Microstructure, mechanical properties and in vitro degradation behavior of novel Zn-Cu-Fe alloys.

Zn and Zn-based alloys as biodegradable material have drawn more and more attention in recent years due to their good mechanical properties, lower degradation rate than Mg and acceptable biocompatibility. However, too low degradation rate is a challenge for future application of Zn-based alloys. In this study, Zn-3Cu-xFe (x = 0, 0.5 and 1 wt%) alloys were proposed as candidate biodegradable materials. The microstructure, mechanical and in vitro biodegradable properties were investigated systematically. The Zn-3Cu alloy was composed of Zn matrix and CuZn 5 phase, while the FeZn 13 phase was newly formed with the addition of Fe. Due to the micro-galvanic effect produced by FeZn 13 as a cathodic phase to the Zn matrix, in vitro degradation rate in simulated body fluid solution (SBF) was greatly increased by about 52.1%, from 45.3 ± 8.22 for Zn-3Cu alloy to 68.9 ± 7.34 μm/year for Zn-3Cu-1Fe alloy. Although the mechanical properties were decreased slightly due to the introduction of hard and brittle FeZn 13 secondary phase to the Zn matrix, Zn-3Cu-0.5Fe alloy still exhibits good combined mechanical properties and the YS, UTS and elongation are 232 MPa, 284 MPa and 33%, respectively. Taken together, the mechanical properties and in vitro degradation behavior of the Zn-3Cu-xFe alloys are more suitable than Zn-3Cu alloy as candidate biodegradable materials. [ABSTRACT FROM AUTHOR]