Search

Magnetic-field-dependent unpolarized small-angle neutron scattering (SANS) experiments demonstrate that high-pressure torsion (HPT) straining induces spin misalignments in pure Ni, which persist in magnetic fields up to 4 T. The spin-misalignment scattering patterns are elongated perpendicular to the applied magnetic field due to an unusual predominant longitudinal $sin^2(\theta)$-type angular anisotropy. Such a contribution cannot be explained by the conventional second order (in spin misalignment amplitude) micromagnetic SANS theory in the approach-to-saturation regime, nor can its magnitude relative to the other features of the cross sections by the third order micromagnetic SANS theory. This indicates that the high-density of crystal defects induced via HPT straining in Ni makes such higher-order effects in the micromagnetic SANS cross sections observable., Comment: 9 figures

We combine magnetometry and magnetic small-angle neutron scattering to study the influence of the microstructure on the macroscopic magnetic properties of a nanocrystalline Ni bulk sample, which was prepared by straining via high-pressure torsion. As seen by magnetometry, the mechanical deformation leads to a significant increase of the coercivity compared to nondeformed polycrystalline Ni. The neutron data reveal a significant spin-misalignment scattering caused by the high density of crystal defects inside the sample, which were created by the severe plastic deformation during the sample preparation. The corresponding magnetic correlation length, which characterizes the spatial magnetization fluctuations in real space, indicates an average defect size of 11 nm, which is smaller than the average crystallite size of 60 nm. In the remanent state, the strain fields around the defects cause spin disorder in the surrounding ferromagnetic bulk, with a penetration depth of around 22 nm. The range and amplitude of the disorder is systematically suppressed by an increasing external magnetic field. Our findings are supported and illustrated by micromagnetic simulations, which, for the particular case of nonmagnetic defects (holes) embedded in a ferromagnetic Ni phase, further highlight the role of localized spin perturbations for the magnetic microstructure of defect-rich magnets such as high-pressure torsion materials., Comment: This is the version of the article accepted for publication in Physical Review Materials including all changes made as a result of the peer review process, and which may also include the addition to the article by APS of a header, an article ID, a cover sheet and/or an Accepted Manuscript watermark, but excluding any other editing, typesetting or other changes made by APS and/or its licensors

Reducing the coefficient of boundary friction on steel surfaces is one of key technologies to improve the efficiency of machines such as automotive engines. It has been shown that the boundary friction on nanostructured steel surfaces in the sliding test using hydrocarbon lubricant molecules is smaller than the friction of normal steel surfaces. The main difference between the nanostructured and a normal surfaces is the density of grain boundaries and other surface defects. The surface defect can attract lubricant molecules and enhance lubricating film formation on metal surfaces. This can be one of the mechanisms that induce the friction reduction on the nanosructured steel surface. In this work, using first principles calculations, the adsorbability of a lubricant molecule, a fatty acid, on a defected iron surfaces has been studied. Adsorbability of the Fe(110) surface with symmetrical tilt {\Sigma}3(111) grain boundary was compared to that of the clean Fe(110) surface. As a result, we found that the molecule is adsorbed on sites close to the grain boundary more strongly (0.77 eV in average) than on the Fe surface without grain boundary., Comment: 11 pages, 6 figures