Search

Anterior cruciate ligament (ACL) rupture is a very common knee joint injury. Torn ACLs are currently reconstructed using tendon autografts. However, half of the patients develop osteoarthritis (OA) within 10 to 14 years postoperatively. Proposedly, this is caused by altered knee kine(ma)tics originating from changes in graft mechanical properties during the in vivo remodeling response. Therefore, the main aim was to use subject-specific finite element knee models and investigate the influence of decreasing graft stiffness and/or increasing graft laxity on knee kine(ma)tics and cartilage loading. In this research, 4 subject-specific knee geometries were used, and the material properties of the ACL were altered to either match currently used grafts or mimic in vivo graft remodeling, i.e., decreasing graft stiffness and/or increasing graft laxity. The results confirm that the in vivo graft remodeling process increases the knee range of motion, up to >300 percent, and relocates the cartilage contact pressures, up to 4.3 mm. The effect of remodeling-induced graft mechanical properties on knee stability exceeded that of graft mechanical properties at the time of surgery. This indicates that altered mechanical properties of ACL grafts, caused by in vivo remodeling, can initiate the early onset of osteoarthritis, as observed in many patients clinically.

Decellularization of animal tissues is a novel route to obtain biomaterials for use in tissue engineering and organ transplantation. Successful decellularization is required as animal DNA causes inflammatory reactions and contains endogenous retroviruses, which could be transmitted to the patient. One of the criteria for successful decellularization is digestion (fragmentation) and elimination (residual quantity) of DNA from the tissue. Quantification of DNA can be done in many ways, but it has recently been shown that silica-based solid-phase extraction methods often do not completely purify in particular small DNA fragments. In the context of decellularization, this means that the measured DNA amount is underestimated, which could compromise safety of the processed tissue for in-patient use. In this article, we review DNA quantification methods used by researchers and assess their influence on the reported DNA contents after decellularization. We find that underestimation of residual DNA amount after silica-based solid-phase extraction may be as large as a factor of ten. We therefore recommend a direct assessment of DNA amount in tissue lysate using dsDNA-specific binding dyes, such as Picogreen, due to their higher accuracy for small fragment detection as well as ease of use and widespread availability.