Search

The aim of the study was to assess the effect of water infusion of dried and crushed ground ivy (GH) on the fermentation properties of wheat flour (WF), farinographic properties of flour and dough (WD) and the quality of the obtained bread. In the tested systems, tap water was replaced with water infusion with GH (m/v) at a concentration of 1% (A), 3% (B) and 5% (C). As part of the research methodology, the fermentation properties of flour and rheological properties of dough were assessed using a farinograph, and bread was obtained using a single-phase method using yeast and its quality was assessed. As part of this, the antioxidant potential and the profile and level of polyphenol content were determined. It was shown that replacing water with GH infusions shortened the total fermentation time of the dough and reduced the fermentation capacity of the dough. In the farinographic evaluation, an increase in flour water absorption (54.0–57.0%), dough development time (2.3–7.6 min), dough stability and softening were observed with an increase in the concentration of the added GH infusion. In turn, the volume of the loaf and the specific volume of the bread decreased with increasing the concentration of the GH infusion. The bread crumb darkened, and the elasticity and chewiness of the crumb decreased in relation to the control sample. In turn, the presence of GH infusion did not significantly affect the hardness of the crumb. As the concentration of the added GH infusion increased, an increase in the antioxidant potential of bread and the content of polyphenols and flavonoids was observed, and the UPLC-PDA-MS/MS analysis allowed the identification of 11 polyphenols in the bread. [ABSTRACT FROM AUTHOR]

Currently, there is an increase in consumer interest in food produced from raw materials from organic farming, which has an impact on the greater attention paid to the possibility of increasing the cultivation of old cereal species. One of the cereals that is suitable for these trends is mountain rye, which is a premise for undertaking research on the usefulness of this cereal grain in food production. Therefore, the aim of the study was to compare the baking value of flour with different milling yields obtained from milling mountain rye grain. The research material consisted of rye grain (Secale montanum Guss.), which was milled, and 6 different rye flours were obtained. The flour was tested for selected quality parameters such as moisture, crude protein content, total ash content, and acidity. Doughs were prepared and fermented using a single-phase method carried out in two different variants, with or without the addition of lactic acid. The obtained rye breads were quality assessed and subjected to organoleptic and consumer evaluations. The use of the fermentation method with dough acidification with lactic acid allowed us to obtain breads with a better specific volume and acidity compared to those obtained from dough without acidification. Breads baked from dough prepared using the method of non-acidification with lactic acid had better porosity of the crumb. In the quality classification, breads made from low-extract flour turned out to be the best, and breads baked from dough made using the non-lactic acid acidification method were more generally accepted by panelists. As confirmed by research, mountain rye grain is a raw material for the production of flour with good baking value, which depends on the preparation of the grain and milling method. The quality of rye bread made from mountain rye flour depends on the flour yield, the baking value of the flour, and the method used for dough fermentation for bread baking [ABSTRACT FROM AUTHOR]

The aim of the study was to evaluate the polyphenol profile of Castanea sativa leaf methanolic extract and further evaluate its biological activities in vitro. After purification with an RP-18 resin, the extract was assessed for its polyphenol profile by UPLC-PDA-MS/MS, as well as for the antioxidant potential (ABTS, CUPRAC, ChA, ROS scavenging methods), anticancer, antiobesity, antidiabetic and antimicrobial potential. Eighteen polyphenols were identified and the dominant compounds were chestatin followed by quercetin 3-O-glucoside. The total phenolic content of the extract showed a value of 1426.55 mg/100 g d.w. The obtained preparation showed the ability to scavenge O2•− (0.067 mg/mL) and OH• (0.207 mg/mL) radicals and had a stronger anti-obesity than anti-diabetic effect. Additionally, this extract exhibited a strong anticancer activity against the Caco-2 line (153.54 µg/mL), with anti-migratory and anti-proliferative activity. In turn, among the tested strains, the highest activity was demonstrated against Staphylococcus aureus. Moreover, the effects demonstrated were strongly dependent on the content of polyphenols. In conclusion, C. sativa is a promising source of natural antioxidant, antibacterial, antiobesity, antidiabetic and chemopreventive compounds for food-pharma industry; however, further experimental studies are needed to validate its pharmacological properties. [ABSTRACT FROM AUTHOR]

The main aim of this work was to assess the possibility of using dried walnut leaves (Juglans regia L.) in the production of wheat bread. In the developed recipe, wheat flour was partially replaced with dried and powdered walnut leaves (WLs) in amounts of 0.5%, 1.0%, 1.5%, 2.0% and 2.5%. Serving as a control sample was wheat bread without WLs. The bread was made using a single-phase method using yeast. As part of the research methodology, laboratory baking parameters (dough yield, total oven loss, bread yield), loaf volume and loaf specific volume were determined. Additionally, the colors of the dough, crust and bread crumb were determined in the CIE L*a*b* space. The crumb texture profile was assessed using the TPA test. Additionally, the antioxidant power and the total phenolic content of the dough and bread were tested. The consumer acceptability of the sensory features of the bread was also assessed. The test results were statistically analyzed using a one-way ANOVA. It was found that enriching the bread recipe with WLs had a significant impact on its quality. The control bread had the highest volume, and replacing wheat flour with dried leaves resulted in a significant reduction in volume, which was greater at higher WLs contents. Similarly, as the proportion of WLs in the recipe increased, a significant decrease in the brightness of both the dough and the crumb of the obtained bread was observed. A texture analysis showed that bread with a WLs content of 2.5% was the most different from the control bread and other tested breads. However, it was found that enriching bread with the unconventional addition of walnut leaves had a very good effect on its health benefits. The antioxidant activity and the content of total phenolics in the bread grew with the increase in the share of WLs in the recipe. [ABSTRACT FROM AUTHOR]

Copyright of Zywnosc is the property of Polish Society of Food Technologists - Scientific Publishing and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

This study assessed edible oil industry byproducts, oil cakes (OC) based on hazelnuts and walnuts (HOC, WOC), to replace wheat flour dough (WD) based on farinograph and extensograph parameters and rheological measurements. The research hypothesis of this work is that replacing part of wheat flour with ground nut oil cakes modifies the rheological characteristics of the dough. WF was replaced at the level of 5%, 10% and 15%. It was shown that use of OC in flour mixtures at various levels significantly influenced the rheological properties of the dough. The water absorption of wheat flour and oil cake mixtures was higher than that of the control sample, and the average value of this indicator was 53.4%. The control sample had the lowest dough development time (DDT), and the presence of HOC or WOC in the system resulted in a significant increase in this parameter (p < 0.05). The average DDT of WDHOC cakes was 4.7 min and was lower compared to WDWOC which was 5.9 min. The WDWOC10% and WDWOC15% samples were characterized by the highest dough stability value and the lowest degree of softening (p < 0.05). The presence of OC in the flour mixtures increased the values of the storage and loss moduli, which was reflected in the K′ and K″ values. The values of these parameters also increased as the level of OC addition increased. WDHOC doughs were characterized by higher values of the K′ and K″ parameters compared to WDWOC. The results of the creep and recovery test showed that the dough with the addition of nut OC was less susceptible to deformation compared to the control dough (p < 0.05). The resistance to deformation increased with the increasing share of HOC or WOC in the mixtures. The average value of viscoelastic compliance (J1) of this parameter for WDHOC dough was on average 1.8 × 10−4 Pa−1, and for WDWOC 2.0 × 10−4 Pa−1. Nut oil cakes are an interesting technological addition to the dough. Their use may have a positive impact on the characteristics of the finished product and expand their application possibilities in the food industry. This is because the dough with the addition of nut cakes was more stiff and less flexible and susceptible to deformation. [ABSTRACT FROM AUTHOR]

The following study analyzed the impact of fertilizing barley with fly ash from biomass combustion grown on two types of soil, Haplic Luvisol (HL) and Gleyic Chernozem (GC), on the properties of starch. The experiment was conducted in 2019 (A) and 2020 (B), and barley was fertilized with ash doses (D1–D6) differing in mineral content. In the tested barley starch samples, the amylose content, the clarity of the paste, and the content of selected minerals were determined. The thermodynamic characteristics of gelatinization and retrogradation were determined using the DSC method. Pasting characteristics, flow curves, and viscoelastic properties of starch pastes were performed. Starches differed in amylose content and paste clarity. The highest gelatinization and retrogradation enthalpy (ΔHG and ΔHR) values were recorded for samples GCD1A and HLD5B. None of the tested factors significantly affected the pasting temperature (PT), but they had a significant impact on the remaining parameters of the pasting characteristics. The average PT value of barley starches was 90.9 °C. However, GCD2A starch had the highest maximum viscosity and the highest rheological stability during heating. GCD2A paste was characterized by the highest apparent viscosity. It was shown that all pastes showed non-Newtonian flow and shear-thinning and had a predominance of elastic features over viscous ones. The resulting gels had the characteristics of weak gels. Ash from burning wood biomass is an innovative alternative to mineral fertilizers. It was shown that the use of such soil fertilization influenced the properties of barley starch. [ABSTRACT FROM AUTHOR]

Copyright of Zywnosc is the property of Polish Society of Food Technologists - Scientific Publishing and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

The aim of this work was to evaluate the effect of dextrose equivalent and concentration of potato maltodextrins on stability and rheological properties of egg albumin foams. It was found that maltodextrins can act as stabilising agents for aerated food systems. This characteristic of maltodextrin depends on its DE value and concentration. The foams containing 20 and 30 wt% of maltodextrin of DE 6 did not undergo destabilisation in time, contrary to the foams with maltodextrins of DE 11 and DE 16. All the foams showed viscoelastic properties with a domination of the elastic ones and they exhibited characteristics typical of a weak gel. The foams with maltodextrins were less susceptible to deformation as compared to the foam without maltodextrin. The susceptibility to deformation of the foams decreased with a decrease in the maltodextrin DE value and with an increase in the maltodextrin concentration. [ABSTRACT FROM AUTHOR]