments of different cutting depths are carried out on the cutting test bench, and compared with the simulation algorithm of cutting load. Taking the cutting load as the discriminant index, the influence of oil supply pressure and excitation frequency of rotary cylinder on the cutting load is analyzed based on the simulation algorithm of cutting load. The results show that the error between the simulation results and the experimental results of the active excitation state is less than 12%, and the two are in good agreement. Under the condition of 30 HZ, when the excitation amplitude is 8 Mpa, 10 Mpa, 12 Mpa, 14 Mpa, when the rotary cylinder excitation amplitude is 10 Mpa, the minimum is 131.42 KN. Compared with the rotary cylinder excitation amplitude under the condition of 10 Mpa, when the excitation frequency is 30 HZ, 35 HZ, 40 HZ, 45 HZ, when the excitation frequency is 40 HZ, the minimum is 83.08 KN, indicating that changing the excitation amplitude or oil supply pressure of the rotary cylinder is helpful to adjust the cutting performance. [ABSTRACT FROM AUTHOR]

A new type of parallel operation unit for excavating and supporting anchors is proposed to address the issue of imbalanced excavation anchor ratio in coal mines. By equipping a straddle type anchoring drilling rig group, the synchronous parallel and fast operation mode for excavating and supporting anchors is achieved; Consider the problem of poor drilling stability of drill pipes in coal mines due to the coupling vibration between surrounding rock and anchoring equipment. Firstly, taking the multi drilling rig anchoring system as the research object, considering the influence of the equipment itself as an influencing factor on the vibration of the drill pipe, a dynamic model of the system is constructed using Lagrangian equations, and analytical solutions for the vibration displacement of each mass block are obtained; In order to more intuitively represent the vibration process of the drill pipe, Ansys is used to conduct modal analysis on the key components of the anchoring drilling rig system, and obtain the natural frequencies and vibration modes of each order of the key components; Using Adams to solve the rigid flexible coupling dynamic model of the anchoring drilling rig system, the vibration response laws of the drill pipe under different operating states were obtained. Secondly, Abaqus was used to simulate the drilling process of the drill pipe and obtain the vibration response law generated by the interaction between the drill pipe and the surrounding rock; The results indicate that the anchoring equipment has a greater impact on the vibration of the drill pipe, and the surrounding rock has a more stable impact on the vibration of the drill pipe. Due to the short body and large span structure of the anchoring system crossbeam expansion frame, the vibration response of the drill pipe is significantly greater than that of the retracted state of the drilling rig due to being in an unstable cantilever state when the drilling rig is extended. The theoretical reliability of the vibration response law of the drill pipe under different states has been further verified through drilling experiments of the anchoring system prototype. The relevant theories can provide a theoretical basis for the implementation of automatic anchoring technology in the anchoring system. [ABSTRACT FROM AUTHOR]