Search

An electronic dimming ballast with a lead-lag tank operation (LLTO) having the properties of high efficiency and low stress is introduced in this paper. The ballast is configured with a voltage-fed half-bridge series-resonant parallel-loaded inverter (SRPLI) acting as a !amp driver. It is loaded with resonant tanks which are designed and operated to be capacitive and inductive to theoretically achieve both zero-voltage switching (ZVS) and zero-current switching (ZCS) and to eliminate the reactive current circulating through the switches, resulting in low switching and conduction losses. Moreover, the merit of a successive lamp ignition can be attained with the proposed operation scheme so that current stress imposed on the switches can be reduced. With the plasma model of fluorescent lamps, the analysis, operating principle, and dimming control strategy of the electronic ballast are described in detail. On the other hand, the limitations of the proposed scheme are pointed out. Computer simulation results and experimental measurements are used to verify the theoretical prediction and analytical discussion. Index Terms - Dimming ballast, lead-lag tank operation.

Analysis, design, practical consideration, and implementation of a microprocessor-based toggle-control lighting system are presented. The system is primarily configured with a power factor corrector (PFC), a square-wave voltage generator, a manually controlled toggle switch, and two relays. Toggling the toggle switch can select a different number of lamps in operation, resulting in a mutual dimming feature. A lighting system with this specific ballast gains the merits of lower system cost and more flexibilities in lighting fixture design, as compared to conventional systems. Index Terms - Ballast, fluorescent lamp.

This paper presents improved start-up scenario for single-stage electronic ballast derived with synchronous switch technique (SST). Based on the SST, the derivation of a single-stage inverter (SSI) used for realizing the ballast is then addressed. The SSI can achieve both high power factor and ballasting function. During lamp start-up transition, power imbalance may exist between the power factor correction semi-stage and the ballast semi-stage, and filament preheating is an important issue. Power imbalance usually results in a high dc-link voltage which, in turn, imposes high stress on the switching devices. Investigation of the ballast operation is conducted, from which control strategies for reducing component stresses and hot resistance detection circuits for minimizing electrode sputtering are therefore proposed. Hardware measurements have verified that on-off tests are higher than 18 000 times without significant sputtering. Index Terms--Single-stage electronic ballast.

Single-stage converters (SSCs) are proposed for applications of photovoltaic powered lighting system (PPLS). The synchronous switch technique [6] is employed to develop the SSCs which can fulfill maximum power point tracking (MPPT), battery charging, discharging, and lamp ballasting features. Several typical SSCs are discussed. One of the proposed SSCs, which is the integration of a buck-boost charger/discharger and a class-D series resonant parallel loaded inverter, is analyzed and designed into a PPLS. Both pulsewidth modulation (PWM) and variable-frequency controls are used to govern the system operation. The controller is implemented on a single-chip microprocessor. Simulated and experimental results of the proposed system for driving up to sixteen GE TBX 26W fluorescent lamps are used to verify the theoretical prediction and feasibility. The proposed system has a simple configuration, as well as a zero voltage switching (ZVS) feature, and can achieve the same functions as those in conventional systems when abrupt insolation changes do not occur frequently. These result in the inherent merits of lower cost, more compact size and possibly achieving higher reliability over conventional systems.