Search

Calcium phosphates (CaPs) composites with silver nanoparticles (AgNPs) attract attention as a possible alternative to conventional approaches to combating orthopedic implant-associated infections. Although precipitation of calcium phosphates at room temperatures was pointed out as an advantageous method for the preparation of various CaP-based biomaterials, to the best of our knowledge, no such study exists for the preparation of CaPs/AgNP composites. Motivated by this lack of data in this study we investigated the influence of AgNPs stabilized with citrate (cit-AgNPs), poly(vinylpyrrolidone) (PVP-AgNPs), and sodium bis(2-ethylhexyl) sulfosuccinate (AOT-AgNPs) in the concentration range 5–25 mg dm−3 on the precipitation of CaPs. The first solid phase to precipitate in the investigated precipitation system was amorphous calcium phosphate (ACP). The effect of AgNPs on ACP stability was significant only in the presence of the highest concentration of AOT-AgNPs. However, in all precipitation systems containing AgNPs, the morphology of ACP was affected, as gel-like precipitates formed in addition to the typical chain-like aggregates of spherical particles. The exact effect depended on the type of AgNPs. After 60 min of reaction time, a mixture of calcium-deficient hydroxyapatite (CaDHA) and a smaller amount of octacalcium phosphate (OCP) formed. PXRD and EPR data point out that the amount of formed OCP decreases with increasing AgNPs concentration. The obtained results showed that AgNPs can modify the precipitation of CaPs and that CaPs properties can be fine-tuned by the choice of stabilizing agent. Furthermore, it was shown that precipitation can be used as a simple and fast method for CaP/AgNPs composites preparation which is of special interest for biomaterials preparation.

Administration of cytotoxic agents like doxorubicin (DOX) is restrained by the effects on different non-targeted/non-cancerous tissues, which instigates the development of nano-enabled drug delivery systems, among others. In this study, imaging mass spectrometry (IMS) was selected to examine the effects of DOX nanoformulations on non-targeted tissues. Chemical alterations induced by liposomal (LPS) and poly (lactic-co-glycolic acid) (PLG) nanoformulations were assessed against the ones induced by the conventional (CNV) formulation. Kidney cryosections of the treated and control Wistar rats were used as a model of the non-targeted tissue and analyzed by MALDI TOF IMS in the 200- 1000 Da m/z range. Principal component analysis (PCA) and Volcano plots of the average mass spectra demonstrated a large overlap between treatments. However, the Venn diagram of significant m/z values revealed a nanoformulation- specific fingerprint consisting of 59 m/z values, which set them apart from the CNV formulation characterized by the fingerprint of 22 significant m/z values. Fingerprint m/z values that were putatively annotated by metabolome database search were linked to apoptosis, cell migration and proliferation. In CNV and PLG cases, false discovery rate adjusted ANOVA showed no differences in the spatial distribution of fingerprint m/z values between the histological substructures like glomeruli and convoluted tubules indicating their tissue-nonselective effect. LPS caused the least significant changes in m/z values and some of the LPS-specific fingerprint m/z values were primarily distributed in the glomeruli. The IMS based procedure successfully differentiated the effects of DOX formulations on the model non-targeted tissue, thus indicating the importance of IMS in effective drug development.

Olive pomace extract (OPE) was investigated as a potential surface modifier for the development of the green synthesis process of selenium nanoparticles (SeNPs). In order to evaluate them as potential nutraceuticals, the obtained nanosystems were characterized in terms of size distribution, shape, zeta potential, stability in different media, gastrointestinal bioaccessibility and biocompatibility. Systems with a unimodal size distribution of spherical particles were obtained, with average diameters ranging from 53.3 nm to 181.7 nm, depending on the type of coating agent used and the presence of OPE in the reaction mixture. The nanosystems were significantly affected by the gastrointestinal conditions. Bioaccessibility ranged from 33.57% to 56.93% and it was significantly increased by functionalization of with OPE. Biocompatibility was investigated in the HepG2 and Caco2 cell models, proving that they had significantly lower toxicity in comparison to sodium selenite. Significant differences were observed in cellular responses depending on the type of cells used, indicating differences in the mechanisms of toxicity induced by SeNPs. The obtained results provide new insight into the possibilities for the utilization of valuable food-waste extracts in the sustainable development of nanonutraceuticals.

The accurate determination of events at the interface between a biological system and nanomaterials is necessary for efficacy and safety evaluation of novel nano-enabled medical products. Investigating the interaction of proteins with nanoparticles (NPs) and the formation of protein corona on nanosurfaces is particularly challenging from the methodological point of view due to the multiparametric complexity of such interactions. This study demonstrated the application of localized surface plasmon resonance (LSPR) spectroscopy as a low-cost and rapid biosensing technique that can be used in parallel with other sophisticated methods to monitor nano–bio interplay. Interaction of citrate-coated gold NPs (AuNPs) with human plasma proteins was selected as a case study to evaluate the applicability and value of scientific data acquired by LSPR as compared to fluorescence spectroscopy, which is one of the most used techniques to study NP interaction with biomolecules. LSPR results obtained for interaction of AuNPs with bovine serum albumin, glycosylated human transferrin, and non-glycosylated recombinant human transferrin correlated nicely with the adsorption constants obtained by fluorescence spectroscopy. This ability, complemented by its fast operation and reliability, makes the LSPR methodology an attractive option for the investigation of a nano– bio interface.

International audience; Background: Silver nanoparticles (AgNP) are one of the most commercialized types of nanomaterials, with a wide range of applications owing to their antimicrobial activity. They are particularly important in hospitals and other healthcare settings, where they are used to maintain sterility of surfaces, textiles, catheters, medical implants, and more. However, AgNP can not only harm bacteria, but also damage mammalian cells and tissue. While the potential toxicity of AgNP is an understood risk, there is a lack of data on their toxicity in combination with polymeric materials, especially plastic nanoparticles such as polystyrene nanoparticles (PSNP) that can be released from surfaces of polystyrene devices during their medical use. Aim: This study aimed to investigate combined effect of AgNP and nanoplastics on human immune response. Methods: Cells were treated with a range of PSNP and AgNP concentrations, either applied alone or in combination. Cytotoxicity, induction of apoptosis, generation of oxidative stress, uptake efficiency, intracellular localization and nanomechanical cell properties were selected as exposure biomarkers. Results: Collected experimental data showed that nanomixture induced oxidative stress, apoptosis and mortality of Jurkat cells stronger than its individual components. Cell treatment with AgNP/PSNP mixture also significantly changed cell mechanical properties, evidenced by reduction of cells' Young Modulus. Conclusion: AgNP and PSNP showed additive toxic effects on immortalized human lymphocytes, evidenced by increase in cellular oxidative stress, induction of apoptosis, and reduction of cell stiffness. These results have important implications for using AgNP and PSNP in medical contexts, particularly for long-term medical implants.

The current “gold standard” therapy is levodopa (L-DOPA) due to its effectiveness and ability to permeate the blood-brain barrier (BBB). However, long-term treatment with L-DOPA can lead to serious side effects and increase oxidative stress, thereby worsening the disease [2]. The oxidative stress caused by either L-dopa or dopamine could be lessened by the combination of antioxidants – one that promises is selenium (Se) – an essential trace element that can protect from oxidative damage through selenoproteins [3]. Direct use of Se as an antioxidant supplement is toxic due to a narrow therapeutic index, so Se should be applied in other therapeutical forms. The use of Se in the form of nanoparticles (SeNPs) may elicit the same beneficial effects with reduced toxicity [4]. This study tested the safety of SeNPs as L-DOPA carrier using differentiated neuroblastoma (SH- SY5Y) cells as in vitro model of Parkinson`s disease [5]. SeNPs were prepared via reduction of sodium selenite by L-ascorbic acid and functionalization by polysorbate 20 (SeTWEEN) and poly(vinylpyrrolidone) (SePVP). The shape, size, and surface charge of SeNPs were determined with transmission electron microscopy (TEM), dynamic light scattering (DLS), and zeta potential measurements, respectively. Cell viability and apoptosis induction test were performed using flow cytometry, while oxidative stress was determined by measuring the concentration od reactive oxygen species, glutathione (GSH) and mitochondrial membrane potential. In all experiments L-DOPA loaded SeNPs were compared with SeNPs and L-DOPA alone. L- DOPA loaded SeNPs (1ppm) were non-toxic to differentiated SH-SY5Y cells after 24-hour treatment, while L-DOPA reduced cell viability at the 100 μM, but not at 50 μM concentration. L-DOPA induced oxidative stress at the concentration of 100 µM which was effectively reduced after combining with SeNPs (1 ppm). Results suggest that SeNPs could be a promising approach for the reduction of toxicity caused by L-DOPA.

Gold nanoparticles (AuNPs) have found applications in biomedicine as diagnostic tools, but extensive research efforts have been also directed toward their development as more efficient drug delivery agents. The high specific surface area of AuNPs may provide dense loading of molecules like catechols (L-DOPA and dopamine) on nanosurfaces, enabling functionalization strategies for advancing conventional therapy and diagnostic approaches of neurodegenerative diseases. Despite numerous well-described procedures in the literature for preparation of different AuNPs, possible transformation and structural changes of surface functionalization agents have not been considered thoroughly. As a case in point, the catechols L-DOPA and dopamine were selected because of their susceptibility to oxidation, cyclization, and polymerization. To assess the fate of coating and functionalization agents during the preparation of AuNPs or interaction at the nano-bio interface, a combination of spectroscopy, light scattering, and microscopy techniques was used while structural information and reaction mechanism were obtained by NMR in combination with computational tools. The results revealed that the final form of catechol on the AuNP nanosurface depends on the molar ratio of Au used for AuNP preparation. A large molar excess of L-DOPA or dopamine is needed to prepare AuNPs funtionalized with fully reduced catechols. In the case of molar excess of Au, the oxidation of catechols to dopamine quinone and dopaquinone was promoted, and dopaquinone underwent intramolecular cyclization in which additional oxidation products, leukodopachrome, dopachrome, or its tautomer, were formed because of the larger intrinsic acidity of the more nucleophilic amino group in dopaquinone. MD simulations showed that, of the oxidation products, dopachrome had the highest affinity for binding to the AuNPs surface. The results highlight how a more versatile methodological approach, combining experimental and in silico techniques, allows more reliable characterization of binding events at the surface of AuNPs for possible applications in biomedicine.

Increasing use of nano-enabled products provides many benefits in various industrial processes and medical applications, but it also raises concern about release of nanoparticles (NPs) into the environment and subsequent human exposure. While potential toxicity of individual NPs types has been well described in scientific literature, exposure and health-related effects of nanomixtures has been poorly described. This study aimed to evaluate the combined effect of silver (AgNP) and polystyrene NPs (PSNP) on the human macrophages. AgNP are one of the most commercialized NPs due to efficient antimicrobial activity, while PSNP are ubiquitous in terrestrial and aquatic environments due to plastic pollution and degradation of polystyrene-based products. Differentiated monocytic cell line THP-1 were used as an in vitro model of human macrophages. Multiple aspects of cellular response to AgNP-PSNP nanomixture were analyzed including cell death, induction of apoptosis, oxidative stress response, expression of pro- and anti-inflammatory cytokines, and nanomechanical properties of cells. NPs uptake was visualized by confocal microscopy and quantified using flow cytometry. Results show that nanomixture increased apoptosis and cell death, expression of IL-6, IL-8 and TNFa, oxidative stress and mitochondrial dysfunction in cells compared to AgNP and PSNP applied as single treatments, indicating mixture additive action. Anti-inflammatory cytokines IL1b, IL-4 and IL-10 were not affected by combined exposure compared to single NPs. Visualization of NPs uptake and internalization showed that AgNP and PSNP were localized mostly in cytoplasm, with small fraction of AgNP translocated into cell nuclei, which explain increased number of double-stranded DNA breaks following exposure of cells to AgNPs alone or in the mixture. Study outcomes represent clear warnings on the human co-exposure to AgNP and PSNP that needs to be implemented in risk assessment approaches towards toxic-free environment.

Nano-drug delivery systems may potentially overcome current challenges in the treatment of Parkinson's disease (PD) by enabling targeted delivery and more efficient blood-brain penetration ability. This study investigates novel gold nanoparticles (AuNPs) to be used as delivery systems for L-DOPA and dopamine by considering their binding capabilities in the presence and absence of a model protein, bovine serum albumin (BSA). Four different AuNPs were prepared by surface functionalization with polyethylene glycol (PEG), 1-adamantylamine (Ad), 1-adamantylglycine (AdGly), and peptidoglycan monomer (PGM). Fluorescence and UV-Vis measurements demonstrated the strongest binding affinity and L-DOPA/dopamine loading efficiency for PGM-functionalized AuNPs with negligible impact of the serum protein presence. Thermodynamic analysis revealed a spontaneous binding process between L-DOPA or dopamine and AuNPs that predominantly occurred through van der Waals interactions/hydrogen bonds or electrostatic interactions. These results represent PGM-functionalized AuNPs as the most efficient at L-DOPA and dopamine binding with a potential to become a drug-delivery system for neurodegenerative diseases. Detailed investigation of L-DOPA/dopamine interactions with different AuNPs was described here for the first time. Moreover, this study highlights a cost- and time-effective methodology for evaluating drug binding to nanomaterials.

Vapor phase processes have been developed for building organic-inorganic hybrid films using small molecules from the gas phase on almost all kind of surfaces. The advantages of these processes include automatization, scalability, uniform coating even of porous substrates and excellent film thickness control at the nanoscale, which make them very interesting for applications, ranging from electronics to biomedical devices. The most known, atomic layer deposition (ALD) is used for the growth of inorganic thin films from organometallic precursors. Similarly, molecular layer deposition (MLD) is used to grow organic polymeric thin films by employing gas organic monomers as precursors, and further combinations of ALD/MLD can afford modular hybrid structures. Although several MLD processes are known today, there is still plenty room for investigation given the vast possibilities provided by the organic chemical reactions. However, the choice of organic precursors is challenging because several factors (e.g., volatility, stability, reactivity) must be considered to expand the scope of the method. Our efforts toward the introduction of azide-alkyne click chemistry in ALD/MLD processes will be presented. This concept has been demonstrated in pulsed vapor phase surface functionalization of metal oxide surfaces (1, 2).