Search

The effects of contaminant sources removal in 2005 (i.e. barrels, tank, pit and wastewater pipe sources) on carbon tetrachloride (CT) and chloroform (CF) concentration in groundwater were assessed at several areas of a fractured multi-contaminant aquifer (Òdena, Spain) over a long-term period (2010-2014). Changes in redox conditions, in these chlorinated methanes (CMs) concentration and in their carbon isotopic compositions (δ 13 C) were monitored in multilevel wells. δ 13 C values from these wells were compared to those obtained from sources (barrels, tank and pit before their removal, 2002-2005) and to commercial solvents values in literature. Additionally, CMs natural attenuation processes were identified by C-Cl isotope slopes (Λ). Analyses revealed the downstream migration of the pollutant focus and an efficient removal of DNAPLs in the pit source's influence area. However, the removal of the contaminated soil from former tank and wastewater pipe was incomplete as leaching from unsaturated zone was proved, evidencing these areas are still active sources. Nevertheless, significant CMs degradation was detected close to all sources and Λ values pointed to different reactions. For CT in the tank area, Λ value fitted with hydrogenolysis pathway although other possible reduction processes were also uncovered. Near the wastewater pipe area, CT thiolytic reduction combined with hydrogenolysis was derived. The highest CT degradation extent accounted for these areas was 72 ± 11% and 84 ± 6%, respectively. For CF, the Λ value in the pit source's area was consistent with oxidation and/or with transport of CF affected by alkaline hydrolysis from upstream interception trenches. In contrast, isotope data evidenced CF reduction in the tank and wastewater pipe influence areas, although the observed Λ slightly deviates from the reference values, likely due to the continuous leaching of CF degraded in the non-saturated zone by a mechanism different from reduction., (Copyright © 2018 Elsevier B.V. All rights reserved.)

A dual element CCl isotopic study was performed for assessing chlorinated methanes (CMs) abiotic transformation reactions mediated by iron minerals and Fe(0) to further distinguish them in natural attenuation monitoring or when applying remediation strategies in polluted sites. Isotope fractionation was investigated during carbon tetrachloride (CT) and chloroform (CF) degradation in anoxic batch experiments with Fe(0), with FeCl 2 (aq), and with Fe-bearing minerals (magnetite, Mag and pyrite, Py) amended with FeCl 2 (aq), at two different pH values (7 and 12) representative of field and remediation conditions. At pH 7, only CT batches with Fe(0) and Py underwent degradation and CF accumulation evidenced hydrogenolysis. With Py, thiolytic reduction was revealed by CS 2 yield and is a likely reason for different Λ value (Δδ 13 C/Δδ 37 Cl) comparing with Fe(0) experiments at pH 7 (2.9 ± 0.5 and 6.1 ± 0.5, respectively). At pH 12, all CT experiments showed degradation to CF, again with significant differences in Λ values between Fe(0) (5.8 ± 0.4) and Fe-bearing minerals (Mag, 2 ± 1, and Py, 3.7 ± 0.9), probably evidencing other parallel pathways (hydrolytic and thiolytic reduction). Variation of pH did not significantly affect the Λ values of CT degradation by Fe(0) nor Py. CF degradation by Fe(0) at pH 12 showed a Λ (8 ± 1) similar to that reported at pH 7 (8 ± 2), suggesting CF hydrogenolysis as the main reaction and that CF alkaline hydrolysis (13.0 ± 0.8) was negligible. Our data establish a base for discerning the predominant or combined pathways of CMs natural attenuation or for assessing the effectiveness of remediation strategies using recycled minerals or Fe(0)., (Copyright © 2018 Elsevier Ltd. All rights reserved.)

Field-derived anoxic microcosms were used to characterize chloroform (CF) and carbon tetrachloride (CT) natural attenuation to compare it with biostimulation scenarios in which vitamin B 12 was added (B 12 /pollutant ratio of 0.01 and 0.1) by means of by-products, carbon and chlorine compound-specific stable-isotope analysis, and the active microbial community through 16S rRNA MiSeq high-throughput sequencing. Autoclaved slurry controls discarded abiotic degradation processes. B 12 catalyzed CF and CT biodegradation without the accumulation of dichloromethane, carbon disulphide, or CF. The carbon isotopic fractionation value of CF (ƐC CF ) with B 12 was -14±4‰, and the value for chlorine (ƐCl CF ) was -2.4±0.4‰. The carbon isotopic fractionation values of CT (ƐC CT ) were -16±6 with B 12 , and -13±2‰ without B 12 ; and the chlorine isotopic fractionation values of CT (ƐCl CT ) were -6±3 and -4±2‰, respectively. Acidovorax, Ancylobacter, and Pseudomonas were the most metabolically active genera, whereas Dehalobacter and Desulfitobacterium were below 0.1% of relative abundance. The dual C-Cl element isotope slope (Λ=Δδ 13 C/Δδ 37 Cl) for CF biodegradation (only detected with B 12 , 7±1) was similar to that reported for CF reduction by Fe(0) (8±2). Several reductive pathways might be competing in the tested CT scenarios, as evidenced by the lack of CF accumulation when B 12 was added, which might be linked to a major activity of Pseudomonas stutzeri; by different chlorine apparent kinetic isotope effect values and Λ which was statistically different with and without B 12 (5±1 vs 6.1±0.5), respectively. Thus, positive B 12 effects such as CT and CF degradation catalyst were quantified for the first time in isotopic terms, and confirmed with the major activity of species potentially capable of their degradation. Moreover, the indirect benefits of B 12 on the degradation of chlorinated ethenes were proved, creating a basis for remediation strategies in multi-contaminant polluted sites., (Copyright © 2017 Elsevier B.V. All rights reserved.)

To use compound-specific isotope analysis for confidently assessing organic contaminant attenuation in the environment, isotope fractionation patterns associated with different transformation mechanisms must first be explored in laboratory experiments. To deliver this information for the common groundwater contaminant chloroform (CF), this study investigated for the first time both carbon and chlorine isotope fractionation for three different engineered reactions: oxidative C-H bond cleavage using heat-activated persulfate, transformation under alkaline conditions (pH ∼ 12) and reductive C-Cl bond cleavage by cast zerovalent iron, Fe(0). Carbon and chlorine isotope fractionation values were -8 ± 1‰ and -0.44 ± 0.06‰ for oxidation, -57 ± 5‰ and -4.4 ± 0.4‰ for alkaline hydrolysis (pH 11.84 ± 0.03), and -33 ± 11‰ and -3 ± 1‰ for dechlorination, respectively. Carbon and chlorine apparent kinetic isotope effects (AKIEs) were in general agreement with expected mechanisms (C-H bond cleavage in oxidation by persulfate, C-Cl bond cleavage in Fe(0)-mediated reductive dechlorination and E1 CB elimination mechanism during alkaline hydrolysis) where a secondary AKIE Cl (1.00045 ± 0.00004) was observed for oxidation. The different dual carbon-chlorine (Δδ 13 C vs Δδ 37 Cl) isotope patterns for oxidation by thermally activated persulfate and alkaline hydrolysis (17 ± 2 and 13.0 ± 0.8, respectively) vs reductive dechlorination by Fe(0) (8 ± 2) establish a base to identify and quantify these CF degradation mechanisms in the field.

Compound-specific chlorine isotope analysis of tetrachloromethane (CCl 4 ) and trichloromethane (CHCl 3 ) was explored by both, gas chromatography-isotope ratio mass spectrometry (GC-IRMS) and GC-quadrupole MS (GC-qMS), where GC-qMS was validated in an interlaboratory comparison between Munich and Neuchâtel with the same type of commercial GC-qMS instrument. GC-IRMS measurements analyzed CCl isotopologue ions, whereas GC-qMS analyzed the isotopologue ions CCl 3 , CCl 2 , CCl (of CCl 4 ) and CHCl 3 , CHCl 2 , CHCl (of CHCl 3 ), respectively. Lowest amount dependence (good linearity) was obtained (i) in H-containing fragment ions where interference of 35 Cl- to 37 Cl-containing ions was avoided; (ii) with tuning parameters favoring one predominant rather than multiple fragment ions in the mass spectra. Optimized GC-qMS parameters (dwell time 70 ms, 2 most abundant ions) resulted in standard deviations of 0.2‰ (CHCl 3 ) and 0.4‰ (CCl 4 ), which are only about twice as large as 0.1‰ and 0.2‰ for GC-IRMS. To compare also the trueness of both methods and laboratories, samples from CCl 4 and CHCl 3 degradation experiments were analyzed and calibrated against isotopically different reference standards for both CCl 4 and CHCl 3 (two of each). Excellent agreement confirms that true results can be obtained by both methods provided that a consistent set of isotopically characterized reference materials is used.

We study static and radially symmetric black holes in the multi-fractional theories of gravity with q -derivatives and with weighted derivatives, frameworks where the spacetime dimension varies with the probed scale and geometry is characterized by at least one fundamental length [Formula: see text]. In the q -derivatives scenario, one finds a tiny shift of the event horizon. Schwarzschild black holes can present an additional ring singularity, not present in general relativity, whose radius is proportional to [Formula: see text]. In the multi-fractional theory with weighted derivatives, there is no such deformation, but non-trivial geometric features generate a cosmological-constant term, leading to a de Sitter-Schwarzschild black hole. For both scenarios, we compute the Hawking temperature and comment on the resulting black-hole thermodynamics. In the case with q -derivatives, black holes can be hotter than usual and possess an additional ring singularity, while in the case with weighted derivatives they have a de Sitter hair of purely geometric origin, which may lead to a solution of the cosmological constant problem similar to that in unimodular gravity. Finally, we compare our findings with other Lorentz-violating models.

We use a top-down holographic model for strongly interacting quark matter to study the properties of neutron stars. When the corresponding equation of state (EOS) is matched with state-of-the-art results for dense nuclear matter, we consistently observe a first-order phase transition at densities between 2 and 7 times the nuclear saturation density. Solving the Tolman-Oppenheimer-Volkov equations with the resulting hybrid EOSs, we find maximal stellar masses in excess of two solar masses, albeit somewhat smaller than those obtained with simple extrapolations of the nuclear matter EOSs. Our calculation predicts that no quark matter exists inside neutron stars.

The library of plasmonic nanosystems keeps expanding with novel structures with the potential to provide new solutions to old problems in science and technology. We report the synthesis of a novel plasmonic system based on the growth of gold nanowires radially branching from the surface of silica particles. The nanowires length could be controlled by tuning the molar ratio between metal salt and surface-grafted seeds. Electron microscopy characterization revealed that the obtained one-dimensional nanoparticles are polycrystalline but uniformly distributed on the spherical template. The length of the nanowires in turn determines the optical response of the metallodielectric particles, so that longer wires display red-shifted longitudinal plasmon bands. Accurate theoretical modeling of these complex objects revealed that the densely organized nanowires display intrinsically coupled plasmon modes that can be selectively decoupled upon detachment of the nanowires from the surface of the colloidal silica template., (Copyright © 2014 Elsevier Inc. All rights reserved.)

The concept of protecting groups, widely used in organic chemistry, has been applied for the synthesis of Au-silica Janus stars, in which gold branches protrude from one half of Au-silica Janus spheres. This configuration opens up new possibilities to apply the plasmonic properties of gold nanostars, as well as a variety of chemical functionalizations on the silica component.

Phytase production by Aspergillus niger F3 by solid state fermentation (SSF) on citrus peel was evaluated at pilot scale under different aeration conditions. The best airflow intensity was 1 VkgM (Lair kg medium(-1) min(-1)), which allowed to produce 65 units of phytases per gram in dry basis (65 Ug(-1) d.b.) as it removed the metabolic heat generated by the microorganism, Agitation did not improve heat removal. Airflow intensity was considered as scale-up criterion. When the airflow intensity was maintained at 1 VkgM for SSF with 2 and 20 kg of medium, the kinetics parameters for biomass and enzyme concentration at the end of fermentation differed by less than 2. The air flow intensity was required to maintain the temperature and cool the SSF and to provide oxygen for microbial growth. Air flow intensity is a key a factor that must be considered when scale-up of SSF is attempted., (Copyright © 2012 Elsevier Ltd. All rights reserved.)

This work describes a novel and scalable colloid chemistry strategy to fabricate gold semishells based on the selective growth of gold on Janus silica particles (500 nm in diameter) partly functionalized with amino groups. The modulation of the geometry of the Janus silica particles allows us to tune the final morphology of the gold semishells. This method also provides a route to fabricating hollow gold semishells through etching of the silica cores with hydrofluoric acid. The optical properties were characterized by visible near-infrared (vis-NIR) spectroscopy and compared with simulations performed using the boundary element method (BEM). These revealed that the main optical features are located beyond the NIR region because of the large core size.

Solid-state fermentation (SSF) is defined as the growth of microbes without a free-flowing aqueous phase. The feasibility of using a citrus peel for producing pectinase and xylanase via the SSF process by Aspergillus niger F3 was evaluated in a 2 kg bioreactor. Different aeration conditions were tested to optimize the pectinase and xylanase production. The best air flow intensity was 1 V kg M (volumetric air flow per kilogram of medium), which allowed a sufficient amount of O2 for the microorganism growth producing 265 U/g and 65 U/g pectinases and xylanases, respectively. A mathematical model was applied to determine the different kinetic parameters related to SSF. The specific growth rate and biomass oxygen yield decreased during fermentation, whereas an increase in the maintenance coefficient for the different employed carbon sources was concurrently observed., (Copyright © 2011 Elsevier Ltd. All rights reserved.)