Search

The presence of organic micropollutants in water and sediments motivates investigation of their biotransformation at environmentally low concentrations, usually in the range of μg L -1 . Many are biotransformed by cometabolic mechanisms; however, there is scarce information concerning their direct metabolization in this concentration range. Threshold concentrations for microbial assimilation have been reported in both pure and mixed cultures from different origins. The literature suggests a range value for bacterial growth of 1-100 μg L -1 for isolated aerobic heterotrophs in the presence of a single substrate. We aimed to investigate, as a model case, the threshold level for sulfamethoxazole (SMX) metabolization in pure cultures of Microbacterium strain BR1. Previous research with this strain has covered the milligram L -1 range. In this study, acclimated cultures were exposed to concentrations from 0.1 to 25 μg L -1 of 14 C-labeled SMX, and the 14 C-CO 2 produced was trapped and quantified over 24 h. Interestingly, SMX removal was rapid, with 98% removed within 2 h. In contrast, mineralization was slower, with a consistent percentage of 60.0 ± 0.7% found at all concentrations. Mineralization rates increased with rising concentrations. Therefore, this study shows that bacteria are capable of the direct metabolization of organic micropollutants at extremely low concentrations (sub μg L -1 ).

The masking of specific effects in in vitro assays by cytotoxicity is a commonly known phenomenon. This may result in a partial or complete loss of effect signals. For common in vitro assays, approaches for identifying and quantifying cytotoxic masking are partly available. However, a quantification of cytotoxicity-affected signals is not possible. As an alternative, planar bioassays that combine high-performance thin layer chromatography with in vitro assays, such as the planar yeast estrogen screen (p-YES), might allow for a quantification of cytotoxically affected signals. Affected signals form a typical ring structure with a supressed or completely lacking centre that results in a double peak chromatogram. This study investigates whether these double peaks can be used for fitting a peak function to extrapolate the theoretical, unaffected signals. The precision of the modelling was evaluated for four individual peak functions, using 42 ideal, undistorted peaks from estrogenic model compounds in the p-YES. Modelled ED 50 -values from bisphenol A (BPA) experiments with cytotoxically disturbed signals were 13 times higher than for the apparent data without compensation for cytotoxicity (320 ± 63 ng versus 24 ± 17 ng). This finding has a high relevance for the modelling of mixture effects according to concentration addition that requires unaffected, complete dose-response relationships. Finally, we applied the approach to results of a p-YES assay on leachate samples of an elastomer material used in water engineering. In summary, the fitting approach enables the quantitative evaluation of cytotoxically affected signals in planar in vitro assays and also has applications for other fields of chemical analysis like distorted chromatography signals., (© 2024. The Author(s).)

Current knowledge about how biochars affect the fate of pesticides in soil is based on studies that used pure biochars. After finding that an additional biological post-pyrolysis treatment, such as co-composting or lactic fermentation, is required for biochars for superior performance in temperate arable soils, a knowledge gap formed of how such further processed biochar products would affect the fate of pesticides in soil. This study compared the effects of a novel fermented biochar alone or mixed with biogas residues on the fate of two pesticides, 4-chloro-2-methylphenoxyacetic acid (MCPA) and metalaxyl-M, in a temperate arable soil to the traditional organic amendments wheat straw and compost. The fate of 14 C-labeled MCPA was markedly affected in different ways. Fermented biochar effectively reduced the water-extractability and mineralization due to adsorption that was comparable to adsorption strengths reported for pure biochars. However, this effect was weak for the biochar mixed with biogas residues. Straw reduced water-extractable amounts due to increased biodegradation and formation of likely biogenic non-extractable residues of MCPA. In contrast, compost decelerated mineralization and increased the water solubility of the MCPA residues due to released dissolved organic matter. The amendments' effects were minor regarding 14 C-metalaxyl-M, except for the fermented biochar which again reduced water-extractability and delayed degradation due to adsorption. Thus, the effects of the organic amendments differed for the two pesticide compounds with only the fermented biochar's effect being similar for both. However, this effect was no longer present in the mixed product containing 20% biochar. Our findings clearly show that biologically treated biochar-containing products can affect the fate of pesticides in soil very differently, also when compared to traditional organic amendments. Such impacts and their desirable and undesirable ecotoxicological implications need to be considered before the large-scale application of biochars to temperate arable soils., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2023 The Authors. Published by Elsevier Ltd.. All rights reserved.)

Urban runoff contains a range of organic micropollutants which, if not removed during wastewater treatment, pose a risk to aquatic environments. These mixtures are complex and often site-specific. Street drains provide an ideal sampling point given they collect the runoff from local and defined catchments. In this study, runoff was collected and sampled in five street drains located in a medium sized town in Germany. A specially constructed trap was used to collect the particulate and total water fractions of the runoff. In addition, passive samplers were deployed to determine the freely dissolved concentrations of selected compounds in the runoff. In sum, 187 polar organic micropollutants could be quantified using LC-HRMS. Thirty of these could only be detected by the use of passive samplers. Traffic derived pollutants such as corrosion inhibitors, rubber- and plastic additives, but also pollutants of industrial origin were strongly represented with sum median concentrations of 100 μg/kg dry weight (DW) in the sediment and 400 ng/L in the water fraction. Several of these substances are of concern due to their environmental persistence and mobility. Perfluorinated compounds and pesticides occurred at lower levels of several μg/kg DW sediment or ng/L water. A number of substances including pharmaceuticals, sweeteners and stimulants indicated domestic wastewater influences. Furthermore, a total of 62 parent and alkylated PAHs were quantified by GC-MS and contributed 30-70% to the sum concentrations of the micropollutants. Non-EPA PAHs dominated the carcinogenic PAH toxicity. The increased PAH alkylation indices (0.7-0.9) showed these primarily came from combustion sources. The runoff particles were additionally microscopically characterized, and correlations were found between the rubber particle counts and the PAH alkylation-index as well as the levels of 2-(methylthio)benzothiazole, a marker compound for tire leaching., (Copyright © 2022 Elsevier Ltd. All rights reserved.)

In the last decade, mirtazapine has become an important antidepressant in clinical use and has also been found at many different environmental sampling sites. Several homologies between the zebrafish Danio rerio and humans, combined with a number of advantages for behavioural and gene expression research using zebrafish embryos, make their use for the analysis of mirtazapine appropriate. The sedative effect of mirtazapine in humans was also found for a specific concentration range in zebrafish embryos (1333.4 μg/L - 2666.9 μg/L). Specifically, 116 hpf old zebrafish embryos showed a reduced swimming distance when exposed to 1334.4 μg/L mirtazapine. Furthermore, changes at the gene regulatory level could be measured (1333.4 μg/L), in particular in the superordinate regulatory systems. For selected transporters of all regulatory systems, an up regulation of the genes by a factor of more than five times could be measured at the highest mirtazapine exposure concentration that was tested. Finally, studies on the protein levels demonstrated an increase in acetylcholinesterase activity for several exposure concentrations (83.3 μg/L and 666.7 μg/L). The physiological changes in zebrafish embryos caused by mirtazapine demonstrate the relevance of these types of studies in aquatic non-target organisms. Such neuroactive substances could pose a potential risk for aquatic organisms below the previously considered concentration threshold for morphological effects., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2021. Published by Elsevier B.V.)

Toxicity results from exposure to mixtures of organic contaminants. Assessing this using ecotoxicity bioassays involves sampling of the environmental mixture and then introducing this into the test. The first step is accounting for the bioavailable levels of all mixture constituents. Passive sampling specifically targets these bioavailable fractions but the sampler-accumulated mixture varies with the compound and sampler properties as well as time. The second step involves reproducing and maintaining the sampled mixture constituents in the bioassay. Passive sampler extraction and spiking always leads to a skewed mixture profile in the test. Alternatively, the recovered passive samplers might be directly used in passive dosing mode. Here, the reproduced contaminant mixture depends on whether kinetic or equilibrium sampling applies. These concepts were tested for determining the combined toxicity of laboratory and field mixtures of aquatic contaminants in the Microtox and ER-Calux bioassays. Aqueous sample extraction and spiking, passive sampler extraction and spiking, and passive sampling and dosing were compared for first sampling and then introducing mixtures in toxicity bioassays. The analytical and toxicity results show that the correct way to first sample the bioavailable mixture profile, and then to reproduce and maintain this in the toxicity test, is by combining equilibrium passive sampling and dosing.

The emission of nutrients and pesticides from agricultural soils endangers natural habitats. Here, we review to which extent carbon-rich organic amendments help to retain nutrients and pesticides in agricultural soils and to reduce the contamination of surrounding areas and groundwater. We compare straw, compost, and biochar to see whether biochar outperforms the other two more traditional and cheaper materials. We present a list of criteria to evaluate the suitability of organic materials to be used as soil amendments and discuss differences in elemental compositions of straw, compost, and biochar to understand, how soil microorganisms utilize those materials. We review their effects on physical and chemical soil characteristics, soil microbial communities, as well as effects on the transformation and retention of nutrients and pesticides in detail. It becomes clear that for all three amendments their effects can vary greatly depending on numerous aspects, such as the type of soil, application rate, and production procedure of the organic material. Biochar is most effective in increasing the sorption capacity of soils but does not outperform straw and compost with regards to the other aspects investigated. Nevertheless, the possibility to design biochar properties makes it a very promising material. Finally, we provide critical comments about how to make studies about organic amendments more comparable (comprehensive provision of material properties), how to improve concepts of future work (meta-analysis, long-term field studies, use of deep-insight microbial DNA sequencing), and what needs to be further investigated (the link between structural and functional microbial parameters, the impact of biochar on pesticide efficiency)., Competing Interests: Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 The Authors. Published by Elsevier B.V. All rights reserved.)

The use of single-phase passive samplers is a common method for sampling bioavailable concentrations of hydrophobic aquatic pollutants. Often such samplers are used in the kinetic stage, and in situ calibration is necessary. Most commonly, exchange kinetics are derived from the release rates of performance reference compounds (PRCs). In this study, a complementary calibration approach was developed, in which measuring the contaminant mass ratio (CMR) from two samplers with different thicknesses allows the dissolved concentrations to be determined. This new CMR calibration was tested (1) in a laboratory experiment with defined and constant concentrations and (2) in the field, at a storm water retention site. Silicone passive samplers with different thicknesses were used to sample a range of dissolved polycyclic aromatic hydrocarbons. In the laboratory study, the concentrations derived from the CMR calibration were compared with those from water extraction and passive dosing and differences below a factor 2 were found. In the field study, CMR-derived concentrations were compared to those from PRC calibration. Here, differences ranged by only a factor 1 to 3 between both methods. These findings indicate that the CMR calibration can be applied as a stand-alone or complementary calibration method for kinetic passive sampling.

Cetyl-trimethylammonium bromide (CTAB) is a widely used cationic surfactant that is biodegradable in nature. CTAB biodegradation requires hydroxylation in the first step, which is rate-limiting and crucial for solubility in water. In this study, the OmniChange multi-site mutagenesis method was applied to reengineer the P450 BM3 substrate specificity towards the hydroxylation of CTAB by simultaneous mutagenesis of four previously reported positions (R47, Y51, F87, and L188). 1740 clones from the P450 BM3 OmniChange library were screened with the NADPH depletion assay. A total of 696 clones were rescreened with the NADPH depletion and an Ampliflu™ Red/ horseradish peroxidase based H 2 O 2 detection assay. Several improved P450 BM3 variants were identified and finally four were kinetically characterized with respect to CTAB hydroxylation, based on both performance and coupling efficiency. Based on NADPH consumption, the P450 BM3 variant P3A8 (R47E/Y51M/F87V/L188E) displayed an initial activity (64.9±4.8 s -1 , 13.5-fold increased activity compared with wild-type P450 BM3), which nearly matches the specific activity for its natural fatty acid substrate (palmitic acid (32-122 s -1 )). Variant P3A8 showed high coupling efficiency (92.5 %), whereas wild-type P450 BM3 displayed a low coupling efficiency (0.5 %). HPLC-MS/MS detection confirmed that P3A8 and P2E7 (R47D/Y51L/F87V/L188A) form 13 and 35 times more 2-hydroxylated CTAB than P450 BM3. In addition, di-hydroxylated CTAB products were detected for all four investigated P450 BM3 variants (up to a yield of 77 %; P3A8). Di-hydroxylated quaternary amines are highly interesting bolaform surfactants with a high hydrophilicity (surface contact angle: θ=16.7°)., (© 2018 Wiley-VCH Verlag GmbH & Co. KGaA, Weinheim.)

Toxicity testing using in vitro bioassays is assuming an increasingly important role. Nevertheless, several issues remain with regard to their proper application, which mainly relate to the proper definition and control of the test chemical(s) concentrations to which the cells or tissues are exposed. This has fundamental implications for understanding the underlying relationship between the in vitro exposure regime and response, and leads to uncertainty in the resulting bioassay data. This chapter covers the definition and control of exposure of hydrophobic organic chemicals (HOCs) in in vitro bioassays aimed at measuring their toxicity. A review of the fate of HOCs in typical in vitro set-ups is followed by a discussion of how to define the test exposure. Currently applied approaches for introducing HOCs into in vitro bioassays are then related to these different definitions of test exposure. Finally, passive dosing as one possible approach for giving defined and constant dissolved concentrations of HOCs in in vitro toxicity tests is introduced, using examples taken from the literature, and how this might be better integrated into high throughput in vitro toxicity testing is discussed.