Search

Despite the development of numerous coating techniques and materials, today’s anti-biofouling applications require coatings that are facile and mechanically robust in nature. Studies on the hydrophobicity of rare-earth oxides have risen due to their unusual chemical properties; ytterbium oxide is one such oxide substance. In this study, spray combustion was used to create a hydrophobic coating of ytterbium oxide (Yb2O3) on a stainless steel (SS) substrate, which was then vacuum-treated. GI-XRD analysis confirmed the sesquioxide cubic crystalline structure of Yb2O3. FESEM images displayed an underneath wavy morphological coating with discrete particles on the surface. The thickness and roughness were ~12 and ~0.17 µm, respectively. When 5 and 10 N loads were applied, the coating showed better scratch hardness than uncoated SS. Water contact angle (WCA) <10° indicated superhydrophilicity in the fabricated coating. After vacuum treatment, it became hydrophobic, and the WCA was 128°; because of the increment in the relative area fraction of the C–H bond. The proportion of area covered by blue–green algae (Phormidium sp.) on vacuum-treated Yb2O3 coating was only 3% compared to uncoated SS samples, 80%. [ABSTRACT FROM AUTHOR]

Hydroxyapatite (HA, Ca10(PO4)6(OH)2)-based porous scaffolds have been widely investigated in the last three decades. HA, with excellent biocompatibility and osteoconductivity, has made this material widely used in bone tissue engineering. To improve the mechano-biological properties of HA, the addition of clay to develop HA-based composite scaffolds has gained considerable interest from researchers. In this study, a cost-effective method to prepare a HA–clay composite was demonstrated via the mechanical mixing method, wherein kaolin was used because of its biocompatibility. Prawn (Fenneropenaeus indicus) exoskeleton biowaste was utilized as a raw source to synthesize pure HA using wet chemical synthesis. HA–clay composites were prepared by reinforcing HA with 10, 20, and 30 wt.% of kaolin via the mechanical mixing method. A series of characterization tools such as XRD, FTIR, Raman, and FESEM analysis confirmed the phases and characteristic structural and vibrations bonds along with the morphology of sintered bare HA, HA–kaolin clay composite, and kaolin alone, respectively. The HA–clay composite pellets, uniaxially pressed and sintered at 1100 °C for 2 h, were subjected to a compression test, and an enhancement in mechanical and physical properties, with the highest compressive strength of 35 MPa and a retained open porosity of 33%, was achieved in the HA–kaolin (20 wt.%) clay composite, in comparison with bare HA. The addition of 20% kaolin to HA enhanced its compressive strength by 33.7% and increased its open porosity by 19% when compared with bare HA. The reinforcement of HA with different amounts (10, 20, 30 wt.%) of kaolin could open up a new direction of preparing biocomposite scaffolds with enhanced mechanical properties, improved wear, and better cell proliferation in the field of bone tissue engineering. [ABSTRACT FROM AUTHOR]