Search

In this study, a new method for determining the elastic constants of isotropic plates using Lamb wave fundamental modes is presented. This method solves the inverse problem, where the elastic constants (Young's modulus and Poisson's ratio) of the plate were estimated by measuring the phase velocities of the Lamb wave using the Rayleigh–Lamb equations to find the solution and determining the phase velocities of the A0 and S0 modes using a new method. The suitability of the proposed method for determining the elastic constants was evaluated using simulated and experimental signals propagating on an aluminum plate. The theoretical modeling on the aluminum 7075-T6 plate shows that the proposed method allows the determination of the Poisson ratio with a relative error not exceeding 2% and Young's modulus with a relative error not exceeding 0.5%. The experimental measurements of an aluminum plate of known thickness (2 mm) and density (2685 kg/m3) confirmed the suitability of the proposed method for the measurements of elastic constants. In the proposed method, the processing of ultrasonic signals can be performed in real-time, and the values of the elastic constants can be obtained immediately after scanning the required distance. [ABSTRACT FROM AUTHOR]

Determining Lamb wave dispersion curves when measuring phase and group velocity values at a fixed frequency is now a common and relevant task. In most cases, in order to solve such a problem, it is necessary to know the exact properties of the material, particularly its thickness. In experimental methods, Lamb wave parameters are evaluated directly from the test materials. This paper proposes a new and simple experimental algorithm for A0 mode group and phase velocity determination based on signal filtering and zero-crossing estimating. The main idea is to capture the zero-crossing instances of the signals closest to the signal envelope peaks and use these time instances to determine the phase and group velocities. The reliability of the proposed method was evaluated using simulated and experimental signals propagating in an aluminum plate. Theoretical modeling has shown that the proposed method enables the calculation of the A0 mode group and phase velocities with a mean relative error of less than 0.7%. An accuracy of 0.8% was observed during the experimental measurements. [ABSTRACT FROM AUTHOR]

The ultrasonic testing technique using Lamb waves is widely used for the non-destructive testing and evaluation of various structures. For air-coupled excitation and the reception of A 0 mode Lamb waves, leaky guided waves are usually exploited. However, at low frequencies (<100 kHz), the velocity of this mode in plastic and composite materials can become slower than the ultrasound velocity in air, and its propagation in films is accompanied only by an evanescent wave in air. To date, the information about the attenuation of the slow A 0 mode is very contradictory. Therefore, the objective of this investigation was the measurement of the attenuation of the slow A 0 mode in thin plastic films. The measurement of the attenuation of normal displacements of the film caused by a propagating slow A 0 mode is discussed. The normal displacements of the film at different distances from the source were measured by a laser interferometer. In order to reduce diffraction errors, the measurement method based on the excitation of cylindrical but not plane waves was proposed. The slow A 0 mode was excited in the polyvinylchloride film by a dry contact type ultrasonic transducer made of high-efficiency PMN-32%PT strip-like piezoelectric crystal. It was found that that the attenuation of the slow A 0 mode in PVC film at the frequency of 44 kHz is 2 dB/cm. The obtained results can be useful for the development of quality control methods for plastic films.