Search

Between 28 March and 1 April 2020, Stromboli volcano erupted, with overflows from the NE crater rim spreading along the barren Sciara del Fuoco slope and reaching the sea along the NW coast of the island. Poor weather conditions did not allow a detailed observation of the crater zone through the cameras monitoring network, but a clear view of the lower slope and the flows expanding in the area allowed us to characterize the flow features. This evidence was integrated with satellite, GBInSAR, and seismic data, thus enabling a reconstruction of the whole volcanic event, which involved several small collapses of the summit cone and the generation of pyroclastic density currents (PDCs) spreading along the slope and on the sea surface. Satellite monitoring allowed for the mapping of the lava flow field and the quantification of the erupted volume, and GBInSAR continuous measurements detected the crater widening and the deflation of the summit cone caused by the last overflow. The characterization of the seismicity made it possible to identify the signals that are associated with the propagation of PDCs along the volcano flank and, for the first time, to recognize the signal that is produced by the impact of the PDCs on the coast.

Hudson is one of the most active volcanoes in the Southern Andes-it had one of the largest eruptions of the 20th century in 1991 (VEI = 5) and smaller eruptions in 1971 (VEI = 3), maybe 1973, and 2011 (VEI of 1-2). We use satellite-based interferometric synthetic aperture radar (InSAR) and thermal imagery to characterize the activity of Hudson between 2004 and 2011 and during the 2011 eruption. InSAR data show that the volcano inflated between 2004 and 2010 with a maximum change rate of between 2 and 3 cm/yr-about half of the deformation rate observed during a previous deformation episode from 1993-1999. Inversion for an inflating point source suggests magma accumulation beneath the SW part of the caldera at an average depth of 10 km. This inferred source is deeper than both the sources estimated for the magma chamber of the 1991 eruption (from petrology) and for the 1993-1999 deformation event. Also, the deformation from 2004-2010 is centered at a slightly different location and has a smaller volume change than that between 1993-1999-further indicating that there is either a large magma reservoir or several separate ones. While the deformation center is a few km from the eruption location near the caldera rim, the two are possibly linked since the predicted static Coloumb stress changes due to the inferred inflation source would encourage unclamping on potential faults in the caldera rim. We also analize nighttime satellite thermal images from MODIS and ASTER. While MODIS did not show any unambiguous evidence for hot spots, ASTER thermal imagery show that at least four months before the eruption there were locations with temperatures 7-8ºK above background. Lahars observed by helicopter overflights on 4 March 2011 and October 2011 suggest that the hotspots may have been caused by lakes or subglacial melting. There is no InSAR data available for the months immediately preceding the eruption, but the ASTER thermal imagery results may indicate an increase in geothermal activity that could have been used to forecast the eruption. [ABSTRACT FROM AUTHOR]

Between 28 March and 1 April 2020, Stromboli volcano erupted, with overflows from the NE crater rim spreading along the barren Sciara del Fuoco slope and reaching the sea along the NW coast of the island. Poor weather conditions did not allow a detailed observation of the crater zone through the cameras monitoring network, but a clear view of the lower slope and the flows expanding in the area allowed us to characterize the flow features. This evidence was integrated with satellite, GBInSAR, and seismic data, thus enabling a reconstruction of the whole volcanic event, which involved several small collapses of the summit cone and the generation of pyroclastic density currents (PDCs) spreading along the slope and on the sea surface. Satellite monitoring allowed for the mapping of the lava flow field and the quantification of the erupted volume, and GBInSAR continuous measurements detected the crater widening and the deflation of the summit cone caused by the last overflow. The characterization of the seismicity made it possible to identify the signals that are associated with the propagation of PDCs along the volcano flank and, for the first time, to recognize the signal that is produced by the impact of the PDCs on the coast. [ABSTRACT FROM AUTHOR]