Search

The potential energy recovery of hydraulic excavators is very significant for improving energy efficiency and reducing pollutant emissions. However, the more common solutions for potential energy recovery require more energy conversion processes before these potential energies can be reused, which adds to the complexity and high cost of the system. To tackle the above challenges, we proposed a novel energy recovery system for hydraulic hybrid excavators based on the digital pump with an energy recovery function. The new system could operate in three different modes: pump, energy recovery, and direct reuse. Based on the descriptions of the working principle of the digital pump and the whole energy recovery system, the mathematical models of the digital pump, the excavator arm cylinder, and the accumulator were established and the AMESim simulation model (combining mechanics, hydraulics, and electrics) was developed. The dynamic characteristics of the energy recovery system were studied under no-load and full-load conditions. The simulation results showed that this scheme could achieve 86% energy recovery when the boom was lowered and reused the recovered energy directly when raised, which could decrease the system input energy by 78.1%. This paper can provide an optimized solution for construction machinery or off-road vehicles and presents a reference for the research on digital hydraulics. [ABSTRACT FROM AUTHOR]

An innovative wind turbine with a particular hydraulic transmission and energy storage system is proposed in this paper. The purpose of applying the hydraulic transmission is to remove the gearbox and power converter of traditional wind turbine and cooperate on wind resource storing with the energy storage system. To overcome the volatility and intermittence shortcomings of wind and improve the output power quality, hydraulic accumulators are used as the energy storage device for wind energy regulation. The original gearbox and generator in the nacelle of a Micon 600 wind turbine were removed and replaced with a hydraulic pump to make a test rig for the investigation into maximum power point tracking (MPPT) of this hydraulic wind turbine concept. The mathematical model of the entire test system is established according to the four function modules. The MPPT control strategy based on the tip speed ratio (TSR) is adopted and a control system containing three closed-loop controls is designed to achieve maximum wind power extracting and produce constant frequency power generation. Ultimately, the dynamic response of rotor speed control is revealed under step change of wind speed and the maximum power tracking performance of the 600 kW hydraulic energy storage wind turbine test bench is simulated and analysed by subjecting to turbulent speed condition. The simulation results demonstrate that the rotor of the wind turbine can run at the expected optimal speed depending on wind speed, and the wind power utilization coefficient of the unit is stabilized at about the maximum value. [ABSTRACT FROM AUTHOR]