Search

As one of the basic supporting technologies of 5G system, wireless sensor networks technology is facing a new challenge to improve its transmission energy efficiency. This paper considers combining simultaneous wireless information and power transfer (SWIPT) technique and routing technique, and applying them to multi-hop clustered wireless sensor networks (MCWSN), where each node can decode information and harvest energy from a received radio-frequency signal. And the relay nodes in MCWSN can utilize the harvest energy to forward data to their next hop nodes according to the routing scheme. First, we formulate an energy-efficient routing problem of MCWSN with SWIPT. Then, a heuristic energy efficient cooperative SWIPT routing algorithm (EECSR) is presented to find a transmission path with the maximum energy efficiency. Specifically, in EECSR, the resource allocation problem in each hop of the path is transformed to some equivalent convex optimization problems, which are resolved via dual decomposition. Moreover, a distributed routing protocol based on EECSR is proposed. As far as we know, this is the first solution that considers energy efficiency optimization based on routing and SWIPT in MCWSN. Simulation results show that our EECSR algorithm has high energy efficiency and good robustness. And our distributed routing protocol has better real-time performance than traditional protocols. [ABSTRACT FROM AUTHOR]

As an important electromagnetic field in experiment, Gaussian beams have non-vanishing longitudinal electric and magnetic components that generate significant energy fluxes on transverse directions. We focus on the transverse energy flux and derive the theoretical propagation properties. Unlike the longitudinal energy flux, the transverse energy flux has many unique physical behaviors, such as the odd symmetry on propagation, slower decay rate on resonant condition. By means of the characteristics of transverse energy flux, it is feasible to find the suitable regions where the information of coherent lights could be extracted exactly. With the typical laser parameters, we simulate the energy fluxes on receiver surface and analyze the corresponding distribution for the coherent light beams. Especially for coherent lights, the transverse energy flux on the y–z plane with x = 0 and x–z plane with y = 0, contains pure coherent information. Meanwhile, in the transverse distance |y| < 2W0 (W0 is the waist radius) and |x| < W0/3 the coherent information could also be extracted appropriately. [ABSTRACT FROM AUTHOR]

Abstract: The calcined product of naturally occurring porous diatomite was previously assumed to be structure-destroyed or at least surface-reconstructed and therefore unsuitable for surface silylation. The present study indicates that the porosity of the mesoporous/macroporous diatomite remains intact after calcination at temperatures as high as 800°C, and the surface silylation of diatomite is achievable even for diatomite calcined at high temperatures. The interface interactions between the hydroxyl species of diatomite and γ-aminopropyltriethoxysilane (APTES) are significantly affected by heating pretreatment. Physically adsorbed water was largely preserved in diatomite at a low heating temperature, leading to the strong hydrolysis of APTES and the subsequent oligomerization between the hydrolyzed APTES species. Under heating at high temperature (800°C), the isolated silanols initially covered by water molecules were exposed and available for the direct grafting of APTES, forming a grafting-dominant structure with high thermal stability (540°C). The grafting-dominant diatomite had a much higher Cu(II) adsorption than the oligomerization-dominant type, because the coordination between the copper and nitrogen was stronger in the former case. These results demonstrate that heating pretreatment plays a key role in the surface silylation of diatomite, and that Cu(II) adsorption is highly dependent on the surface structure of the silylated diatomite. [Copyright &y& Elsevier]