Search

One of the most critical operations aspects is power management strategies for hybrid AC/DC microgrids. This work presented power management in hybrid AC–DC microgrids with a droop control strategy. At first, photovoltaic, Wind, and battery are used as the power sources, which supply the power with uncertainties. The AC and DC microgrids are controlled by an Adaptive neuro-fuzzy inference system (ANFIS) controller and Proportional Integral Derivative (PID) controller. Simultaneously we calculate the running cost for photovoltaic, Wind, and Battery. Moreover, an optimizer based on the elephant herding optimization algorithm is formulated to reduce the cost price. This method utilizes two stages like clan updating operator and separating operator. This cost value is used to calculate the Droop Coefficients in Droop Control Strategy. The autonomous droop control strategy is utilized in the interlinking converter to share the load between AC and DC. This proposed concept is implemented in the MATLAB tool, and the performance is taken in terms of voltage, power, and current for PV and wind, DC link voltage and load current. The bidirectional ac/dc interlinking converter power flow was subsequently changed from 2.2k W to −2k W. The effectiveness of the power dispatch mode under uniform control has been verified.

A novel non-isolated high-gain DC–DC converter for green energy employment is presented and analyzed. The proposed converter comprises a switched capacitor cell, passive clamp circuit, coupled inductors, and voltage multiplier unit. An interleaved boost converter (IBC) is placed on the input side of the proposed design. The voltage multiplier unit (VMU) with the secondary windings of the coupled inductors is located on the load side. It is used to accomplish interleaved power storage. The leakage energy of coupled inductor is recirculated to the load side, and the reverse recovery problem of diodes is effectively suppressed. As a result, a low-on-state resistance power switch with a low voltage rating is employed and minimizing conduction losses. The presented topology is suitable for sustainable energy applications due to its low operating duty cycle, high voltage conversion ratio, and higher efficiency. The output voltage causes substantially low voltage stress on semiconductor switches and passive elements. This proposed paper deals with simulation, parameter selection, experimental design, results and discussion. The simulation is verified using MATLAB/Simulink with a DC voltage of 30–517 V. To validate the design analysis, a 1.5-kW experimental prototype is designed with a switching frequency of 10 kHz and attained an efficiency of 96.07%. [ABSTRACT FROM AUTHOR]

The increasing concerns about greenhouse gas emissions have made it necessary to incorporate environmental constraints in the operation of power systems. The CO2 emission-constrained short-term unit commitment problem (CSCUCP) is a multiobjective optimization problem that involves minimizing both the cost of operation and the CO2 emissions. This paper proposes an integer-coded shuffled frog-leaping algorithm (SFLA) to minimize both total CO2 emissions and operating costs for the unit commitment problem (UCP) over a one-day scheduling period. The SFLA is inspired by the natural food-searching behavior of frogs. The proposed method aims to determine the optimal start-up and shut-down times for generating units to meet fluctuating loads while minimizing operating costs and CO2 emissions. The method takes into account fuel costs, start-up and shut-down costs, and maintenance costs while satisfying various constraints. The study uses the IEEE 39 bus with a 10-unit test system, and the results are related to conventional methods. The proposed method consistently produces lower CO2 emissions and total operating costs compared to the existing methods. [ABSTRACT FROM AUTHOR]

Titanium dioxide nanofluid is used in the thermosyphon solar flat plate collector at volume fractions of 0.1%, 0.3%, 0.5%, 0.7%, and 1% to test the collector's effectiveness. The heat transfer coefficient, Nusselt number, friction factor, and pressure drop calculations were used to analyze the impact of adding nanoparticles to the working fluid. The effectiveness of the solar flat plate collector and the heat transfer coefficient are both greatly affected by the addition of titanium dioxide to the working fluid, with a tolerable rise in pressure drop. With concomitant variances of 15% and 13%, correlations were constructed for the Nusselt number and friction factor. [ABSTRACT FROM AUTHOR]