Search

We report on the strong coupling between a metallic ferromagnetic Fe75Co25 thin film patterned element and a range of superconducting Nb half-wavelength co-planar waveguide (CPW) resonators. By varying the volume of the ferromagnet we demonstrate that the coupling rate scales linearly with the square root of the number of spins and achieve a coupling rate over 700 MHz, approaching the ultrastrong coupling regime. Experiments varying the center conductor width while maintaining constant magnetic volume verify that decreasing the center conductor width increases coupling and cooperativity. Our results show that the frequency dependence of the coupling rate is linear with the fundamental and higher order odd harmonics of the CPW, but with differing efficiencies. The results show promise for scaling planar superconducting resonator/magnetic hybrid systems to smaller dimensions., Comment: 14 pages, 6 figures

Single flux quantum (SFQ) circuits form a natural neuromorphic technology with SFQ pulses and superconducting transmission lines simulating action potentials and axons, respectively. Here we present a new component, magnetic Josephson junctions, that have a tunablility and re-configurability that was lacking from previous SFQ neuromorphic circuits. The nanoscale magnetic structure acts as a tunable synaptic constituent that modifies the junction critical current. These circuits can operate near the thermal limit where stochastic firing of the neurons is an essential component of the technology. This technology has the ability to create complex neural systems with greater than 10^21 neural firings per second with approximately 1 W dissipation., Comment: 2016 IEEE International Conference on Rebooting Computing (ICRC)

We model "soft" error rates for writing (WSER) and for reading (RSER) for perpendicular spin-torque memory devices by solving the Fokker-Planck equation for the probability distribution of the angle that the free layer magnetization makes with the normal to the plane of the film. We obtain: (1) an exact, closed form, analytical expression for the zero-temperature switching time as a function of initial angle; (2) an approximate analytical expression for the exponential decay of the WSER as a function of the time the current is applied; (3) comparison of the approximate analytical expression for the WSER to numerical solutions of the Fokker-Planck equation; (4) an approximate analytical expression for the linear increase in RSER with current applied for reading; (5) comparison of the approximate analytical formula for the RSER to the numerical solution of the Fokker-Planck equation; and (6) confirmation of the accuracy of the Fokker-Planck solutions by comparison with results of direct simulation using the single-macrospin Landau-Lifshitz-Gilbert (LLG) equations with a random fluctuating field in the short-time regime for which the latter is practical.

We measure the power spectral density of frequency fluctuations in nanocontact spin torque oscillators over time scales up to 50 ms. We use a mixer to convert oscillator signals ranging from 10 GHz to 40 GHz into a band near 70 MHz before digitizing the time domain waveform. We analyze the waveform using both zero crossing time stamps and a sliding Fourier transform, discuss the different limitations and advantages of these two methods, and combine them to obtain a frequency noise spectrum spanning more than five decades of Fourier frequency $f$. For devices having a free layer consisting of either a single Ni$_{\text{}80}$Fe$_{\text{}20}$ layer or a Co/Ni multilayer we find a frequency noise spectrum that is white at large $f$ and varies as \emph{$1/f$} at small $f$. The crossover frequency ranges from $\approx\unit[10^{4}]{Hz}$ to $\approx\unit[10^{6}]{Hz}$ and the $1/f$ component is stronger in the multilayer devices. Through actual and simulated spectrum analyzer measurements, we show that $1/f$ frequency noise causes both broadening and a change in shape of the oscillator's spectral line as measurement time increases. Our results indicate that the long term stability of spin torque oscillators cannot be accurately predicted from models based on thermal (white) noise sources.

We measure oscillator phase from the zero crossings of the voltage vs. time waveform of a spin torque nanocontact oscillating in a vortex mode. The power spectrum of the phase noise varies with Fourier frequency $f$ as $1/f^2$, consistent with frequency fluctuations driven by a thermal source. The linewidth implied by phase noise alone is about 70 % of that measured using a spectrum analyzer. A phase-locked loop reduces the phase noise for frequencies within its 3 MHz bandwidth., Comment: 6 pages, 5 figures, supplementary material. Submitted to {Appl. Phys. Lett.}

The broadband ferromagnetic resonance (FMR) linewidth of the free layer of magnetic tunnel junctions is used as a simple diagnostic of the quality of the magnetic structure. The FMR linewidth increases near the field regions of free layer reversal and pinned layer reversal, and this increase correlates with an increase in magnetic hysteresis in unpatterned films, low frequency noise in patterned devices, and previous observations of magnetic domain ripple by use of Lorentz microscopy. Postannealing changes the free layer FMR linewidth indicating that considerable magnetic disorder, originating in the exchange-biased pinned layer, is transferred to the free layer., Comment: 13 pages, 4 figures

We have measured spin-transfer-driven, large amplitude, current hysteretic, low frequency (< 500 MHz), narrowband oscillations in nanocontacts made to spin valve structures. The oscillations occur in zero field, persist up to 5 mT for in plane applied fields, and to beyond 400 mT for out of plane fields. Unlike previous measurements, the oscillation frequency is well below that for uniform-mode ferromagnetic resonance, is only a weak function of applied field, and is highly anharmonic. The oscillations are hysteretic with applied dc current, appearing at high currents but persisting to lower currents upon decrease of the current. We suggest that these observations are consistent with the dynamics of a nonuniform magnetic state in the vicinity of the contact nucleated by both the spin transfer torque and dc current-generated Oersted fields, with the dynamics driven by spin transfer. The electrical oscillation amplitudes are large and narrowband, with the largest amplitudes on the order of 1 mV and the narrowest linewidths below 1 MHz., Comment: 17 pages, 3 (color) figs. PDF only

Spin-polarized dc electric current flowing into a magnetic layer can induce precession of the magnetization at a frequency that depends on current. We show that addition of an ac current to this dc bias current results in a frequency modulated (FM) spectral output, generating sidebands spaced at the modulation frequency. The sideband amplitudes and shift of the center frequency with drive amplitude are in good agreement with a nonlinear FM model that takes into account the nonlinear frequency-current relation generally induced by spin transfer. Single-domain simulations show that ac current modulates the cone angle of the magnetization precession, in turn modulating the frequency via the demagnetizing field. These results are promising for communications and signal processing applications of spin-transfer oscillators., Comment: 13 pages, 3 Figures

We have measured microwave frequency, current-driven magnetization dynamics in point contacts made to Co90Fe10/Cu/ Ni80Fe20 spin valves as a function of applied field strength and angle relative to the film plane. As the field direction is varied from parallel to nearly perpendicular, the device power output increases by roughly two orders of magnitude while the frequencies of the excitations decrease. For intermediate angles the excited frequency does not monotonically vary with applied current and also exhibits abrupt, current-dependent jumps. For certain ranges of current, and applied field strength and direction, the excitation linewidths decrease to a few megahertz, leading to quality factors over 18,000.

We have directly measured coherent high-frequency magnetization dynamics in ferromagnet films induced by a spin-polarized DC current. The precession frequency can be tuned over a range of several gigahertz, by varying the applied current. The frequencies of excitation also vary with applied field, resulting in a microwave oscillator that can be tuned from below 5 GHz to above 40 GHz. This novel method of inducing high-frequency dynamics yields oscillations having quality factors from 200 to 800. We compare our results with those from single-domain simulations of current-induced dynamics.