Search

We examine the impact of water (160 ± 41 ppm of reference) on the anode, cathode, separator and electrolyte in two aging scenarios: calendric aging (60 °C, 80 days, charged state), resulting in a triggered current interrupt device (CID), and cycling 1680 times (charge/discharge with 1C, 2.75–4.2 V, 20 ± 2 °C), resulting in 24.5% residual capacity. We applied computer tomography (CT), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and secondary ion mass spectrometry (SIMS) to understand the capacity loss. The aged NMC/LCO–graphite cells were compared to a reference cell in pristine state. Both aging scenarios showed (a) thick depositions on the anode and cathode consisting mainly of oxygen, fluorine and phosphorous, (b) reduced separator pore sizes, (c) the deposition of Mn, Co and Ni on top of the anode and (d) the decomposition of the conductive salt LiPF6 accompanied by HF formation and a loss of active lithium. Calendric aging consumes the water content and additionally leads to (e) the decomposition of the organic solvent followed by CO2 gas formation. Cyclic aging increases the water content and additionally results in (f) the consumption of the additive fluoroethylene carbonate (FEC). These findings show how water affects aging phenomena and results in a capacity decrease in the cell. [ABSTRACT FROM AUTHOR]

The deployment of battery-powered electric vehicles in the market has created a naturally increasing need for the safe deactivation and recycling of batteries. Various deactivating methods for lithium-ion cells include electrical discharging or deactivation with liquids. Such methods are also useful for cases where the cell tabs are not accessible. In the literature analyses, different deactivation media are used, but none include the use of calcium chloride (CaCl2) salt. As compared to other media, the major advantage of this salt is that it can capture the highly reactive and hazardous molecules of Hydrofluoric acid. To analyse the actual performance of this salt in terms of practicability and safety, this experimental research aims to compare it against regular Tap Water and Demineralized Water. This will be accomplished by performing nail penetration tests on deactivated cells and comparing their residual energy against each other. Moreover, these three different media and respective cells are analysed after deactivation, i.e., based on conductivity measurements, cell mass, flame photometry, fluoride content, computer tomography and pH value. It was found that the cells deactivated in the CaCl2 solution did not show any signs of Fluoride ions, whereas cells deactivated in TW showed the emergence of Fluoride ions in the 10th week of the insertion. However, with the addition of CaCl2 in TW, the deactivation process > 48 h for TW declines to 0.5–2 h, which could be an optimal solution for real-world situations where deactivating cells at a high pace is essential. [ABSTRACT FROM AUTHOR]