Search

Your search keyword '"Sun, Shaoni"' showing total 125 results
Start Over Author "Sun, Shaoni"
125 results on '"Sun, Shaoni"'

32. The influence of initial deflection angle on the tribological properties of gray cast iron rings with curve distributed pits under dry sliding.

Author

Sun, Shaoni, Long, Risheng, Zhang, Yimin, and Li, Manhong

Abstract

This study presents the influence of initial deflection angle (IDA) on the tribological properties of gray cast iron (GCI) rings with curve distributed pits in the radial direction (CDPRD). The thermal behavior of pits textured GCI rings with different initial deflection angles (0°, 30°, 45°, 60°, 75°) and fixed deflexional angle of adjacent pits (DAAP, 10°) were researched, through APDL programming. A pin-on-disc wear test rig was used to reveal the anti-wear performance of samples under dry sliding, at a rotating speed of 200 rpm, with a normal load of 70 N. An electronic balance and an optical microscope (OM) were used to obtain their wear losses and worn surfaces, respectively. The results show that: comparing with the smooth GCI ring, there are evident high temperature regions between two adjacent pits groups, called "temperature barrier and separation effect". Among all textured samples, the von Mise's stress of IDA45 is the most stable, and its temperature is almost the lowest. The friction coefficient curve and the wear loss of IDA45 are also the lowest, and much lower than the loss of smooth GCI ring, indicating the excellent anti-wear performance. This work can provide a valuable reference for the surface design of journal bearings. [ABSTRACT FROM AUTHOR]

Published
2021
Full Text
View/download PDF

33. Wear behavior of pits textured grey cast iron rings with Zr/ZrN coatings under dry sliding.

Author

Long, Risheng, Sun, Shaoni, and Zhang, Youwei

Abstract

This study presents the influence of Zr/ZrN coatings on the tribological performance of pits textured grey cast iron parts under dry sliding. A laser marking system and a physical vapor deposition equipment were applied to manufacture pits textured grey cast iron rings combined with Zr/ZrN coatings. A pin-on-disc wear test rig was used to reveal the wear behavior of samples under dry wear condition, at a rotating speed of 200 r/min, with a normal load of 70 N. The wear losses and the worn surfaces of all rings were obtained by an electronic balance and a three-dimensional surface profilometer, respectively. The results show that Zr/ZrN coatings can significantly increase the surface roughness and surface hardness of grey cast iron rings. As a result, Zr/ZrN coatings increase the friction coefficients of all coated GCI rings, and reduce the wear losses of some ones. In this work, when surface texturing combines with Zr/ZrN coatings, the final tribological properties of coated grey cast iron rings may be either improved or deteriorated, depending on surface characteristics, texturing parameters and loads. Compared with the uncoated smooth grey cast iron ring, Zr/ZrN coatings cannot effectively improve the wear behavior of pits textured samples. Among all coated grey cast iron rings, when the diameter of the pit is 0.8 mm, and the distance between pits is 1.25 mm, the pits textured grey cast iron ring can provide the optimal anti-wear performance. This work would provide a valuable reference for the surface design of journal bearings and roller bearings. [ABSTRACT FROM AUTHOR]

Published
2021
Full Text
View/download PDF

Catalog

Books, media, physical & digital resources
See catalog results