Search

Measurements of areal (3D) surface texture using optical methods are very popular because of the short measurement time compared to the stylus tip technique. However, they are very sensitive to measurement errors. In some cases, optical measurements are not recommended. The stylus measurement method is well known and can be the reference technique for surface texture measurement. The main disadvantage is the long measuring time. This time can be shortened using higher speeds of measurement. The effect of the speed of the measurement of stylus profilometer on changes in surface texture parameters was studied. Fifty surface topographies were measured using the stylus profilometer at speeds 0.5, 1, 2, 3, 4, and 5 mm/s in the same places. Surfaces after lapping, polishing, grinding, milling, laser texturing, and two-process random surfaces were measured and analyzed. Changes in parameters caused by the increase in the traverse speed depend on the characteristics and parameters of the surfaces. The random surfaces changed more than the deterministic ones. The increase in the traverse speed from 0.5 to 1 mm/s caused small changes in the parameters. [ABSTRACT FROM AUTHOR]

During co-action between contact elements in reciprocating motion, different working conditions exist in outer and inner zones of stationary elements. Because the tribological effects of surface texturing depend on the operating conditions, various dimple patterns were created in the middle part of the steel disc and near the reversal points. The behaviors of variable dimple patterns were compared with those of uniform texturing and untexturing. It was found that the dimple patterns in the middle disc zone depended on the resistance to motion. The best tribological behavior was obtained for a pit area ratio of 13% and diameter of 0.4 mm in the inner zone, and pit area ratio of 3% and diameter of 0.2 mm in the outer zones. Low resistance to motion and the smallest friction variation of all tested sliding pairs were achieved. For the same pit area ratio of 13% in a disc of 0.4 mm, the dimple diameter behaved better than in the 0.2 mm diameter disc. The greatest decrease in the coefficient of friction of 85% compared to untextured sliding pair was achieved for uniform laser texturing with a pit area ratio of 13% and dimple diameter of 0.4 mm, when the normal load was 40 N and frequency of displacement was 20 Hz. [ABSTRACT FROM AUTHOR]

Surface topography in general is not easy to characterize due to a great number of different features that appear on it. It is still more challenging for machined textured surfaces that are of high functional significance for tribological purposes. For practical reasons, there is a need to describe such surfaces using only a small number of parameters. Which of them represent surface details the best is still an open issue. To find out which parameters can be the most suitable in that case, three groups of machined textured surfaces were prepared. They were plateau-honed cylinder surfaces made of gray cast iron, steel, and bronze surfaces with isolated dimples and steel surfaces after abrasive blasting followed by lapping. All of them were measured by means of a white light interferometer. Different parameters and relationships were evaluated and based on them correlation and regression analyses were used. The basic description contained statistically independent parameters that can be used in production control, while the wider description in scientific research. In general, parameters of random surfaces were more intercorrelated than those of surfaces with isolated dimples. As was found for the basic description of random two-process surfaces, five parameters were enough while description of textured surfaces with isolated oil pockets needed six. In wider, scientific description, regardless the surface type seven parameters contained the necessary information about the surface. It was also proved that a pair of parameters, the emptiness coefficient Sp/Sz and Sq/Sa, can describe the shape of the ordinate distribution of machined textured surfaces better than, for example, skewness Ssk and kurtosis Sku, commonly used for that purpose. [ABSTRACT FROM AUTHOR]