Search

Interest in building dedicated Quantum Information Science and Engineering (QISE) education programs has greatly expanded in recent years. These programs are inherently convergent, complex, often resource intensive and likely require collaboration with a broad variety of stakeholders. In order to address this combination of challenges, we have captured ideas from many members in the community. This manuscript not only addresses policy makers and funding agencies (both public and private and from the regional to the international level) but also contains needs identified by industry leaders and discusses the difficulties inherent in creating an inclusive QISE curriculum. We report on the status of eighteen post-secondary education programs in QISE and provide guidance for building new programs. Lastly, we encourage the development of a comprehensive strategic plan for quantum education and workforce development as a means to make the most of the ongoing substantial investments being made in QISE., Comment: 18 pages, 2 figures, 1 table

We study the time-fluctuating magnetic gradient noise mechanisms in pairs of Si/SiGe quantum dots using exchange echo noise spectroscopy. We find through a combination of spectral inversion and correspondence to theoretical modeling that quadrupolar precession of the $^{73}$Ge nuclei play a key role in the spin-echo decay time $T_2$, with a characteristic dependence on magnetic field and the width of the Si quantum well. The $^{73}$Ge noise peaks appear at the fundamental and first harmonic of the $^{73}$Ge Larmor resonance, superimposed over $1/f$ noise due to $^{29}$Si dipole-dipole dynamics, and are dependent on material epitaxy and applied magnetic field. These results may inform the needs of dynamical decoupling when using Si/SiGe quantum dots as qubits in quantum information processing devices., Comment: 17 pages, 11 figures

Coherent charge-photon and spin-photon coupling has recently been achieved in silicon double quantum dots (DQD). Here we demonstrate a versatile split-gate cavity-coupler that allows more than one DQD to be coupled to the same microwave cavity. Measurements of the cavity transmission as a function of level detuning yield a charge cavity coupling rate $g_c/2\pi$ = 58 MHz, charge decoherence rate $\gamma_c/2\pi$ = 36 MHz, and cavity decay rate $\kappa/2\pi$ = 1.2 MHz. The charge cavity coupling rate is in good agreement with device simulations. Our coupling technique can be extended to enable simultaneous coupling of multiple DQDs to the same cavity mode, opening the door to long-range coupling of semiconductor qubits using microwave frequency photons.

We implement a technique for measuring the singlet-triplet energy splitting responsible for spin-to-charge conversion in semiconductor quantum dots. This method, which requires fast, single-shot charge measurement, reliably extracts an energy in the limits of both large and small splittings. We perform this technique on an undoped, accumulation-mode Si/SiGe triple-quantum dot and find that the measured splitting varies smoothly as a function of confinement gate biases. Not only does this demonstration prove the value of having an $in~situ$ excited-state measurement technique as part of a standard tune-up procedure, it also suggests that in typical Si/SiGe quantum dot devices, spin-blockade can be limited by lateral orbital excitation energy rather than valley splitting., Comment: 18 pages, 9 figures

We demonstrate improved operation of exchange-coupled semiconductor quantum dots by substantially reducing the sensitivity of exchange operations to charge noise. The method involves biasing a double-dot symmetrically between the charge-state anti-crossings, where the derivative of the exchange energy with respect to gate voltages is minimized. Exchange remains highly tunable by adjusting the tunnel coupling. We find that this method reduces the dephasing effect of charge noise by more than a factor of five in comparison to operation near a charge-state anti-crossing, increasing the number of observable exchange oscillations in our qubit by a similar factor. Performance also improves with exchange rate, favoring fast quantum operations., Comment: 10 pages, 8 figures

We report on the fabrication and characterization of a few-electron quantum dot controlled by a single gate electrode. Our device has a double-quantum-well design, in which the doping controls the occupancy of the lower well while the upper well remains empty under the free surface. A small air-bridged gate contacts the surface, and is positively biased to draw laterally confined electrons into the upper well. Electrons tunneling between this accumulation-mode dot and the lower well are detected using a quantum point contact (QPC), located slightly offset from the dot gate. The charge state of the dot is measured by monitoring the differential transconductance of the QPC near pinch-off. Addition spectra starting with N=0 were observed as a function of gate voltage. DC sensitivity to single electrons was determined to be as high as 8.6%, resulting in a signal-to-noise ratio of ~9:1 with an equivalent noise bandwidth of 12.1 kHz. Analysis of random telegraph signals associated with the zero to one electron transition allowed a measurement of the lifetimes for the filled and empty states of the one-electron dot: 0.38 ms and 0.22 ms, respectively, for a device with a 10 nm AlInAs tunnel barrier between the two wells., Comment: 3 pages, 3 figures