Search

Your search keyword '"Suwas, Satyam"' showing total 1,241 results
Start Over Author "Suwas, Satyam"
1,241 results on '"Suwas, Satyam"'

20. Microstructural stability and mechanical properties of the as-cast and heat-treated newly developed TiNbCrTa refractory complex concentrated alloy.

Author

Gupta, Aman, Shankar, Gyan, Pawar, Saurabh, Choi, Shi-Hoon, and Suwas, Satyam

Subjects
ENERGY dispersive X-ray spectroscopy, LAVES phases (Metallurgy), HEAT treatment, ELECTRON diffraction, COMPRESSIVE strength
Abstract

In this study, a TiNbCrTa refractory complex concentrated alloy (RCCA) was prepared using vacuum arc remelting. The microstructural evolution and mechanical properties of both as-cast and heat-treated RCCA samples were analyzed. Heat treatment (HT) was performed at 800–1200 °C for 1 h in a vacuum-sealed environment. These samples exhibited a formation of Cr2Nb and Cr2Ti Laves phases. A variation in elemental distribution was observed, with interdendritic (ID) regions showing higher fractions of Ti and Cr, while the dendritic regions had a greater concentration of Ta and Nb. Micro-segregation at the IDs was confirmed through energy dispersive x-ray spectroscopy mapping, which inferred the formation of Cr- and Ti-rich phases during HT at 800–1200 °C. High-temperature HT at 1200 °C for 1 h led to the evolution of the hcp omega phase. Prolonged HT at 1200 °C for 96 h resulted in the evolution of a Cr-rich Laves phase (Cr2Ta), which was homogeneously distributed within the microstructure, indicating an unstable microstructure. Furthermore, despite prolonged HT, a variation in the elemental distribution persisted due to the presence of dendritic and ID regions. Electron backscattered diffraction analysis revealed the presence of bcc and hcp phases in the dendritic and ID regions, respectively, of the as-cast and HTed samples. The as-cast samples demonstrated a high compressive strength of approximately 2 GPa. Micro-hardness values increased with the HT temperature up to 1000 °C. Further increases under HT conditions did not significantly reduce the microhardness value, whereas prolonged HT at 1200 °C led to an increase in the microhardness value. Overall, the newly developed TiNbCrTa RCCA exhibited high-strength behavior even after the phase transformation. [ABSTRACT FROM AUTHOR]

Published
2024
Full Text
View/download PDF

43. Evolution of texture and microstructure during accumulative roll bonding of aluminum AA5086 alloy

Author

Roy, Shibayan, D., Satyaveer Singh, Suwas, Satyam, Kumar, S., and Chattopadhyay, K.

Subjects
Physics - Applied Physics, Condensed Matter - Materials Science
Abstract

In the present investigation, a strongly bonded strip of an aluminium-magnesium based alloy AA5086 is successfully produced through accumulative roll bonding (ARB). A maximum of up to eight passes has been used for the purpose. Microstructural characterization using electron backscatter diffraction (EBSD) technique indicates the formation of submicron sized (~200-300 nm) subgrains inside the layered microstructure. The material is strongly textured where individual layers possess typical FCC rolling texture components. More than three times enhancement in 0.2% proof stress (PS) has been obtained after 8 passes due to grain refinement and strain hardening, Comment: 13 pages, 9 figures

Published
2017
Full Text
View/download PDF

Catalog

Books, media, physical & digital resources
See catalog results