Search

This work deals on industrial electrical power quality improvement using an active power filter (APF) based on fuzzy logic controller. The studied system is a PV conversion chain used to supply linear and non-linear industrial loads of 200 kw plant. The PV station is modeled then simulated under Matlab Simulink, with standard conditions consideration in the first time then under real irradiation and sun power variation during the day hours, to obtain the true parameters design of the PV station to be able to give the needed power during the climatic conditions changing. APF parameters design and control loop structure are well studied to have an optimal control. MPPT technique is used in PV station control with the P&O algorithm. Also PV panel fault diagnosis has been done by using alarm for fault indicator and protection over under power. Simulation results are analyzed and discussed comparison with real signals, produced by the FLUK 6001B reference source with the use of the PRS 600 and the Teledyne 3,5 GHz-40Gs/s oscilloscope as measurement instrument, to improve the effectiveness of APF on electrical power quality, THD, amelioration and harmonic minimization in the industrial installation. [ABSTRACT FROM AUTHOR]

This paper focuses on regulation of the parallel active power filter (APF) Dc Voltage bus by judicious choice of rule bases and intervals for each selected fuzzy variable of suitable fuzzy logic controller. In addition, an algorithm describes the main steps for designing an FLC that has any number of rules with direct application to the APF capacitor voltage regulation. Where their simulation, by MATLAB, applied to PV conversion chain network will be represented in the booths cases, constant and variable non-linear loads after modeling, to show the effectiveness of this kind of regulators on electrical power quality and improve the reliability of the APF on PV system. The delivered voltage of PV plant has been regulated and controlled with MPPT using P&O technique and FLC regulator after modeling of each part of the conversion chain. PV plant supplies a nonlinear load from the rectifier installed on the output of the conversion chain via a controlled power inverter. A 3 × 3 rules fuzzy regulator is implanted in the control part of the APF to examine the influence of the FLC on the produced electrical power quality. Simulation results are represented and analyzed.

The European Community has named five emergencies as being priorities. These five emergencies are: the cardiorespiratory arrest, the myocardial infarction, the severe polytrauma, the cerebral vascular accident and the severe acute dyspnoea. In this article three of them are discussed. Seen with the eyes of a generalist the severe polytrauma requires simple gestures, such as an early call for help by the SMUR, axialisation of head, trunk and members, compression of overtly sources of bleeding and opening the airway to facilitate breathing. The acute myocardial infarction continues to pose problems of diagnosis. The pathognomonic presentations are the STEMI and the N-STEMI infarction. In these cases it is a priority to call for the help of a SMUR unit. In the case of a STEMI infarction it is an absolute priority to admit the patient quickly to hospital and to directly move on to the coronarography ward for a primary angioplasty procedure. Within the first three hours of the infarction, if primary angioplasty is not a possibility within the first 90 minutes, thrombolysis is absolutely indicated. In the case of N-STEMI infarction a quick admission to a coronary care unit is urgent but the treatment is mainly medical. The cerebral vascular incident occurs more frequently than the myocardial infarction, but, culturally, not enough importance is attached to this pathology. Within the first three hours the aim is to get the patient to an emergency department (by means of the SMUR), to evaluate the coagulation values of the patient and to perform a head scan (without the injection of contrast) of good quality. If the patient is not too severely incapacitated (NIH score between 4 and 25), if the head scan does not show a hemorrhagic lesion and if there is no contraindication for thrombolysis, Actilyse should be administered. The time it takes to do all of these acts can not exceed the above mentioned three hours.