Search

This study undertakes a comprehensive experimental and numerical analysis of the structural integrity of buried RC sewerage pipes, focusing on the performance of two distinct jointing materials: cement mortar and non-shrinkage grout. Through joint shear tests on full-scale sewer pipes under single point loading conditions, notable effects on the crown and invert of the joint were observed, highlighting the critical vulnerability of these structures to internal and external pressures. Two materials—cement–sand mortar and non-shrinkage grout—were used in RC pipe joints to experimentally evaluate the joint strength of the sewerage pipes. Among the materials tested, cement–sand mortar emerged as the superior choice, demonstrating the ability to sustain higher loads up to 25.60 kN, proving its cost-effectiveness and versatility for use in various locations within RC pipe joints. Conversely, non-shrinkage grout exhibited the lowest ultimate failure load, i.e., 21.50 kN, emphasizing the importance of material selection in enhancing the resilience and durability of urban infrastructure. A 3D finite element (FE) analysis was also employed to assess the effect of various factors on stress distribution and joint deformation. The findings revealed a 10% divergence between the experimental and numerical data regarding the ultimate load capacity of pipe joints, with experimental tests indicating a 25.60 kN ultimate load and numerical simulations showing a 23.27 kN ultimate load. Despite this discrepancy, the close concordance between the two sets of data underscores the utility of numerical simulations in predicting the behavior of pipe joints accurately. This study provides valuable insights into the selection and application of jointing materials in sewerage systems, aiming to improve the structural integrity and longevity of such critical infrastructure.

Geopolymer concrete is preferred over OPC due to its use of energy waste such as fly ash, making it more sustainable and energy-efficient. However, limited research has been done on its seismic characterization in confined masonry, highlighting a gap in sustainable earthquake-resistant structures. Our study compares the performance of alkali-activated fly-ash-based geopolymer concrete bare frame and confined masonry wall panels with conventional concrete. Experimental results showed that geopolymer concrete bare frame has 3.5% higher initial stiffness and 1.0% higher lateral load-bearing capacity compared to conventional concrete. Geopolymer concrete confined masonry exhibited 45.2% higher initial stiffness and 4.1% higher ultimate seismic capacity than traditional concrete. The experimental results were verified using a numerical simulation technique with ANSYS-APDL, showing good correlation. Comparison with previously tested masonry walls revealed that GPC confined masonry has similar structural behavior to cement concrete masonry. This study demonstrates that geopolymer concrete made from waste energy such as fly ash is a sustainable and low-energy substitute for OPC concrete, particularly in highly seismic-prone areas, for a cleaner environment.