Search

The force development by calcium-activated skinned frog skeletal muscle fibers and the motion on a slow time base after a quick decrease in load were studied at 0-1 degrees C as a function of the ionic strength and the degree of activation. The ionic strength was varied between 50 and 190 mM by adding appropriate concentrations of KCl to the bathing solution. Under these conditions, the fibers could be maximally activated for several cycles at low ionic strength without developing residual tension. We found that the steady isometric force in fully activated fibers linearly decreased when the KCl concentration was increased from 0 to 140 mM. The steady isotonic motion at a given relative load in fully activated fibers was almost the same at KCl concentration greater than or equal to 50 mM. In 0 and 20 mM KCl, the isotonic velocity decreased continuously for more than 300 ms. At a given relative load, the initial velocity of the motion in 0 and 20 mM KCl was about 0.6 and 0.9 times, respectively, that in 140 mM KCl. The initial velocity decreased further when residual tension developed; this observation provides additional evidence that residual tension may reflect the presence of an internal load. The effect of calcium on the motion was examined at 70 mM KCl. In this solution, the motion during the velocity transient at a given relative load appeared to be the same at different levels of activation. The speed of the subsequent motion was almost steady at high calcium levels but decreased continuously in low calcium levels. These results support the idea that at low ionic strength the response of the fiber to calcium is switch-like, but that other factors also affect the contraction mechanism under these conditions.

Calcium and ionic strength are both known to modify the force developed by skinned frog muscle fibers. To determine how these parameters affect the cross-bridge contraction mechanism, the isotonic velocity transients following step changes in load were studied in solutions in which calcium concentration and ionic strength were varied. Analysis of the motion showed that calcium has no effect on either the null time or the amplitude of the transients. In contrast, the transient amplitude was increased in high ionic strength and was suppressed in low ionic strength. These results are consistent with the idea that calcium affects force in skeletal muscle by modulating the number of force generators in a simple switchlike "on-off" manner and that the steady force at a given calcium level is proportional to cross-bridge number. On the other hand, the effect of ionic strength on force is associated with changes in the kinetic properties of the cross-bridge mechanism.

Chloride-induced Ca release in skinned muscle fibers was studied by measuring isometric force transients and 45Ca loss from fiber to washout solutions. Skinned fibers prepared from muscles soaked in normal Ringer solution made large force transients in 120 mM Cl solution with 5 mM ATP and 1 mM Mg, but 3 mM Mg was inhibitory. Mg inhibition was antagonized by low temperature and by Cd, agents which slow active Ca uptake by the sarcoplasmic reticulum (SR). In low Mg++, Cl stimulated rapid 45Ca release from the SR in sufficient amounts to account for the force response. The increased 45Ca release was inhibited by EGTA, suggesting that release requires free Ca under these conditions. The 45Ca initially released was partially reaccumulated later. Reaccumulation was increased in higher Mg++. These results provide additional evidence that the Ca uptake rate is an important determinant of net release, and suggest that Mg++ acts primarily on this mechanism. Skinned fibers prepared from muscles soaked in low Cl solutions could give force responses to Cl solutions with 3 mM and 6 mM Mg. This observation suggests that the Cl stimulus varies with the [Cl] gradient across the internal membranes, and supports the hypothesis that applied Cl causes membrane depolarization.