Si-bronze to 304 stainless steel GTA weld fusion zone microstructure and mechanical properties.

Si-bronze and 304 stainless steel were joined using gas tungsten arc (GTA) welding with two different welding (filler) rods matching the base metals. Cross-sections of the welds were analyzed using light optical microscopy (LOM), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and hardness testing. Mechanical testing was performed for welds from each of the two filler metals using cross-weld tensile bars. For (1) the Si-bronze filler weld, partial mixing resulted in (a) copper-based regions with enhanced hardness due to iron-based islands and (b) iron-based regions with elevated hardness due to Si enrichment. Joint strength was ~ 90% that of the base Si-bronze strength of 340 MPa, and elongation was ~ 48%, as compared to the base Si-bronze elongation of 55%. For (2) the stainless steel filler rod (a) primary austenite solidification and (b) micro-fissures were identified in the fusion zone. Thermodynamics calculation software was used to model solidification mode, demonstrating that the Cu (contributed by the Si-bronze) stabilized primary austenite solidification, which led to solidification micro-cracking or micro-fissuring. Micro-fissuring caused low ductility in the transverse weld tensile specimens. Fractography was performed to characterize the fracture mechanisms. For the stainless filler weld, a Cu film formed in interdendritic spaces between primary austenite grains. [ABSTRACT FROM AUTHOR]