Search

The discoloration of uncoated wood surfaces in both outdoor and indoor use in non-heated spaces has become an increasing problem in European timber constructions due to the use of less toxic substances for protection and also changes in outdoor climate conditions, necessitating the use of protective coatings. To investigate the effect of methyl methacrylic (MMA) resin for the protection of wood from discoloration and mould growth, resin-treated wood surfaces were studied in a laboratory-scale mould test, as well as in an outdoor weathering test. Non-modified Scots pine and Norway spruce were used, and some of the test materials were also thermally modified. The resin suppressed mould growth for the laboratory-scale experiments. The protective effect was considerably reduced for outdoor tests. The MA resin did not effectively prevent the wood from greying from ultraviolet (UV) radiation exposure; there was some protective effect detected on the pine. The Fourier transform infrared (FTIR) spectra of weathered specimens showed a reduction of lignin-associated absorption bands for all treatments, which corresponded to the UV degradation and greying of the wood surface. It is suggested that MMA resin may provide adequate protection against mould growth on wood without direct exposure to rain and sunshine (e.g., attics, basements, etc). Validerad;2020;Nivå 2;2020-09-02 (johcin)

The biocidal properties of an industrially used copper-based preservative were evaluated at different planing depths on exposure of pine wood to mold fungi in direct and indirect contamination methods, with simultaneous verification of white rot fungi virulence on wood. The preservative was an aqueous solution of copper carbonate, 2-aminoethanol, and quaternary ammonium compounds. Full cell preservative impregnation efficiency against visual mold fungi growth was tested on sapwood surfaces planed to different depths before impregnation. The virulence of two white rot fungal strains of Trametes versicolor (441 and JPEI) against the dried non-impregnated and impregnated wood samples was also tested. The unplaned surface of impregnated timber was occupied by air-borne contaminants, such as Paecilomyces variottiand Aspergillus niger up to 30%, and, even after impregnation it was necessary to process the surface to avoid micro-fungi settlement. The virulence of the tested rot fungi strains was confirmed by the aggressive degradation of non-impregnated wood with a mass loss of over 40%. Both Trametes sp. strains degraded the preservative-impregnated wood with a mass loss of 3.1% to 4.8%, but degradation by the JPEI strain was more intensive and more dependent on planing depth than the other strain (441). Validerad;2018;Nivå 2;2018-10-30 (svasva)

Wood is a lignocellulosic raw material that is used for a diversity of industrial products. Besides the traditional uses of wood in the construction, pulp- and papermaking and furniture industries, the energy recovery industry based on renewable resources such as wood has been growing strongly during recent years. Like all resources, wood is available only in limited amounts and an increasing demand leads to greater competition among the wood-using industries. By defining a strategic cube it was possible to visualise the impact of the different parameters on the types of wood raw material available. Further, the method supported estimations of the changes in the mix of wood raw materials when one or more of the parameters was changed.The results show that, in addition to the available land and to the climate conditions, the demands of the different sectors of wood-using industries have a strong impact on the amount of raw material available for energy purposes. Climate change and innovation or trends in the wood-using industries, for example, influence silvicultural management, and this then affects the mix of raw materials. The results challenge the studies estimating that large amounts of raw material available for energy purposes relate only to land., Proceedings of the 23rd European Biomass Conference and Exhibition, 1-4 June 2015, Vienna, Austria, pp. 266-269

We present measurements of charged hadron p_T spectra from Au+Au collisions at sqrt(snn)=62.4 GeV for pseudorapidities eta=0, eta=1 and eta=3.2. Around midrapidity (eta=0, eta=1) we find nuclear modification factors at levels suggesting a smaller degree of high p_T suppression than in the same reaction at higher energy sqrt(snn)=200 GeV. At the high pseudorapidity, eta=3.2, where nuclear modification factors cannot be constructed due to the lack of p+p reference data, we find a significant reduction of R_{CP} (central to peripheral ratio) as compared to midrapidity.

We present a measurement of π−/π+π−/π+, K−/K+K−/K+ and p¯/p from p+pp+p collisions at s=200 GeV over the rapidity range 02.0y>2.0. The p¯/p ratio is very similar for p+pp+p and 20% central Au + Au collisions at all rapidities. In the fragmentation region the three ratios seem to be independent of beam energy when viewed from the rest frame of one of the protons. Theoretical models based on quark–diquark breaking mechanisms overestimate the p¯/p ratio up to y≲3y≲3. Including additional mechanisms for baryon number transport such as baryon junctions leads to a better description of the data. publishedVersion

Particle production of identified charged hadrons, $\pi^{\pm}$, $K^{\pm}$, $p$, and $\bar{p}$ in Au+Au collisions at $\sqrt(snn) =$ 200 GeV has been studied as a function of transverse momentum and collision centrality at $y=0$ and $y\sim1$ by the BRAHMS experiment at RHIC. Significant collective transverse flow at kinetic freeze-out has been observed in the collisions. The magnitude of the flow rises with the collision centrality. Proton and kaon yields relative to the pion production increase strongly as the transverse momentum increases and also increase with centrality. Particle yields per participant nucleon show a weak dependence on the centrality for all particle species. Hadron production remains relatively constant within one unit around midrapidity in Au+Au collisions at $\sqrt(snn) =$ 200 GeV., Comment: 52 authors, 8 pages, 12 Figures, 3 Tables, submitted to PRC

We have measured rapidity densities dN/dy of pions and kaons over a broad rapidity range (-0.1 < y < 3.5) for central Au+Au collisions at sqrt(snn) = 200 GeV. These data have significant implications for the chemistry and dynamics of the dense system that is initially created in the collisions. The full phase-space yields are 1660 +/- 15 +/- 133 (pi+), 1683 +/- 16 +/- 135 (pi-), 286 +/- 5 +/- 23 (K+) and 242 +/- 4 +/- 19 (K-). The systematics of the strange to non--strange meson ratios are found to track the variation of the baryo-chemical potential with rapidity and energy. Landau--Carruthers hydrodynamic is found to describe the bulk transport of the pions in the longitudinal direction., 4 pages, 4 figures, 1 table, submitted to Physical Review Letters. Updates : data are now corrected for feed down from Lambda and K0short decays, figures and tables show the corrected data. The text has been cleared and details on corrections to the data added

Charged-particle pseudorapidity densities are presented for the d+Au reaction at sqrt{s_{NN}}=200 GeV with -4.2, 4 pages, 3figures; expanded discussion of uncertainties; added 60-80% centrality range; added additional discussion on centrality selection bias

BRAHMS has the ability to study relativistic heavy ion collisions from the final freeze-out of hadrons all the way back to the initial wave-function of the gold nuclei. This is accomplished by studying hadrons with a very wide range of momenta and angles. In doing so we can scan various phases of QCD, from a hadron gas, to a quark gluon plasma and perhaps to a color glass condensate., 8 pages, 6 figures, proceedings of plenary talk at Quark Matter 2004 conference

The BRAHMS experiment at RHIC has measured the production of charged hadrons as a function of pseudorapidity and transverse momentum in Au+Au, d+Au and p+p collisions at a common energy of sqrt(s_NN)=200GeV, and from these spectra we construct the nuclear modification factors for both ``hot'' and ``cold'' nuclear matter. In this contribution I will show how these factors evolve with pseudorapidity and collision centrality. We see a Cronin-like enhancement in d+Au collisions at midrapidity, going to a strong suppression at eta >= 2. In central Au+Au collisions we find a suppression both at mid- and forward rapidities that vanishes for peripheral collisions. We interpret this as signs of several different medium related effects modifying bulk particle production in Au+Au and d+Au collisions at RHIC energies., 6 pages, 6 figures, prepared for the proceedings of the XLII International Winter Meeting on Nuclear Physics, Bormio, 2004