Search

Fabry–Perot interferometers (FPIs), comprising foundry-compatible dielectric thin films on sapphire wafer substrates, were investigated for possible use in chemical sensing. Specifically, structures comprising two vertically stacked distributed Bragg reflectors (DBRs), with the lower DBR between a sapphire substrate and a silicon-oxide (SiO2) resonator layer and the other DBR on top of this resonator layer, were investigated for operation in the near-ultraviolet (near-UV) range. The DBRs are composed of a stack of nitride-rich silicon-nitride (SiNx) layers for the higher index and SiO2 layers for the lower index. An exemplary application would be formaldehyde detection at sub-ppm concentrations in air, using UV absorption spectroscopy in the 300–360 nm band, while providing spectral selectivity against the main interfering gases, notably NO2 and O3. Although SiNx thin films are conventionally used only for visible and near-infrared optical wavelengths (above 450 nm) because of high absorbance at lower wavelengths, this work shows that nitride-rich SiNx is suitable for near-UV wavelengths. The interplay between spectral absorbance, transmittance and reflectance in a FPI is presented in a comparative study between one FPI design using stoichiometric material (Si3N4) and two designs based on N-rich compositions, SiN1.39 and SiN1.49. Spectral measurements confirm that if the design accounts for phase penetration depth, sufficient performance can be achieved with the SiN1.49-based FPI design for gas absorption spectroscopy in near-UV, with peak transmission at 330 nm of 64%, a free spectral range (FSR) of 20 nm and a full-width half-magnitude spectral resolution (FWHM) of 2 nm. [ABSTRACT FROM AUTHOR]

Pholis fangi is a small, bottom-dwelling fish species endemic to the Yellow Sea and Bohai Sea in China. While previous research has focused on its population biology and molecular structure, little is known about the early developmental stages of this species. In this study, larval and juvenile P. fangi specimens were collected from the Sheyang Sea Area, Jiangsu Province, in 2017. Morphological features were examined using microscopy, and DNA barcoding was conducted to confirm species identification. The research documented detailed changes in yolk sac, fin development, and melanophore distribution patterns across larval and juvenile stages of P. fangi. Comparative analysis with other Pholis species revealed that melanophore distribution is a key distinguishing characteristic, allowing effective differentiation between larval and juvenile stages, as well as between Pholis species. This study provides valuable insights into the early life history of P. fangi, contributing to a better understanding of the genus Pholis. The findings demonstrate the utility of combining traditional morphological observation and molecular techniques for accurate species identification, particularly during the critical larval and juvenile developmental phases. [ABSTRACT FROM AUTHOR]

Microscale gas chromatography (μGC) systems are miniaturized instruments that typically incorporate one or several microfabricated fluidic elements; such systems are generally well suited for the automated sampling and analysis of gas-phase chemicals. Advanced μGC systems may incorporate more than 15 elements and operate these elements in different coordinated sequences to execute complex operations. In particular, the control software must manage the sampling and analysis operations of the μGC system in a time-sensitive manner; while operating multiple control loops, it must also manage error conditions, data acquisition, and user interactions when necessary. To address these challenges, this work describes the investigation of multithreaded control software and its evaluation with a representative μGC system. The μGC system is based on a progressive cellular architecture that uses multiple μGC cells to efficiently broaden the range of chemical analytes, with each cell incorporating multiple detectors. Implemented in Python language version 3.7.3 and executed by an embedded single-board computer, the control software enables the concurrent control of heaters, pumps, and valves while also gathering data from thermistors, pressure sensors, capacitive detectors, and photoionization detectors. A graphical user interface (UI) that operates on a laptop provides visualization of control parameters in real time. In experimental evaluations, the control software provided successful operation and readout for all the components, including eight sets of thermistors and heaters that form temperature feedback loops, two sets of pressure sensors and tunable gas pumps that form pressure head feedback loops, six capacitive detectors, three photoionization detectors, six valves, and an additional fixed-flow gas pump. A typical run analyzing 18 chemicals is presented. Although the operating system does not guarantee real-time operation, the relative standard deviations of the control loop timings were <0.5%. The control software successfully supported >1000 μGC runs that analyzed various chemical mixtures. [ABSTRACT FROM AUTHOR]

The green tide in the Southern Yellow Sea which has been erupting continuously for 14 years. Dominant species of the free-floating Ulva in the early stage of macroalgae bloom were Ulva compressa, Ulva flexuosa, Ulva prolifera, and Ulva linza along the coast of Jiangsu Province. In the present study, we carried out comparative studies on complete mitochondrion genomes of four kinds of bloom-forming green algae, and provided standard morphological characteristic pictures of these Ulva species. The maximum likelihood phylogenetic analysis showed that U. linza is the closest sister species of U. prolifera. This study will be helpful in studying the genetic diversity and identification of Ulva species.

With global warming, in recent years, golden tides have frequently occurred off the coasts of China. Sargassum horneri, which attach to aquaculture rafts, can float and form small-scale golden tides after falling off. Temperature will affect the growth and reproduction of algae. In order to explore whether the temperature is the potential influence factor of the golden tide outbreak, in this study, the effects of global warming on the growth and proliferation of S. horneri in the mussel aquaculture area of Gouqi Island will be discussed. Samples of the macroalgae were collected monthly from August 2021 to July 2022 at various stages of its life cycle, and the relationship between algal growth and temperature was analyzed based on the concept of effective accumulated temperature, combined with the parameters of sea surface temperature, photosynthetic rate, growth rate, and growth cycle. Based on the continuous temperature variation observed, the growth cycle could be divided into five stages: the decreasing temperature period (October to November), the low-temperature adaptation period (December), the second suitable low-temperature period (January to February), and the high-temperature decay period (February to May). The effective accumulated temperature stored by S. horneri from 2021 to 2022 was 2772.4 °C·d; compared with previous studies, it decreased by about 800 °C·d. The winter temperature in 2022 was higher than the average temperature in the previous 5 years, allowing the macroalgae to enter the reproductive period in advance. This had a significant impact on the blooming time of golden tides and led to an earlier outbreak and extinction. Therefore, in the future, we can set up a monitoring system for the early warning of golden tides according to the change of SST in winter. [ABSTRACT FROM AUTHOR]