1. Influence of river and crushing aggregates composition in self-compacting mortars
- Author
-
Geraldo Luís Becker Duarte, Bruno José da Silva, Ben-HurRaíra Martins, Juliana Machado Casali, and Andrea Murillo Betioli
- Subjects
autonivelante ,areia de britagem ,river sand ,areia de rio ,argamassa autoadensável ,General Physics and Astronomy ,self-leveling mortar ,General Materials Science ,self-compacting mortar ,General Chemistry ,crushed sand - Abstract
RESUMO O presente artigo teve como objetivo o estudo de argamassa autoadensável com composições de agregado miúdo (areia de rio e areia de britagem) com intuito de reduzir o consumo de areia natural de rio, uma vez que a mesma gera um impacto devido a sua extração. No estado fresco, as argamassas produzidas foram avaliadas quanto à densidade de massa, teor de ar incorporado, fluidez e análise de borda. No estado endurecido foram determinadas as resistências à tração e à compressão; o módulo de elasticidade dinâmico e a densidade de massa aparente. A partir dos resultados obtidos concluiu-se que a substituição de areia natural de rio por areia de britagem diminuiu a demanda de água nas argamassas autoadensáveis, resultando num aumento do consumo de cimento Portland por m3, em um menor volume de pasta para a mesma fluidez, isso devido ao maior módulo de finura da areia de britagem e melhor empacotamento em função da granulometria mais contínua. Com a diminuição da relação água/cimento houve um aumento dos valores de resistência à compressão e à tração e do módulo dinâmico, obtendo valores acima do mínimo exigido por norma. Como o consumo de cimento Portland por m3 também aumentou, evidencia-se a possibilidade de ajuste na composição reduzindo o seu consumo para uma dada resistência. Assim, com o aumento do teor de areia de britagem e de cimento Portland, as argamassas obtiveram um menor índice de intensidade de ligante, assim mais eficientes. ABSTRACT This article aimed to study self-compacting mortar with fine aggregate compositions (river sand and crushed sand) in order to reduce the consumption of natural river sand, since it generates an impact due to its extraction. In the fresh state, the mortars produced were evaluated for specific gravity, air entrained content, fluidity and appearance (surface finish). In the hardened state were also determined the tensile and compressive strengths; elasticity modulus and specific gravity. From the results obtained, it was concluded that the replacement of natural river sand by crushing sand reduced the water demand in self-compacting mortars (higher cement consumption), resulting in a lower volume of paste for the same fluidity, due to the greater fineness modulus of sand from crushing and better packing due to more continuous granulometry. The decrease in the water-cement ratio resulting in an increase in the compressive strength, tensile strength and the elasticity modulus, obtaining values above the minimum required by standard specification. However, as the consumption coefficient of Portland cement has also increased, the possibility of adjusting the composition is evident, reducing the consumption coefficient of Portland cement for a given strength. With the increase in the crushing sand and Portland cement content, the mixtures obtained a lower binder intensity index, more efficient. more...
- Published
- 2023